I am fresh out of cable staples and would rather not go all the way to Lowe's just to get a box. What are the implications of not fastening loose electrical wires to a stud? It's not like there's ...
I just moved into an old home that has a three pronged wall jack as shown below: I have a newer dryer that has a four pronged wire. Please see the back of the dryer, I've removed the four pronged ...
I would like to run wires in anticipation of a future hard-wired security system. However, I have yet to find any information that pulls everything together regarding what is required. From what I ...
I am working with an electrical socket and I need extra length on the ground wire. It doesn't seem unreasonable that I can attach an extra three inches to the existing one and attach it with a copper ...
Is it possible to do two 3way switched circuits that share a common power source but the power source and the light wire are in the same box?
I'm trying to connect two separate circuits from a single power source using 3way switches. My trouble seems that my wire from my light and my power source are in the same box. Is there a way to do ...
This seems like a simple question, but I cannot seem to find the answer in the 2008 NEC. There are references to "maintaining spacing" in many sections of the code such as the following: ...
The wire on my lamp is too short, so I'm trying to replace it. The fitting/fixture (what's the correct term?) however doesn't play nice: I can't see the correct way to remove the old wire (and still ...