The installation of wire and/or electrical devices, to allow the transmission of electricity from one point to another.

learn more… | top users | synonyms

21
votes
6answers
25k views

How do I wire an old house with Cat6?

I have a older home (build in the 50's) with 1/2" dry wall and then plaster on top. I would like to run Cat6 cable through most of the house (living room, kitchen, entertainment room,etc). So, I'm ...
19
votes
4answers
2k views

How can I get a wire that is outside a wall to be inside a wall

I recently removed an abominable drop ceiling from my dining room and found this close to the ceiling on the one side of the room. There is definitely a stud between these two holes. On the other ...
15
votes
3answers
7k views

Is running ethernet cable through an air return allowed under US code?

I'm looking to wire up the second floor of my house and the cold air return provides a convenient, straight run from the office to the utility room. Is it safe and within code to run ethernet cable in ...
14
votes
4answers
5k views

What should I use to secure/organize data cable runs?

I am running Cat-6 and Coax in new construction. I am looking for advice/best practices on how to organize and secure the cables during the runs. I will be running 2 Cat-6 and 1 Coax to a ...
14
votes
4answers
64k views

How do you know when and where it is safe to drill into a wall?

Lots of home projects involve cutting or drilling through walls (everything from nails, screws, or hooks to mount things to cutting through drywall and drilling through studs to run wire). In ...
13
votes
6answers
5k views

What is the right way to strip power wires?

I've been working with electrical circuits as a DIYer for years, including electronics and powerline work. But one thing I always feel like I do a terrible job at is stripping wires: both the outside ...
13
votes
3answers
56k views

What is a GFI outlet used for, and where should I install them?

What purpose does a GFI serve? Where should they be used?
13
votes
3answers
10k views

How do I run ethernet, speaker wire, and coax through a wall into a crawlspace?

I would like to run three low-voltage cables from my entertainment center through an old plaster wall, down (1-3 feet) through the sill plate, and into the crawlspace. The cables are Ethernet, ...
13
votes
6answers
13k views

How should I go about installing a 12 volt DC residential circuit?

I have a couple deep cycle batteries that trickle charge from a solar panel, for emergency use. Right now the only way I get useful power from them is to use a 12VDC -> 120VAC inverter, e.g. the type ...
12
votes
4answers
1k views

What is this 110/24V 60Hz transformer in the breaker room for?

My friend sent me a photograph of this transformer, which is installed above the main breaker panel, with leads running from the panel into the transformer. The stamped labels read PRI. Volts: 110 ...
11
votes
5answers
2k views

What are some pros, cons and recommendations for multicables?

Currently saving to build a new home and I'm going over wiring options in my mind. My current home has too few sockets, cable connections and LAN ports (yes I still like wired LAN, wireless is good ...
11
votes
3answers
5k views

Ethernet cable instead of Thermostat wire?

I need to pull new wire from my furnace to my thermostat and was wondering if there would be any problems in using an Ethernet cable instead of standard thermostat wiring. The reason being is I have ...
11
votes
3answers
1k views

What size extension cord should I use for multiple computers?

We're hosting a LAN party (several computers, 50+) and I had some questions about power draw; I hope this is the right place to ask. Currently, we're assuming each PC will draw an average of 3.5 ...
11
votes
2answers
10k views

Why is my Nest thermostat not working with A/C?

I installed Nest thermostat a few weeks ago, replacing an old Lux programmable thermostat (there was nothing wrong with it). I connected 4 wires (R,W,Y and G) to the Nest. But as soon as I'd ...
10
votes
5answers
52k views

How should I run wiring for my above-fireplace mounted TV?

I'm going to mount my 47" LCD above my fireplace. I'm not looking for arguments against this decision. I'm looking for wiring solutions. The diagram below should help explain the situation. ...
9
votes
3answers
1k views

Does voltage play any role in choosing the appropriate wire gauge?

Online, most household wiring guides suggest 14 gauge wire for 15 amp circuits, 12 for 20 amps, and 10 for 30 amps. Do these assume the voltage is 120, or does voltage not come into play when choosing ...
9
votes
2answers
3k views

Is this fluorescent light fixture a major electrical problem / fire hazard?

(I am a new homeowner.) I went to replace a some fluorescent tubes that looked like they burned out, but after disassembling it a little to get the tubes out, I saw something a little alarming: ...
9
votes
5answers
5k views

Why would there be a 50 amp plug on a 30 amp appliance?

I have an old conveyor dryer, which my office purchased used some time ago, just sitting in storage. The dryer is for silk screen t-shirts and has a large heating element and a variable speed conveyor ...
9
votes
3answers
430 views

How should I rewire this situation?

In my dinning room, I have this: There is a wire run going up through the floor from the basement. It then goes outside the wall, around a stud (or studs, I'm can't tell there is more than one), back ...
9
votes
1answer
949 views

What type of connector is this and how do I remove it?

I was trying to install a ceiling fan in my apartment and came across these connectors when removing the light. What is this and how do I take it off?
8
votes
2answers
338 views

Is it within code to complete 12g wiring circuit with 10g wire?

In installing a dishwasher on a dedicated 20amp circuit on 12g wiring, I've come short about 5 feet to run a line. I have some surplus, heavier, 10g wire. Would it be safe to install a junction box ...
8
votes
3answers
95 views

Why is a neutral wire needed for most 'smart' light switches?

Why do most smart light switches need a neutral wire?
8
votes
1answer
9k views

Can Romex (NM-B) be run through conduit?

A few days ago I asked an electrician if I could run Romex through conduit - he gave me a funny look and said "No, Romex is not allowed in conduit." When I searched online, there seems to be a wide ...
8
votes
3answers
4k views

Can I use two wire nuts instead of one to connect 6 wires inside a 3-gang box?

Is it considered acceptable practice to use two wirenuts in a situation where it is possible to use only one but may be easier to use two? I have a three-gang box with six cables coming into it. The ...
8
votes
1answer
1k views

How do I wire this motor with 240V?

I have 240 plug with a switch dedicated for Air compressor. I have compressor that supposedly can be wired for 240V 2 pictures show sticker and current wiring. How do I update wiring to make it 240V? ...
8
votes
2answers
2k views

How do I run a wire underground to an outdoor post lamp?

I live in Geauga county Ohio. My question is three part. First what type of wire do I need to run from the house underground to a post lamp 100 feet away? Second,does it need to be in conduit and ...
8
votes
1answer
36k views

How can I override a motion detector light?

I am going to be installing one or two motion detector lights to cover my backyard. I would like the ability to "override" the motion detector. What I mean by this is that I would like to be able to ...
8
votes
3answers
580 views

What is a minimally intrusive way to move a wire that is in a wall 3.5" to the left?

I need to move a speaker that's mounted on a wall about 3.5" to the left. Here's what the actual mounted speaker looks like: The wire comes out inside the bracket that attaches to the wall, and ...
8
votes
2answers
2k views

What are my options for installing 240v receptacles in an attached garage?

My workshop (attached garage) is currently wired with 120V receptacles fed from the main panel in the house by #10/3 with ground (1 black, 1 red, 1 white, 1 ground) attached to a double-pole 30A ...
8
votes
5answers
3k views

Why is there so much metal-clad wiring in my house?

My house was built in 1893. I was recently doing some electrical work in the attic, adding some light fixtures. While doing that, I noticed that several of the upstairs outlets were wired with old, ...
8
votes
1answer
962 views

Can I use Romex in an unfinished basement or attic?

I am asking in reference to articles 382.2 & 382.12 in the 2008 edition of NFPA-70. The following definition appears to me to be describing Romex (NM-type) cabling: **382.2 Definitions** ...
8
votes
5answers
5k views

Is “don't mix data and power cables” and “don't loop power cables” still valid nowadays?

There are two sayings I keep hearing when talking about wiring e.g. home cinema or computer hardware; Don't wrap data/network cables and power cables up in the same loop because the power cables ...
8
votes
3answers
2k views

What happens if I shave a little sliver off electrical wire with a utility knife?

I needed to replace an electrical wire with a longer one so I could move an electrical outlet. When I went to cut away the outer rubber cover of one of the wires with a utility knife (yes, dumb, I ...
8
votes
1answer
404 views

How should I install a signal cable duct from new home office to a wiring closet?

I'm constructing a new home office and rather than having fixed cables from the (existing) wiring closet, I want to have the flexibility to add/remove/change cables in future, so I've been looking at ...
8
votes
2answers
1k views

Is there a standard wiring scheme for AC/heater thermostats?

I have a project idea where I would really like to be able to make my own thermostat to control my home's AC and heater. I have just two questions Is there any standard wiring/color code? Are any ...
7
votes
12answers
23k views

When wiring outlets should I use pigtails or both sets of outlet screws?

I'm replacing the outlets in our house and pulled out one that had two black and two white cables. My first thought was that it was two circuits, one of them being switched, but then realized the tab ...
7
votes
2answers
6k views

What gauge speaker wire do I need?

I am looking to run some speaker cable through my unfinished basement. I will need 35 ft long cables for a couple of Technics SB-A10 speakers. What gauge of cable will I need? How is the gauge ...
7
votes
5answers
11k views

How can I get a shock from a circuit when the breaker is off?

While I was replacing an old outlet, I received a shock from something in the box. I think it was the metal box itself. Before I started, I performed the following to ensure the power was out: ...
7
votes
5answers
4k views

Is it safe to run a USB cable inside a wall?

I need to extend a USB device from a corner of my room to the above the fireplace. Since I'm already going to be installing some HDMI and audio cables through the wall, I'd like to have my USB device ...
7
votes
2answers
743 views

Is a negative reading from a non-contact voltage detector sufficient?

I'm a beginner at doing electrical work, and I want to make sure I'm not taking unnecessary risks. Let's say that I'm preparing to work on some wiring. I have a non-contact voltage detector that ...
7
votes
2answers
606 views

Will security system wiring cause interference in data cables?

Is it acceptable to run 22/4 security wire along side Cat6 and Coax cables, or is there any possibility for interference?
7
votes
3answers
2k views

How should I go about fixing a faulty 240 V Electrical Outlet

This afternoon, my wife and I noticed a peculiar smell coming from the garage. We localized it to a faulty 3-wire 240 V outlet. Something got really hot resulting in part of the rubber melting on ...
7
votes
2answers
51k views

What wire gauge do I need for a 100 Amp subpanel at the end of a 60' wire run?

I am adding an attached garage to my house. I'm going to be putting in a 100 Amp subpanel which is about 60 feet away and run through the basement joists. What gauge wire do you recommend for ...
7
votes
1answer
3k views

How can I remove a switch and terminate a circuit in its place?

I have a switch that used to control outdoor lighting. It no longer does any more and I'd like to just leave it off permanently. Is there an easy way I can terminate it from within the gang box? ...
7
votes
1answer
326 views

What are these clips on the wires in my junction box?

Are these clips just for protection? or are they connectors for something?
7
votes
1answer
56k views

What wire gauge should I use with a 30 amp breaker for a 220V welder?

I am installing an outlet in my garage for a 220v mig welder. The welder specs call for 30A breaker. The outlet for the welder is only 2 feet from the garage sub panel. The wiring refernece charts ...
7
votes
3answers
3k views

What to do with an apartment with only 2-pronged outlets

I just rented an apartment (Colorado, for what it's worth RE code) that has 2-pronged outlets throughout the place except for two GFCI's, one in the bathroom and one in the kitchen. I bought the ...
7
votes
1answer
1k views

Any reason not to ground the sheathing of MX wire?

Having recently bought an older house (c1943) I am doing a little work on the place. While rewiring a light switch I noted that there is newer Romex wiring from the distribution panel to the switch, ...
7
votes
2answers
400 views

Do I need junction boxes where conduit containing data cables terminates?

I'm going to be running 1" blue PVC conduit from all my low voltage boxes to a structured wiring panel. My wiring panel will chase to the attic where necessary and I was wondering what the best ...
6
votes
2answers
771 views

How do I run a 3 Phase/1hp TEFC motor off of a regular household outlet?

I recently bought a brand new TECO-Westinghouse Electric motor . 3 phase HP: 1 Volts : 208-230/460 RPM: 1750 HZ: 60 Fr: 56 Cat no: ZA.0014TE2/56 Type : AEFAZA Enclosure : TEFC I would like to run ...