Tagged Questions

1
vote
1answer
84 views

Can I upgrade my garage to 20amp service without a headache?

I have an unfinished garage which I am looking to upgrade the service to. Currently it is 15amps running through some difficult to access sub-ground conduit, but if I run the band saw plus the ...
0
votes
1answer
2k views

Network Garage Door opener/ how does the switch work

I'm trying to connect a relay/switch to a Garage door(Lift Master). I know that there are two wires to trigger the garage door. I'm not sure how it works exactly. I'm trying to control the garage ...
6
votes
1answer
1k views

How can I replace a light fixture?

I need someone to sort out this wiring question for me. I'm trying to hang a flourenscent light in the garage, however, when I took the old garage light out (one of those round, single light ...
4
votes
1answer
2k views

What are the requirements for wiring an unfinished garage with lights and outlets?

I found this DIY article online which suggests that running Romex along the center faces of studs and rafters was code compliant for unfinished garages. How to Wire a Garage The article is dated ...
4
votes
3answers
538 views

What voltage/amperage garage circuits should I install for welding tools and an air compressor?

As a part of renovating my garage this fall, much of the wiring is being re-done. Since doing the work before putting up walls will be much easier now than adding circuits in the future, I'd like to ...