0
votes
2answers
108 views

Why do I have almost no water pressure after installing a new valve?

We had a leaky shut off valve under our master bathroom sink. The valve appeared to be original to the house. That would put it in the 40 year old range. I replaced the valve with a new “Shark ...
1
vote
0answers
52 views

How can I stick bathroom tiles back down?

Some water got under the tiles and now they move around as you stand on them. How can I fix this, is there a way to stick them back down?
1
vote
1answer
461 views

How do I replace the water supply line that appears to be built in to the shutoff valve?

We're preparing to replace our bathroom faucet. We were able to easily disconnect the cold water supply line from the shutoff valve to the faucet by simply loosening the nuts holding it in place. ...
4
votes
2answers
591 views

Water from bathroom faucet smells like rotten eggs

The sink is in the powder room on the main floor of our house. When I turn the water on it is fine for a few seconds then it smells horribly for about 3-4 more seconds then it is back to normal. It is ...
4
votes
1answer
119 views

What areas of 1st floor sheetrock sould be replaced subsequnet to a major 2nd floor water leak?

In our apartment, the ceiling began leaking in 2 places. One of the places, the water was brownish and had multiple droplets, the other the water was clear. We called maintenance at 8 am and no one ...
0
votes
1answer
132 views

Are PEX required for shower mixers?

From my understanding it is normal to mount a PEX like this one in the wall. And that it is not legal to have hidden connections in the wall. Question Why are PEX so often used (required)? Is it ...
6
votes
4answers
2k views

Should I install an inline water heater for my bathroom?

It takes 3-4 minutes of the shower running before the hot water reaches my upstairs bathroom. I'd like to not have to waste all that water and time. My initial though was to install an inline water ...
0
votes
1answer
80 views

how can i fix my bath tub

When I turn the water on to take a bath the water don't run it just drips and takes hours to fill the tub or I have to add pots of water is there a way for this to be fixed or do I have to call a ...
2
votes
1answer
420 views

How to determine if a faucet is plastic or metal?

On the first picture below I am pretty sure the grip is made of plastic because it feels very light, when I lift it. On the second I have no idea. Question How do I tell if the grip of a faucet is ...
5
votes
3answers
9k views

How can I repair a flexible hot water supply hose that is leaking at the nut?

The hot water supply hose under my sink started leaking after I replaced the popup drain on the sink. Apparently I disturbed the hose in some way. It is leaking from just above the nut where it ...
0
votes
1answer
294 views

Can I get a smaller toilet installed? (picture included)

At the bottom is a picture of my toilet, where you can see the toilet pipe that enters the floor and that there is ~7 cm of space between the water container and the wall. Question Does there exist ...
5
votes
2answers
7k views

How do I repair drywall around a bathtub?

I have an area of drywall that is next to my bath tub that has gotten soft and crumbly. Mostly held together by paint & caulk now. I'm reasonably sure I understand why. We're getting some water ...
2
votes
1answer
564 views

Could water temperature fluctuations be caused by new plumbing?

I'm having a new bathroom installed. I hired a plumber to do all the water works. He ran all the lines; he is now waiting on sink and toilet to arrive to finish installation. Since he ran new line, we ...
2
votes
2answers
262 views

Why do my toilet valves seem to have started running at the same time?

I had a bad toilet that started running last year. This was in a bathroom that is not used at all (guest bedroom). So, i just closed the valve to that toilet and decided to look into it later. I ...
3
votes
2answers
2k views

How can I make a mixer shower more powerful?

The Mira mixer shower has variable temperate settings from 1 (cold) through 10 (hot), plus the extra bit for hot water only. I normally shower at 3 and was thinking there must be a way to let more ...
2
votes
1answer
3k views

My hot water stopped working in one bathroom, what can I try in order to fix it?

I have an electric water heater from 2004. The hot water works in all other areas of my house (kitchen, other bathroom and washing machine). The sinks and shower in my master bathroom are not ...
2
votes
1answer
596 views

How to turn on a ballofix / ball valve?

When I turned the valve off, it was as if it made a small click, as if it had reached a locking position. Now I can't turn it on again. I have one other just like this one, and that one can I turn ...
1
vote
2answers
259 views

Is “bronze and silumin” mix actually possible in a ball cock?

In my apartment bathroom there's a thick steel pipe with hot water going from the floor beneath through my bathroom and to the store above. There're two pipes welded into that vertical pipe and a ...
3
votes
1answer
1k views

Why is my third floor hot water pressure so low?

The hot water pressure in our 3rd floor shower is very low. The 2nd floor shower however, has very good pressure. The problem is not the shower head, which actually produces great pressure when ...