Vertical structures which usually enclose, divide, define, or protect an area.

learn more… | top users | synonyms (1)

6
votes
1answer
163 views

How can I restore this interior wooden siding?

I have a small entry way with wooden siding by my front door. It's not in great condition from the previous owners and I was hoping there would be a way to restore or just make it look better. Could ...
10
votes
2answers
3k views

How to fix small holes in a wall caused by throwing darts?

I can think of a few ways of fixing these marks on the wall but I don't want to try anything without first getting some advice. I have a dart board on a painted wall and as is inevitable with darts, ...
3
votes
1answer
630 views

How to seam new stucco to old stucco when patching large areas

Our city inspector wants us to break out the edge of old stucco to expose the wire then tie that back into the new mesh. But when we did that, it became obvious to everyone (inspector included) that ...
7
votes
2answers
299 views

Are these brick walls properly constructed?

I'm looking into buying an apartment and I'm visiting some locations. During one of my visits I saw this exterior wall of a future apartment building: I'm not an expert but it does not look good ...
8
votes
3answers
3k views

Can I wall-mount a TV when there is an air gap between the drywall and the wooden stud?

I'm mounting a 38lb TV (with a ~10lb mounting bracket). I located a stud, but the drywall floats an inch above it, plus the drywall itself is another 1/2 inch. So a couple 3-inch screws (and not a ...
4
votes
1answer
536 views

Should I use sugar soap or denatured alcohol to clean nicotine from painted walls?

I'd like to clean nicotine off of painted walls, but I'm not sure if I should use sugar soap, or denatured alcohol (methylated spirits). Which would do a better job all-around, specifically for ...
3
votes
4answers
32k views

How can I mount a TV when I can't find studs inside my wall?

WARNING: I'm not the greatest handyman. I bought a TV mount the other day, expecting to hang my heavy 40" TV above the fireplace. However, the instructions specifically say to first screw the mount ...
6
votes
2answers
11k views

How can I remove old paint from plaster walls?

I first stripped the wallpaper from my bedroom walls using a steam stripper and scraper. This revealed a lurid pink paint on the walls and a peculiar purple ceiling paint which came off in sheets like ...
2
votes
1answer
402 views

What to best use to build an artificial wall in my house?

trying to build a wall in my new rented house to separate one big room into two smaller ones. Any recommendations on what to use and on how to build this?
4
votes
3answers
10k views

How to determine the type of wall on which I'm putting up a shelf?

I'd like to put up a small shelf. I have never tackled any kind of DIY project before so this is a first (I don't even have the necessary tools yet!) and I have a rather newbie question: Having read a ...
2
votes
1answer
239 views

How can I seal an old wood finish on a 60-year-old wall that is off-gassing?

We just moved into a 60-year-old house and most of it was recently painted with low VOC paint, although one original wall is a medium-color wood finish which is putting out a strange smell. One of us ...
5
votes
2answers
1k views

How can I extend a wall outlet?

I have a interior brick wall, with wall outlet in it, I am covering the wall with 1/2" sheet rock. But I am ancoring 1x2's on the brick so I can hang the sheetrock. How would I extend the wall outlet ...
2
votes
2answers
1k views

What are the current and voltage limits when determining low vs. high voltage wiring?

I'm trying to figure out what is considered a power line( for outlets) and data communication line. What are the qualifying factors here. I know outlets have 120V AC at 60Hz and data lines have ...
5
votes
2answers
987 views

I removed this non-load bearing wall in the corner of my basement, now 2 doors upstairs rub on their frames. Why is this?

In the image below, notice where the small 1x1 bits are, running perpendicular to the ceiling joists. These was used by the previous homeowner to lower the ceiling in one room, so if you can imagine, ...
4
votes
1answer
306 views

How to prepare poured concrete wall for adhesion

I am considering the application of an artificial stone wall veneer onto a poured concrete wall. The wall is flat with no protrusions or other which might aid in adhesion. I do not know if any release ...
5
votes
4answers
2k views

How do I know if a firewall and mortar contain asbestos?

I want to remove a rock wall behind my pellet stove that was put in in 1980. I have already removed some of the rock and cement that holds the rocks together where the pellet stove is sitting. Then ...
0
votes
1answer
135 views

Is the permeability of normal shellac (flakes dissolved in spirits) the same as Zinsser B-I-N sealer?

I've made a whole batch of clear shellac for sealing ceiling and concrete floors in a heavily nicotine damaged apartment. But I'm worried now that there may be some differences between them, such as ...
3
votes
4answers
7k views

Is it possible to anchor a cabinet to a wall without damaging it?

I have purchased an approx 2m high by 35cm deep dispay cabinet seated on a carpet floor. This is not fully stable (the cabinet rocks a bit when you exert force on the doors to open them), and it was ...
5
votes
1answer
4k views

What size expansion gap should I leave between my wall a hardwood floating floor?

How much space to leave between wall and hardwood floating floor? This is a unique floor. Each board is solid bamboo (never thought I'd say that) but they snap together the same way that an engineered ...
0
votes
1answer
571 views

How can I hang a skateboard deck on the wall?

I have a Skateboard deck and I'd like to hang it on the wall. Analog to hanging a frame on the wall. I've thinking about it but I have no idea on how to do it. Firstly I was thinking to suspend it, ...
2
votes
4answers
363 views

Why are my wall hooks ending up crooked?

I have a power drill and sometimes use it to make holes to put up hooks, etc. in my brick+plaster wall. But no matter how carefully I line the holes up and measure them, the hook always ends up at a ...
3
votes
3answers
25k views

When should a waterproof membrane be installed for shower tiling?

For what kinds of wall structure - tile type combinations a waterproof membrane should be used between walls and tiles?
3
votes
1answer
778 views

Should I install a wall before or after hardwood floor installation? [duplicate]

Possible Duplicate: Frame or floor planks first? I am building a small wall between two rooms. The existing flooring was carpet, which I have removed. I plan to install a floating floor ...
7
votes
4answers
5k views

My house has steel “2x4s” in the walls, can I hang cabinets, a TV, or some other heavy item from them?

The question is pretty much all in the title: My house has metal "2x4's" in the walls. Can I hang cabinets or a TV directly on these metal studs? If not directly, is there something special I must do? ...
4
votes
1answer
4k views

How much thinset is enough?

I'm having a shower tiled and I noticed that the tiler didn't put thinset over the entire area, just on the back of individual tiles. The tiles are heavy stone 3/8x6x12. He used a 1/2 x 1/2 trowel to ...
6
votes
1answer
331 views

Designed a floating corner table, unsure of its potential strength. Any ideas?

I pretty much want to attach some angle iron to the studs and some threaded rods to the angle iron. I'll rout out the profile of the angle iron into the butcher block so it sits flush and so that when ...
4
votes
1answer
1k views

Do I need to install dry wall in my basement?

I have a concrete basement with concrete walls. I'm thinking about just painting the basement and not have to put up dry wall because I want to save money. Is that a good idea or should I really ...
3
votes
2answers
185 views

Possible to screw machine screw in wall?

Background I would like to build picture frames, where there on the back is a hole with 18mm in diameter and 7mm in depth. In the hole will I glue a 2mm metal plate. On the wall would I like to ...
8
votes
2answers
6k views

My neighbor keeps complaining about my music. How to soundproof my apartment?

I live in an old apartment building and the walls are thin. This is a problem because I love to listen to music -- sometimes at odd hours of the night. Yes, I can be an asshole in this way. But my ...
6
votes
1answer
5k views

How to stop outside rainwater from coming in under the wall and through the concrete floor of my garage conversion?

I have got a problem with an attached garage converted den in a 1978 built brick home. The heavy spring rains are redirected to the two year old perforated drain system on the side of the house ...
4
votes
1answer
635 views

How can I drill through rim joist/sheathing for a dryer vent?

I want to vent dryer through the rim joist of this home but it looks like this home has some sort of stone sheathing underneath the cedar shake. I can only see it from the basement. I can't really ...
3
votes
3answers
19k views

Paint got ripped off when trying to remove double-sided foam tape

I was trying to remove a picture frame which was adhered to the wall with some double-sided foam tape. Unfortunately, the foam tape was so sticky and ripped some of the paint off the wall (see ...
0
votes
1answer
1k views

What tack like options are stronger then blu tack?

I want to use something stronger then blu tack as a non permanent option to secure things, such as christmas lights, paintings, small mirrors etc. I mean non permanent in the sense that it does not ...
1
vote
2answers
3k views

How can I attach plywood to a wall without damaging the wall?

I live in a rental and want to avoid permanently renovating the walls. And I have very little home improvement experience. I would like to temporarily attach plywood to the interior walls in a way ...
1
vote
2answers
466 views

How can I convert a wall to a writing board? [duplicate]

Possible Duplicate: Which material should I use for a whiteboard that would erase easily? I would like to convert my walls (at least one of them) into a laminated surface so I would be ...
3
votes
1answer
6k views

How can I patch a hole in a painted wood paneling (or plywood wall)?

We just moved into a ranch house that's well over 100 years. Unfortunately our family made some unusual improvements to it while the last five generations were living there (during various decades). ...
7
votes
2answers
3k views

How should I fill a hole in an exterior wall?

I noticed a good sized hole in an exterior wall that allows wires and things to go from my AC unit into my basement. The problem is that the hole is a good deal larger than it needs to be and there ...
4
votes
2answers
1k views

How can I route an unknown amount of wires through an outside wall?

I'd love to figure out the best way to make a reusable junction through an outside wall for routing cables through it. (Specifically, ham-radio coax cables). It would be fairly simple if I was going ...
6
votes
3answers
1k views

What is the best way to patch 3" holes in plaster

I have a number of ~3" holes in my plaster from where my walls were filled with insulation. (Why did they drill a 3" hole? I have no idea). Obviously I would like to fill these holes in, but they ...
11
votes
3answers
11k views

What's the minimum depth that an electrical box can recess into a finished wall? Does it have to be flush?

Do electrical boxes have to be flush to the finished surface? Can they recess any depth into the wall by as much as 1/8" or 1/4"? Edit: I appreciate everyone offering alternative solutions to ...
3
votes
2answers
886 views

How do I repair crumbling wall plaster?

I found this in a closet behind something that a previous owner had nailed into a wall. It's inside a closet, so it doesn't have to look pretty, I just don't want it to keep crumbling. I was going ...
1
vote
0answers
172 views

Can I repair damage caused by a roof leak myself? [closed]

To fix the exterrior wall, inside the wall and interrior wall can I have friends who are builders help me or do I have to go with a contractor? Also do I need a building permit for this. I had my ...
3
votes
3answers
5k views

How can I mount speakers that don't have mount adapters?

How can I mount a pair of speakers to my apartment walls? Specifically, how do I mount speakers that have no mounting points? They are from a turntable set from the 80's most likely before the ...
3
votes
5answers
3k views

What are some materials that I can use to build a chalkboard?

I want to make a chalkboard wall in the house. I want it to be black or dark, not light colored I want the best chalkboard surface I want it to feel very solid/immovable when installed What do you ...
3
votes
2answers
1k views

How should I choose between a pegwall or slatwall as a tool storage solution?

I'm interested in putting up a tool wall in my garage/workshop. Taking into consideration the price, strength, ease of use and versatility. Which of the two boards will be best for the job and what ...
1
vote
1answer
116 views

Is there a remote switch I can use to replace a switch located in a wall being removed?

I am removing two walls that contain light switches for the dining, and kitchen ceiling lights. Is there a wireless switch I can use for control, without fishing wires into the existing walls?
4
votes
1answer
916 views

How can I remove faux brick from a kitchen wall?

My kitchen has these fake bricks placed over the drywall on the walls around the cabinets. My question is, is there a way to remove just the bricks without completely tearing down the cabinets and ...
4
votes
1answer
1k views

What material should be used behind a sink and range in the kitchen?

I am getting ready to demo my kitchen to the studs in a couple weeks. I'm wondering if anyone has any suggestions for alternate materials to use other than "green" board (moisture resistant drywall) ...
4
votes
1answer
2k views

What glass for an interior, mainly glass, wall?

We would like to install a small interior wall (say 3m long) with a wooden door. We want to make it out of large wooden beams with glass between them (there is already one such wall in the house, and ...
4
votes
1answer
723 views

When installing new stud in existing frame, does the stud have to be the *exact* height of the inside of the frame?

I am about to install two new studs into my wall's frame. I noticed that the studs are about 1/16th of an inch shorter than the inner height of the frame. That doesn't appear to be a lot to a layman ...