5
votes
1answer
563 views

Is this an appropriate drain design for adding a shower?

I recently took on the challenge of adding a shower to my existing downstairs bathroom. The bathroom is inside what used to be the garage so it is far away from any existing vents. After some demo, ...
6
votes
1answer
3k views

How can I lengthen my vent stack and are there any negative effects in doing so?

I have observed that when we receive a lot of snow here in Ontario, at least one of the drain vents on my roof is covered by snow. While after one winter in the house I have not yet observed any ...
5
votes
1answer
8k views

How can I properly vent a basement toilet & shower using an AAV?

When we bought our house the plumbing drains for a basement bathroom were roughed in but they did not install any vent lines for them. We have the first floor plumbing draining into the main stack ...
5
votes
2answers
14k views

Maximum run on drain?

I'm planning a reconfiguration of my basement and want to move both the powder room and w/d to new locations. The powder room would be close enough to the stack not to worry me, but I'm looking at ...
3
votes
1answer
559 views

Can I use a 1 1/2 vent for a toilet (3" drain) in CA (not a went vent, no other fixtures on it)?

Most of the info I have on code implies this would be OK, but one item I have says that a 1 1/2 vent can only serve 8 "non-WC" fixture units.
8
votes
2answers
6k views

How do I install a sink in a room that doesn't have a drain vent?

I want to install a sink in my attached garage where there is no existing plumbing. I will be running new water supply and drain pipes to mains behind a nearby wall. I'm concerned I will need a ...