0
votes
2answers
42 views

Frame wall with steel post at corner

How do I frame this corner? There are already two walls up (the one on the left that will become a closet), but that the corner where they meet is a steel post. Obviously I can't move that, and I ...
1
vote
1answer
40 views

Possible to remove truss and add collar ties?

I am doing a pretty significant garage renovation and had a couple questions. I was originally going to just replace the loft (the original wasn't supported on top the stud wall on side which always ...
1
vote
1answer
37 views

Wall frame weirdness during renovations

so I am renovating my garage and noticed something in 2 spots along the frame when ripping down the drywall. Here is a photo: The walls of the garage have stood for many many years without major ...
4
votes
1answer
327 views

Proper size of header to support new door in load bearing wall?

We're going to install a new linen closet off the hallway next to our recently(ish) remodeled bathroom. The wall in question is load bearing. I know how to properly build out the King and Jack ...
3
votes
2answers
336 views

How do I properly frame an opening to angle a through-wall air conditioner?

I'm going to install a through-wall air conditioner using a purpose-built sleeve. The instructions from the manufacturer say to install it such that it angles slightly downwards to the outside (about ...
1
vote
2answers
163 views

Framing long walls - Lots of 8' sections or should I use longer top plates

For interior walls (bearing and non) I'm wondering what the preferred method for framing might be on long walls. For example a hallway. Should I just use normal ~8' long 2x4 as top plates and stagger ...
2
votes
2answers
375 views

Interior wall installation over hardwood finished floor?

I'm looking at moving my interior walls around. We are planning to keep our existing floor and replace open spaces with the same floor. We will be refinishing the floors when the wall moving is done. ...
2
votes
1answer
242 views

How do I go about framing a half wall into a full wall?

My house has an second floor open loft area with a half wall that overlooks the foyer down below. I would like to enclose the half wall, add a closet and door to create a fourth bedroom. How do I go ...
10
votes
3answers
2k views

What is a shear wall and what is it for?

I have a wall in the middle of my house which I have been told is a shear wall. The image below is a diagram I put together real quick to show what it looks like. The grey lines on the right are ...
1
vote
1answer
207 views

How can I expand a fireplace box in a framed wall?

We're creating a bumped-out wall with an inset fireplace (ventless, bioethanol), similar to this to give you an idea. One notable difference however is that the bottom of the fireplace will be ...
3
votes
1answer
541 views

How do I install a non-load bearing wall on a carpeted concrete floor and finished drywall ceiling?

I am looking to close off a stairwell with a new drywall wall. The area it will be installed is already finished with carpet stretched over the concrete floor and a popcorn drywall ceiling. What are ...
3
votes
1answer
626 views

How do I attach the framing of a shorter wall to a higher wall above concrete?

Back again with another framing question that I simply haven't been able to answer. For Reference: Gray - Concrete Pink - XPS Insulation Darker Browns - Existing Wood Light Brown w/ Dashes - new ...
4
votes
1answer
225 views

How can I frame this area of my basement wall around my water main?

I have started the process of framing my basement, but I've hit a bit of a snag as I'm not sure how exactly to frame around our water main. My original idea was to frame two walls (floor to joists) on ...
4
votes
3answers
1k views

Can I use engineered I joists as studs in a wall?

Project: 3m by 6m weekend house, roof 3m high, walls 20cm insulation. Question: I want build it from lighter/thinner materials, and i want to calculate from how thick materials i can build this I ...
2
votes
2answers
1k views

How do you frame a wall around existing pipes and ducting?

Adding ducting or conduit or pipes to a wall is easy, you just drill or cut a hole. Adding a wall where there is already conduit and pipes poses more of a dilemma, especially if those things are ...
4
votes
1answer
6k views

How do you frame a wall more than 8-10 feet tall?

I am capable of framing a "simple" 8' wide 8' tall 4" thick wall out of 2x4 lumber, then attaching plywood or drywall or OSB or any other sheet material to the frame. Making the wall wider is a ...
7
votes
4answers
7k views

What is the best way to remove a non load bearing wall?

I have a wall that I want to knock out as part of a kitchen remodel. The wall is non load bearing, so its fine to take out. The question is, what's the best way to do it? I imagine there's not a ...
4
votes
2answers
6k views

Does crown direction really matter when framing a wall?

When framing a wall is it really important to have the crown of each stud in the same direction?
10
votes
3answers
3k views

When should you use metal studs?

When does it make sense to use metal framing for an interior wall? What are the advantages to traditional wood framing?
17
votes
4answers
5k views

How do I find studs when stud finders won't work?

I was trying to hang my TV at my new place, on an interior wall (between living room and a bathroom). Using the stud finder on other walls worked fine, but on this wall I got some very strange ...