1
vote
4answers
370 views

How to fit 4" rigid aluminum duct vent in between walls when there is an angle brace?

I want to do what these people have done here: The problem is I have bracing going diagonally and it is not leaving enough space for the 4" aluminum duct vent. Can I saw the bracing off for the ...
4
votes
2answers
111 views

Dryer exhaust from 2nd floor through crawl space, out roof

This is my setup, 1986 built town home. I just purchased a dryer and before connecting it, I decided to inspect the 4" tube going from the dryer, up behind the wall to the crawl space / attic and out ...
1
vote
0answers
511 views

How can I tell if my bathroom ceiling vent is working properly?

Seems to take the vent forever to clear shower vapor from room. I purchased a vent that had a good rating. It is vented to the outside. How do I know if it is working properly and actually venting to ...
2
votes
1answer
176 views

Covering roof vents to keep out roof rats

I have around 20 vents on my roof and I currently do not have a roof rat problem but I want to cover them with something to prevent roof rats getting into the attic. I'm sure I can find something at ...
2
votes
3answers
2k views

Should I install an exhaust fan in a new garage?

I'm having a new garage built in my home and I'm wondering if it's a good idea to have some sort of ventilation/exhaust/fan system installed while they're at it? I'm thinking of doing some spray ...
2
votes
2answers
800 views

Can I vent a basement bathroom into a semi-enclosed crawlspace under an attachment?

I'm refinishing my basement bathroom and installing a vent. I can easily vent out to this wall, but the thing I'm worried about is it's semi-enclosed. In the winter we put up tarps and store wood ...
2
votes
1answer
1k views

What can be done about this unattractive dryer vent?

The house I bought has dryer vent that runs from the dryer into the ceiling. Besides being an eyesore it is also loose/flimsy. I'm redoing the laundry room and would like to make this more ...
5
votes
2answers
701 views

What kind of vent is pictured here and what are its uses?

While my roof was being replaced, I requested that they install two roof vents. One for laundry and one for bathroom fan. They installed two of these. I just tried connecting the bathroom fan to this ...
1
vote
1answer
468 views

How can I vent a range hood that's not on an exterior wall?

I want to vent a range hood out and it is not on an outside wall. I have already installed 12X3.5 duct into the attic through the cabinet and ceiling (visable). the 90 turn and wall cap are 10X3.5. ...
3
votes
1answer
991 views

How can I reduce whistling due to wind across a gas fireplace vent?

We have a gas fireplace venting through the roof of our attic bedroom; there's a cap on a chimney up there. Double-wall construction, such that it pulls combustion air in from outside. When the wind ...
8
votes
2answers
10k views

What are my options for venting a bathroom exhaust fan?

I would like to install a fan in our bathroom which currently has none. However, I'm very confused regarding the best approach for this. Above the bathroom is an attic space. I have read that ...
2
votes
3answers
12k views

How to make a 6 inch hole through a brick wall for venting

I'd like to vent my range hood out through an exterior brick wall. How would I go about making a 6 inch hole for the vent? I'd guess I'd use a masonry chisel to chip out the mortar and then pull ...
5
votes
2answers
3k views

Installing bathroom exhaust fan: what to do with vapour barrier and insulation?

I'm adding a bathroom exhaust fan, which is being mounted in the ceiling of the bathroom (in the attic) and venting out through a vent in the wall. right now, there is a vapour barrier (paper) ...
9
votes
7answers
12k views

What is the best way to clean your clothes dryer exhaust?

My dryer exhaust goes out of my laundry room, into my attic, and runs for about 15 feet before it gets outside. Over time the lent has built up quite a bit. What is the best way to clean this? The ...