Vertical structures which usually enclose, divide, define, or protect an area.

learn more… | top users | synonyms (1)

4
votes
1answer
754 views

How can I remove faux brick from a kitchen wall?

My kitchen has these fake bricks placed over the drywall on the walls around the cabinets. My question is, is there a way to remove just the bricks without completely tearing down the cabinets and ...
4
votes
1answer
906 views

What material should be used behind a sink and range in the kitchen?

I am getting ready to demo my kitchen to the studs in a couple weeks. I'm wondering if anyone has any suggestions for alternate materials to use other than "green" board (moisture resistant drywall) ...
4
votes
1answer
2k views

What glass for an interior, mainly glass, wall?

We would like to install a small interior wall (say 3m long) with a wooden door. We want to make it out of large wooden beams with glass between them (there is already one such wall in the house, and ...
4
votes
1answer
647 views

When installing new stud in existing frame, does the stud have to be the *exact* height of the inside of the frame?

I am about to install two new studs into my wall's frame. I noticed that the studs are about 1/16th of an inch shorter than the inner height of the frame. That doesn't appear to be a lot to a layman ...
2
votes
1answer
622 views

Is this wall board made of dangerous material?

There's a room in my house that has walls made of a material that I've always thought was weird. It's not like normal drywall. Recently, I pulled up the base boards I got a better look at the bottom ...
2
votes
1answer
277 views

Installing a swing set between two brick walls?

My neighbors and I are considering putting up a swing set in the alleyway between our houses. The space is about 10' wide, and the house walls on both sides are brick (about 4" thick). Which of the ...
1
vote
1answer
439 views

Hanging a new wall with Genie Clips and need to install a few studs. Will this affect the installation?

Here's what the bare frame looks like: If you don't already know how a wall is hung with Genie Clips, here's the video. Skip to 2:45 to see how they're spacing the clips. ...
2
votes
3answers
434 views

What can I do to solve the moisture problem in my bathroom?

My bathroom walls are done in concrete not drywall. I installed a ceiling fan. After showering, the walls are covered with moisture. What can I do to eliminate the moisture?
2
votes
2answers
1k views

Is drilling a pilot hole into the plaster wall of an old house hazardous asbestos?

The house was built in the 20's, and I was installing some battery powered smoke alarms today. I drilled the pilot holes for the plastic screw anchors and the 'A' word jumped into my head after I ...
1
vote
1answer
249 views

what sized screw should I use?

I have a projector screen which weighs 26kg and I'm trying to fix it on to the wall. The screen has holes for two screws and I'm wondering what size screw I need to support that weight. To ...
5
votes
1answer
3k views

How can I estimate the maximum load on shelves on a plasterboard wall? [duplicate]

Possible Duplicate: How much weight can you mount to a wall? (Apologies for asking here whilst not a serious DIYer, but as a Stack Overflow user it seemed like the obvious place!) I would ...
0
votes
1answer
187 views

What is the best removable insulation material?

There is a crack in a wall that I would like to fill with some removable insulation. It must be removable, as such it should just be a temporary solution. I know of rockwool and glasswool, but don't ...
2
votes
2answers
550 views

What can cause a wet patch to appear on an outside wall around an external tap?

I have just noticed that I have a wet patch around my external tap on the outside wall. The wall seems to dry throughout the day. I have turned off the water to the tap, but the following morning, the ...
6
votes
1answer
2k views

How can I tell if I have rock or wood lath plaster, and is there a difference when repairing cracks and peeling/flaking?

My wife and I are repainting our attic and aren't sure how best to proceed with fixing the wall cracks. We have several different kinds of problems: long parallel cracks set a couple feet apart, and ...
6
votes
3answers
639 views

What tool and technique do I use to achieve this finish in plaster?

Our shed (in Switzerland) has an outdoor wall that is finished with plaster texture called crépi here which Google translates as roughcast. The plasterer here says it is impossible to replicate today. ...
2
votes
2answers
580 views

What are some DIY alternatives to drywall that I can carry up a narrow staircase?

I'm fixing up a house that's been cut into apartments, and needs a few wall and ceiling repairs due to some water damage. I'm planning on cutting out large sectons to check the extent of the water ...
4
votes
2answers
2k views

What thickness drywall do I need for 24" OC wall studs in a detached garage?

I am currently finishing an older 3-car detached garage. Both the wall studs and the ceiling trusses have 24" OC spacing. I know that for the ceiling, I'll need to use 5/8" thick drywall, due to the ...
0
votes
1answer
618 views

How can I protect the wall behind a closet from developing a mold problem?

I'm moving soon to a new two-story house, built from concrete and AAC blocks (Autoclaved aerated concrete). The walls have an acrylic paint over them. I'm planning on installing a wall closet in the ...
3
votes
1answer
374 views

Would building a partial raised wall for a pond in this way be strong enough?

I just read your answers about "Building a raised wall for a pond." Although quite detailed, I am not very physics minded and hope someone will give me a thumbs up or down. I have a pond that is ...
2
votes
4answers
620 views

Can I use a 4x6 as a top plate for a stud wall?

The beam on the front and back walls of a shed and will be extending out to support the roof overhanging the sides of the shed. So instead of using a typical 2x4 top plate for the walls and putting ...
3
votes
1answer
279 views

How do I fix a fallen-off facade?

We live in a block of apartments made from bricks, and the wall outside one window is damaged. We have a clothes hanger attached to that wall, and one screw has already fallen off, and wall around the ...
2
votes
1answer
262 views

What kind of fastener should I use to hang things on cabinets?

I have cabinets that hang down in the middle of my kitchen, above the island, and would like to mount things on the back of them (it's a metal rod from Ikea from which I'm going to hang pots and pans, ...
2
votes
2answers
19k views

What is the right drill bit for concrete or stone walls?

I'm living in an old apartment, circa 1945. The walls seem to be made of an incredibly hard stone or concrete. Any recommendations on the right drill bit type to use? My standard set doesn't even make ...
2
votes
1answer
418 views

How can I hang a framed picture onto a wallpapered concrete wall without damaging the wall surface?

I have a framed picture about two feet by three feet in size that weighs about one pound (not a sheet of paper). I want to hang it onto a wall that is of full-blown hard concrete and covered with ...
0
votes
2answers
452 views

How would you go about installing shelves _in_ the wall?

I would like to install shelves in my wall. The wall itself is sheetrock. What tools would I need, and how would I go about it? I believe what I'm trying to do is called built-in shelving, if that ...
3
votes
1answer
355 views

What is the best way to get rid of plants growing in my walls?

In a rental unit my fiancée just leased, 2 weeks after she moved in, a vine-type weed sprouted from the baseboard in her kitchen. Upon further inspection, I was able to pull about a foot of vine ...
9
votes
1answer
603 views

How do I get to the wall cavity above a double floor joist from below?

I am running some new romex for a couple of electrical outlets. One of the outlets is on one side of a wall in one bedroom and the other outlet is on the other side of the wall in another bedroom. ...
2
votes
2answers
1k views

How do you frame a wall around existing pipes and ducting?

Adding ducting or conduit or pipes to a wall is easy, you just drill or cut a hole. Adding a wall where there is already conduit and pipes poses more of a dilemma, especially if those things are ...
12
votes
3answers
42k views

How do you know when and where it is safe to drill into a wall?

Lots of home projects involve cutting or drilling through walls (everything from nails, screws, or hooks to mount things to cutting through drywall and drilling through studs to run wire). In ...
4
votes
1answer
5k views

How do you frame a wall more than 8-10 feet tall?

I am capable of framing a "simple" 8' wide 8' tall 4" thick wall out of 2x4 lumber, then attaching plywood or drywall or OSB or any other sheet material to the frame. Making the wall wider is a ...
5
votes
4answers
650 views

How can I attach normal framed walls in between concrete columns?

I'd like to add partitions to this grid of columns. I want to make "normal" walls, framed with 2x4 and faced with plywood or drywall. My concern is how to attach the walls to the columns. Naively, I ...
3
votes
1answer
1k views

How much weight can the studs in a non load bearing wall support?

I have a non load bearing wall in my home that has a 52' inch LCD TV mounted into the studs. I think the TV weighs around 90lb I'd like to add another shelf underneath the TV to the same wall mounted ...
4
votes
3answers
2k views

How do I soundproof my vaulted townhouse wall?

I want to soundproof my wall. In fact, it's this wall: I know, right? It would probably be an enormous task, but I really want to get it soundproofed because I have a neighbor on the other side ...
4
votes
2answers
2k views

What's the best material to patch gaps between moulding and the wall?

I am installing new moulding (aka baseboards, woodwork, etc). A few of the walls sort of dip inward, so a gap is left in between the moulding and drywall. What's a good material for patching this ...
3
votes
4answers
726 views

How do I prop-up or fix a wall that is slowly moving?

In the image, the single stack of breeze blocks on the right hand side has been slowly moving away from the wall over the last 4 years. The gate latch (also on the right hand side) is now rubbing ...
5
votes
2answers
585 views

Is it possible to hang something on the wall surrounding my chimney?

My chimney runs up the center of the house from the basement. Where it passes through the kitchen, there is an obvious bulge in the wall where the wall basically wraps around the chimney. Based on the ...
3
votes
3answers
666 views

What is up with this wall, and what is the right way to hang something on it?

I just moved in to a new apartment, in a very old house. The landlord mentioned that it is over 100 years old. The walls are plaster, which means (to the best of my knowledge) that there is lath ...
6
votes
5answers
24k views

What's the best way to hang an unframed poster on a sloping wall without using something that will damage the poster?

What's the best way to hang unframed posters on a sloping wall without using tape or velcro or glue that would damage the poster? Thumb-tacks don't work too well because the poster ends up sagging ...
1
vote
1answer
406 views

Installation of Polystyrene External Wall Insulation - over old render?

I am considering installing a Polystyrene-block based External Wall Insulation system. Currently the house is blockwork with a rough render. One contractor has told be that the existing render on ...
2
votes
2answers
435 views

How do I replace ceiling drywall over cabinets?

I recently had some water damage to my ceiling after a storm. For the most part, it's a simple cut out and replace procedure, but I'm stuck wondering what to do in the kitchen. There's about 1'x2' ...
2
votes
2answers
393 views

How to remove trim caulk orange peeled wall

We're replacing the trim in our room, but the trim that is there is taller than the trim that we want to replace it with. So after removing the old trim, there's a caulk line for the original. The ...
2
votes
1answer
281 views

insulating exterior walls

I have an old house with no insulation. The walls are 2x4 with plaster and lath. The outside is aluminum siding, in good shape. I would like to blow cellulose insulation inside the wall cavities from ...
9
votes
3answers
1k views

What are some ways to appropriately hang things on a wall?

I just moved into a new house and am at the point where I need to start hanging stuff on the walls. Most of the stuff I want to hang is around the size of a picture frame, large mirror, or diploma ...
2
votes
1answer
207 views

How do I re-point an outside wall?

How do I re-point an outside wall? What tools and techniques should be employed?
7
votes
4answers
190 views

Repairing eroded plywood window casing

The interior side casing of my window has been scratched/chewed away a bit, destroying the paint and outer two layers of plywood: What's the best way to repair this? PS the source of the problem ...
5
votes
1answer
395 views

What is the best way to deal with wall tie failure?

My wife and I are considering purchasing a new house, but the surveyor says that it has wall tie failure. What is the best solution for repairing this? Is it really necessary to get the old ties out ...
4
votes
2answers
300 views

Aquarium in the wall

I want to build a wall with aquarium inside. This wall will divide my office from recreational room. Aquarium will be about 2 meters long and 0.7 - 0.9 m high. Width is about 50 - 60 cm. What ...
4
votes
2answers
9k views

How do I properly jack up one side of my house?

As I write this, I have a slight lean as I walk on my floor in some parts of my house, and it's even worse on the upper floor. In some parts upstairs, it feels almost like you have to grab something. ...
2
votes
3answers
645 views

What is the best way to seal this old fireplace vent?

I am doing some minor renovations to my basement with the drop ceiling and found that one of the geniuses that owned the house before me, used fibreglass ceiling tiles to seal off an old vent for a ...
3
votes
1answer
591 views

How to fix a retaining wall that is difficult to access behind the house?

My retaining wall needs to be fixed/rebuilt since it's leaning, but I can't get any machines back there because house doesn't have much side or rear setback(maybe 5ft on each side) and behind the ...