0
votes
1answer
40 views

Well (Water) Troubleshooting

I have a 20g Pressure Holding tank. When I turn on the outside faucet, I notice low pressure after a while. When I go to the control unit connected to the pressure tank, I see the pressure drop from ...
1
vote
0answers
51 views

Can I run 2 well tanks from 1 well

I have a detached garage that is in between the well and the house. As it stands, the tank in the house is not sufficient for watering the lawn, and so I would like to get a bigger one anyhow. Since ...
0
votes
0answers
33 views

Why would 2 different sprinkler zones cause pressure at the pump to drop to 0?

Why would 2 out of 3 sprinkler zones cause the pressure reading at the pump to drop to 0? This is a well irrigation system and it is separate from the home's well. The pump is a 3/4 HP, has a flow ...
1
vote
1answer
43 views

How can I get this pump casing off the motor?

I have a Monarch MJC-50 shallow well jet pump (1/2 hp) and I want to tear the pump portion down to clean, inspect, and rebuild as it isn't delivering the pressure it used to (and I have ruled out all ...
1
vote
1answer
200 views

Water pressure low after hose was left on overnight

The water pressure inside my house went way down and stayed down after the hose was left on overnight. It's been a while now and the water pressure is still low (useable but low). The air pressure ...
3
votes
1answer
441 views

What would cause a well pump to suddenly be louder when operating?

We currently have an unknown (in terms of GPM) 3/4HP Franklin well pump, at an unknown depth (though our neighbor's well is at roughly 100'). Since we moved in, when the well pump is running, there ...
3
votes
1answer
2k views

How can I find a leak in underground plumbing?

We moved into a home a couple years ago that was 1600 sq ft from a 3700 sq ft home. We were shocked that the power bill here was about 30% more than the big house but I suspected a water leak ...
0
votes
0answers
59 views

What damage may a bad condensor on a well-pump do?

Yet another follow-up to How does one determine whether a waterlogged High HP pump is electrically OK to use? The pump is out now. The screws on the housing being jammed/rusted tight, I've applied ...
0
votes
1answer
41 views

What are the different ways to dry the winding of a water-logged pump?

A follow-up to How does one determine whether a waterlogged High HP pump is electrically OK to use? Several sites on the internet indicate it may be possible to dry the windings on a waterlogged ...
1
vote
1answer
61 views

How does one determine whether a waterlogged High HP pump is electrically OK to use?

A high power pump (the mechanic said it is a 0.75HP induction motor) is mounted on the old well using those huge bolts driven through the stone. During the recent rains the grounds were water-logged, ...
4
votes
1answer
6k views

How does one know if a well pump is “Short Cycling” or pressure tank is water logged?

Is there any calculation that can be performed to estimate the amount of water a well water pressure tank should output between pump cycles? E.g.- I have a 40 gallon pressure tank (non bladder) with ...