Vertical structures which usually enclose, divide, define, or protect an area.

learn more… | top users | synonyms (1)

3
votes
2answers
430 views

How do I install a Rubbermaid closet organizer in a paneled mobile home?

I have a Rubbermaid Configurations closet organizer and have no confidence in the enclosed hardware. I have a mobile home and the walls are all paneled - the studs very difficult to find as well as ...
3
votes
2answers
341 views

Why is there dirt in my wall (by the tub)?

We were trying to put in some laminate flooring, and as I was vacuuming against the base of the drywall I noticed that dirt kept falling from what looked like inside the wall. The drywall seemed a ...
1
vote
1answer
41 views

Overlap When Painting Stripes: Can I Sand?

I'm painting a three-stripe pattern across the length of my wall, and I had a question about whether I could sand down the overlapping areas. The stripe consists of a 21" green stripe with two 3" ...
0
votes
1answer
41 views

Is Behr primer compatible with Sherwin Williams paint?

Can I prime walls using Behr primer then paint over the primer using Sherwin Williams paint?
0
votes
0answers
34 views

Building a deck - can I extend the side wall vent of my propane furnace underneath it?

I'm building a low deck outside of my house, and the vent wouldn't have a 1ft clearance. Deck extends about 7ft out from the house. Would it cause any problems if I were to extend the vent's 2inch ...
2
votes
2answers
33 views

TV wall mount problem. (Studs too far apart)

I bought a full motion wall mount to fix 49" tv to wall. Instructions for mount specify must be fixed to studs. Studs are too far apart where I want it to go. Is there a safe way to fix or should I ...
0
votes
2answers
46 views

How do I remove glow in the dark paint from my walls?

A friend of mine painted on the walls of the apartment we are staying in with glow in the dark pain, and we have to get them off of the walls because we will get fined for it. We did not realize this ...
1
vote
1answer
60 views

Can I remove this wall?

This is the plan of the house I'm living in, and I'm thinking of making some changes. The measurements are in cm. The construction brick, circa 1980. It has only ground and first floor. Before I'll ...
1
vote
1answer
26 views

What length header should I consider?

I have 2 bathroom remodeling we are planning on the 2nd floor of 2 storied house. I want to carve out part of the bathroom as laundry room where Washer (27") and Dryer (27") will be stacked in a ...
2
votes
4answers
4k views

How to secure an ikea Kallax shelf unit

I’d appreciate some advice on the tools I need to complete a task. I bought an Ikea Kallax shelving unit (http://www.ikea.com/gb/en/catalog/products/30275861/) It came with two brackets, with a space ...
1
vote
2answers
37 views

How was the wood grain aligned in this set of decorative wall panels?

Can anyone tell me how the wood finish look on this wall was achieved? My guess was either by staining plywood or using vinyl sticker. I am planning to build a wall panel similar to this and was ...
0
votes
1answer
33 views

Easy way to find out if this wall is load bearing? (double top plate, but parallel with trusses) with pictures

It's a single story house (but this is an addition done in the 80's I think). I know a double top plate usually means it's load bearing, but parallel with trusses means it's usually not load bearing. ...
0
votes
2answers
290 views

Mount metal letters to a wall so that they are removable

I have to mount some metal letters to a concrete wall. Until now the plan was to ad pins to the letters and glue them into the wall. This would have required making some holes in the wall. Now the ...
0
votes
0answers
22 views

How do i determine load bearing post concrete condo lower level with concrete ceiling

We have these 2 sheetrock metal 2x4 framed square posts in the middle between living room and dining room that the wife would like removed. They have 3 arches. I dont beleive they are load bearing ...
1
vote
2answers
58 views

How to repair flaked plaster surface

I recently moved and noticed this crack on the wall. When I tapped it lightly with a blunt knife it broke off. I've never plastered before but I assume I will need to re-plaster this section. Any ...
0
votes
0answers
24 views

Drilling through the exterior wall of a row house - hitting metal?

Working on a 1920s brick two family row house in Brooklyn. Looking to run a cat5 cable through an exterior wall (and back in again at another part of the house, to avoid running the wire through ...
0
votes
2answers
37 views

Do vertical cracks in old plaster wall along studs indicate a structural problem

My house was built in 1908 and still has its original plaster walls. One of the upstairs bedroom's wall has vertical cracks from floor to ceiling along the studs-3 studs in a row in the center of the ...
0
votes
0answers
17 views

Painting on plastic panels

So bit of a quandary. I'm about to move into a flat which has what looks like plastic (I think, didn't personally go to the viewing but thats what I've been told) wall panels on all of the exterior ...
1
vote
1answer
91 views

Basement foundation wall repair

After we poured some concrete outside of our east wall, we noticed some cracks along the foundation wall. I guess due to the weight of the new foundation, the foundation wall crumbled. One of the ...
0
votes
1answer
14 views

Putty knife : when to use flexible blade and when to use stiff blade?

I'm prepping my walls for painting. There are various sizes of putty knives and they come in flexible and stiff versions. I know that I need to get a few sizes for different kind of work: 4", 6" and ...
0
votes
1answer
20 views

How to tighten an optical fiber to the wall?

I would like to lengthen my optical fiber so I can put my Internet box on a proper shelf. That's quite easy, I'll just have to buy a longer fiber. The problem is that I don't want it to hang ...
2
votes
3answers
522 views

Best way to make a hole in concrete wall

So my house has concrete walls and ceilings. There a few places i would need to remove some large holes like for vents or light fixtures. I was looking at a concrete hole saw which seems to be a good ...
0
votes
0answers
29 views

Cost effective fasteners in crumbly wall

My apartment has very shoddy walls. It's basically a truss construction (though I never encountered a truss in a wall, but a neighbor did), the space between the trusses is filled with sand and fine ...
2
votes
1answer
121 views

How many holes will hanging a heavy panel on my wall require?

I would like to build panels to put up on my apartment wall, with a backing (probably wooden) strong enough to attach faux bricks onto my 8' high walls. The panel-making process is as follows: Lay ...
8
votes
6answers
9k views

Is ivy bad for your walls?

We have a front wall covered by ivy. We do like it very much, but keep getting remarks that ivy eventually destroys your wall. My usual response is that you often see ivy on century-old buildings and ...
0
votes
2answers
37 views

How to mount a white board on a wall without making holes in the wall?

I'm planning on buying a big white board to put on my bedroom wall. I don't want to commit to it though, so I don't want to nail it to the wall. Does anyone know of a non permanent solution to fix the ...
2
votes
1answer
1k views

Can I use cement instead of paint for interior walls?

I live in Mumbai (India) where clay brick walls are reinforced with concrete. On the interior part of these walls (inside the house), some layers of plaster followed by a layer of oil paint or any ...
2
votes
3answers
52 views

How can I create a movable insulated wall?

I have a storage area which I need a sectioned. The smaller section will be cooled to 35-40 degrees with the help of our air conditioner and an attached Coolbot system. I want have the option of ...
0
votes
1answer
44 views

Preparing walls for plastering

Hi I'm pulling down wallpaper in front room as I want to paint it but I've found that the old plastering is coming off with the wallpaper, and on last wall I've found they painted under it as well! ...
3
votes
1answer
1k views

How can I hang a framed picture onto a wallpapered concrete wall without damaging the wall surface?

I have a framed picture about two feet by three feet in size that weighs about one pound (not a sheet of paper). I want to hang it onto a wall that is of full-blown hard concrete and covered with ...
0
votes
1answer
17 views

Special sized towel rack brackets needed - do they exist?

I'm trying to replace my bathroom towel racks, without re-drilling holes in the wall. The previous rack's holes are wider apart than all the standard holes I'm finding in stores, so I'm not finding ...
5
votes
3answers
34k views

How do I hang a shelf without drilling holes?

I'm currently living in a house in which we have clear instructions not to drill through the walls for danger of asbestos. I purchased a small projector and would like to mount a shelf to the wall, ...
0
votes
1answer
30 views

Can I use liquid nails to attach toe plate/sill plate to concrete floor?

Sorry for my choice of words yesterday. Hope this is better explained: ground water flooded two finished rooms in my basement. Took out rotting, mildewed drywall, studs, sill plate, insulation. ...
0
votes
0answers
22 views

How to buy the right AC for an existing wall mount sleeve?

I have a non-working GE wall mounted AC. I am looking to remove the chasis and purchase an AC that will fit this sleeve. I looked up the GE AC model to see if there were similar models I can buy to ...
1
vote
3answers
32 views

Can I use construction adhesive alone to attach pressure-treated wall plate to concrete floor?

Replacing walls in basement due to flooding. Contractor installed sump and drain pipe around the inside of the cinder block wall. I want to put in new wall, concerned that TapCon or other hammer/gun ...
1
vote
1answer
53 views

The walls in our living room transitions into the ceiling with a curved surface…what is this called?

Our living room has walls that transitions into the ceiling with a curved surface...the radius of the curve is a few inches I think. What is this kind of construction called?
3
votes
3answers
288 views

How do I prep my houses exterior cement walls for painting?

My house exterior walls are cement - how do I prep it before painting? Here's some photos. I'm thinking maybe a pressure washer but would prefer an easier, less messy alternative if available. I read ...
1
vote
1answer
56 views

what is long term impact of stones on house wall?

Here is my first question on this site. Apology for any error. I live in 1500 sqft house with unfinished basement. I'm planning to put some stones outside house near walls (in garden). And have a ...
1
vote
1answer
99 views

Is this a load bearing wall? Please help

I have a commercial space I am working on and would like to open up the wall between two rooms its a single story building, flat roof, concrete flooring. one room is 400 sq ft and the other is 600sq ...
6
votes
1answer
18k views

How to stop outside rainwater from coming in under the wall and through the concrete floor of my garage conversion?

I have got a problem with an attached garage converted den in a 1978 built brick home. The heavy spring rains are redirected to the two year old perforated drain system on the side of the house ...
1
vote
2answers
76 views

How to hang a TV on a drywall with no studs and no room for toggle bolts?

I am hanging a TV in a narrow wall space that has no studs behind it. I have verified there are no studs behind the drywall by using two different stud finders (a cheaper and a more expensive model). ...
1
vote
1answer
36 views

Building a 1 layer thick brick wall over drywall

Looking to lay a brick wall over drywall in my basement. The floor is a concrete slab which covers my entire basement. I am looking to see what issues or concerns I should have laying a 1 layer ...
0
votes
0answers
55 views

Dealing with a badly inserted wall anchor

I didn't drill the wall deep enough (4 cm or so) and inserted a wall anchor with maybe 4-5mm missing in depth. Then I screwed a screw in cause I though that the screw will help drive it in. It didn't ...
3
votes
4answers
83k views

How can I mount a TV when I can't find studs inside my wall?

WARNING: I'm not the greatest handyman. I bought a TV mount the other day, expecting to hang my heavy 40" TV above the fireplace. However, the instructions specifically say to first screw the mount ...
0
votes
1answer
80 views

I drilled a hole in the fireplace flue

I was trying to hang a shelf on the wall in my living room and was drilling holes to plug fishers in it. Accidentally I found myself drilling into part of the flue of the fireplace (people living in ...
0
votes
1answer
46 views

How to install a mini split when you have brick walls

I want to install a mini-split unit myself. I can't afford to do it any other way and I'm going to die of heat exhaustion if I fail because these window units just aren't doing the trick. The only ...
0
votes
1answer
56 views

Where can I find these textured cast concrete blocks?

I am trying to match up some old blocks but ain't having much luck. Would anybody know the name or style of the block?
0
votes
0answers
21 views

Rabbit proofing gap in gate

I have a gap between the wall and gate which allows rabbits to get into the backyard. My objective is to rabbit proof this gap. I've considered pulling the gate closer to the wall with the threads on ...
3
votes
1answer
913 views

Cause of eroded mortar in exterior brick

This question actually reminded me of an issue with my exterior walls. I have the same problem with the vertical mortar being eroded/missing from several bricks at ground level on the exterior of my ...
1
vote
1answer
187 views

remove chamberlain wall unit

How do i remove below wall unit? I need to replace it with a new one