1
vote
4answers
131 views

Driving screws back into weathered deck

I have a 20+ year old deck behind my home. It's in great shape, but I want to refinish it this summer. Problem is, a number of the Phillips screws have popped up over the years. I have a basic Hitachi ...
0
votes
0answers
47 views

deck repair and painting

the previous owner painted our 1000sf deck but failed to maintain same. Currently the painted deck is peeling and several small areas have dry rot of the wood decking. what is the best way to repair ...
1
vote
2answers
671 views

What header joist sizes do I need for a loft bed?

I've decided to design and build a king-sized loft bed for our bedroom. Basically, I've got an 80" x 89" frame, 54" off the floor, covered with slats instead of plywood (see image, below). I'm sure ...
1
vote
0answers
206 views

Sanding vs power washing vs chemical cleaning wooden deck for restoration

There seems to be various methods for cleaning and preparing a wooden deck for restoration. Some how-to's that I have read strongly advise against power washing. Some sources suggest a combination ...
4
votes
3answers
311 views

Why do decks and porches have cracks between the boards?

Is there a functional reason, like helping with rainfall or snow, or is it more of a cost issue? Are there decks that are solid pieces of bonded wood?
1
vote
2answers
4k views

What is the best way to seal my deck?

I Have an outside deck, it currently has a layer of varnish on it, I Think the wood type is Meranti. The deck is exposed to lots of rain and also harsh sun, and the varnish has started to peel. I ...
5
votes
2answers
7k views

How do I vertically connect two 4x4s on a deck to build a roof?

I have a deck I am going to put a roof over. It has 4x4s for vertical supports that I need to extend upward to attach my trusses to. What is the best way to connect two vertical 4x4s?
4
votes
3answers
669 views

Easiest way to cut, shave, or chisel bottom 8" of posts to fit footings

I got some 6x6's and deck post brackets that are similar to the picture below, except they're 8" high: Come to find out, the 6x6 is slightly too large to fit inside this bracket. Now I see how ...
1
vote
2answers
186 views

Would it be safe to leave charred wood on a deck until repairs can be made?

Had a small fire incident outside on our wood deck. There didn't appear to be any structural damage to any of the supporting material, just a few surface boards which need to be replaced. Can the ...
6
votes
1answer
671 views

Is it OK to build a deck with OSB?

I have left over 2x4s and OSB from a project a few months back (lean-to shed). It is just enough to make a 12'x8' deck, and I was wondering if this would be "OK" to use for decking? The main purpose ...
0
votes
1answer
211 views

Preparing a deck & playset for re-staining

The question asked here is pretty much similar to mine except that there are few splinters and chipped wood on the deck. How to smooth those out? Also there is a kid's play structure (with steps and a ...
12
votes
1answer
7k views

Which is better for deck flooring: 2x6 or 1x6 deck boards?

My current deck flooring is done with 2x6x10' boards, however they have degraded to the point now where they need to be replaced. I'm wondering if there are any specific pros or cons for using the ...
3
votes
2answers
7k views

How do I treat / maintain IKEA Platta wood patio tiles?

Over a year ago we put a good sized set of IKEA Platta deck tiles on our patio. After exposure to the elements, they are now dis-coloring and becoming a bit 'rough'. What exactly do I need to do to ...