The tag has no wiki summary.

learn more… | top users | synonyms

0
votes
1answer
33 views

Can I overtigthen the screws on my pool's skimmer basket

I have an in ground pool which has been losing water too fast recently (about an inch a day). The water level will drop until it is below the skimmer basket, and then it's a more reasonable loss rate ...
1
vote
0answers
44 views

How should I support a large gate in a vinyl fence?

I'm adding a new gate in my vinyl fence; a full width (6') gate. I'm concerned about support. The fence posts are decently moored, but there is still some wiggle. Would it be better to dig out and ...
0
votes
1answer
35 views

basement bathroom flooring options in old 1929 house

I have an old house built in 1929 in Minneapolis, Mn. I need to replace water damaged rotted basement bathroom floor(toilet and shower leak another story). Current floor is 2" by 4" sleepers set on ...
1
vote
1answer
119 views

How do I remove vinyl underlayment?

In the process of replacing our carpets with laminate flooring, I originally elected to retain a 6' x 6' patch of vinyl at the front door. Living in Minnesota and hosting visitors even during our ...
1
vote
2answers
118 views

options for new floor over concrete slab

I am in the middle of a basement renovation, roughly 1000 sq feet. The existing floor is some sort of vinyl sheet material over concrete slab. There is an existing floor drain in the current washing ...
0
votes
0answers
24 views

Recommendations for Removing Vinyl Wallpaper

I'm planning to remove old (around 30 years) vinyl wallpaper from a room in preparation for painting. I understand removing this type of paper can be difficult. Does anyone have experience with a ...
1
vote
1answer
101 views

How do I fix a good size gouge in my faux wood vinyl floor?

We have faux wood laminant through out our kitchen.We had to move the refridgerator and when doing so we gouged(with a crease) the flooring.We are trying to sell the house and would like to try to ...
0
votes
0answers
43 views

Should I glue down sheet vinyl?

How does a person know if sheet vinyl is glue down or not my daughter bought it at a surplus store to save money it fells cushioned and is1/8th to3/16th inch thick
2
votes
2answers
525 views

Should I peel off the top layer of vinyl in preparation for tiling?

I'm preparing my kitchen floor for ceramic tile. Currently it's a sheet of vinyl(linoleum?). The plan was to sand off any gloss and tile over it. I was going around the edges picking off any loose ...
1
vote
1answer
62 views

Can I fit hardboard of two different thicknesses?

I'm fitting hardboard on my bathroom's floor in order to glue vinyl on top of it. However I'm using 2 kinds of hardboard. One is 3mm thick, and the other 2mm. Is this a problem, and if so is there an ...
2
votes
2answers
182 views

How can I remove vinyl base without damaging the drywall?

My house has vinyl base material attached to the walls in the laundry room and bathrooms. This material is glued directly to the drywall. It is presently unclear if the glue was a pre-applied layer on ...
1
vote
0answers
120 views

Click vinyl on basement floor with drain

I have a basement with a grade leading to a drain in the floor. The previous owner added a wall over the drain and put self-levelling cement on one side of the wall, over top of existing linoleum ...
2
votes
1answer
412 views

How do I flatten my uneven concrete floor?

We have an old Victorian house with a concrete floor throughout the ground floor. The ground floor is partitioned in two by a dividing wall and french doors. From the front of the house to the ...
0
votes
0answers
22 views

Installing Azrock VCT on Cement Floor

I need to install some replacement tiles on a basement floor. The original tiles are Azrock VCT (vinyl composite tile?) and were installed some time ago, mid-90's perhaps. Some of the tiles have ...
1
vote
1answer
159 views

Will my new adhesive-backed cork tiles adhere to my existing sheet vinyl?

I have a vinyl floor, not tiles one full piece, over concrete, in my bathroom. The vinyl is solid and perfectly fitting to all the walls and runs beneath the bath, shower, toilet, sink and fitted wall ...
2
votes
1answer
121 views

How to install vinyl tubing for bathroom vent?

I need to replace the vinyl tubing that goes from my bathroom ceiling to the side of the house. It had a rip in it and I was successful in pulling it out. I went into the attic crawl space and ...
-2
votes
1answer
582 views

What type of replacement windows can I use on my log home?

I'm stumped as to what style of window to pick for my log home (replacement). The current windows are aluminum frame, and are trimmed flush on both sides with wood, so all you see is a very thin strip ...
1
vote
3answers
2k views

How do I patch this hole in my vinyl window frame?

Not sure what the previous homeowner was thinking when he drilled this hole, but what would be the best material to patch it with? As you can see in the picture, it's a purely aesthetic fix but I'm ...
1
vote
1answer
465 views

I mounted a vinyl picture window sideways, can I drill small weeping holes into the frame?

I found a nice picture window on the cheap but its frame weeping holes are designed to drain in a horizontal orientation (one in each lower corner). I have mounted it vertically, so now there is a ...
1
vote
1answer
317 views

How to Level Concrete for Sliding Patio Doors?

I'm replacing an outdoor sliding patio door set with a new one that has almost the exact same dimensions - luckily the previous homeowner (family) did not go with custom-sized doors. The issue is ...
3
votes
1answer
270 views

Which type of vertical window shades are the most durable? [closed]

I am looking into purchasing vertical window shades. I hear vinyl will warp with heat, but I also hear fabric isn't as durable as vinyl. Not sure why fabric is much more expensive than vinyl though. ...
2
votes
0answers
275 views

How can I find wide diameter clear tubes at a cheap price? [closed]

I am trying to build a series of tubes for my pet rat to run around the apartment in. But I need for the tubes to be at least 3'' in diameter, preferably 4'' and I need them to be clear so I can find ...
6
votes
1answer
624 views

Our vinyl floor install will need to be redone — will new vinyl need to be used, or can the existing vinyl be reused?

I had a company (whose name will not be mentioned unless they refuse to fix the job) install a new vinyl floor. I'll spare all the ugly details except the one that's relevant to this question which is ...