The tag has no usage guidance.

learn more… | top users | synonyms

0
votes
2answers
87 views

Why does my garage door opener only click when the button is pushed?

My Quantum 3213 garage door opener only clicks when I hit the main button in the garage. The light comes on for 30 seconds or so, and then it blinks on and off. I've checked all the safety ...
1
vote
0answers
14 views

How can I figure out exactly where a bathroom leak is coming from?

There's a small amount of water at the lowest point on my bathroom floor. It looks clear and doesn't have a smell. Lately, it's been showing up every day, whether anyone's taken a shower or not. ...
1
vote
1answer
14 views

Why isn't my halogen floor lamp working with new bulb and new dimmer switch?

I replaced the bulb and the dimmer switch. There is 120V between the connections when switched on. It varies between 115V on low and 122V on high. The bulb has continuity. I also measured the voltage ...
2
votes
2answers
51 views

My florescent lights need a shake or a hit to work

I have a Wave Twin Fluorescent Ceiling Light that doesn't light up in general. If I switch it on, it only lights up a very small part at one end. I need to shake it or give it a hit a couple of times ...
0
votes
5answers
563 views

Router bit depth keeps decreasing/slipping down, where is the problem?

I inherited a black and decker plunge router from my grandfather. From when I first tried it the bit has always slowly receded back decreasing the amount the bit protrudes from the router base. This ...
0
votes
1answer
23 views

Aprilaire 560 repair

My Aprilaire 560 humidifier will do a bang click many times before it turns the blower on. I replaced the solenoid valve with a new factory part and it still does the same thing. What next?
1
vote
2answers
177 views

Is this the source of my hot tub leak, or just a symptom?

Background: I have a Galbocca 2-person Plug and Play HotSpa (tm?) that I imagine is quite old. It came with the house I'm renting, so I have no idea exactly how old it is, but the company doesn't ...
3
votes
1answer
37k views

Troubleshooting a leaking exterior door

I have an exterior door that leaks water into the house when rain is blown against it. The floor on the inside of the house is unfinished, meaning it is just the raw subfloor. I don't want to put the ...
2
votes
2answers
6k views

Why won't my washer spin even though it still agitates?

I have a Kenmore 80 series washer and it recently stopped spinning and agitating and I found out it was the coupler. So I changed that and it start to work again, normally. After a week or two it ...
4
votes
2answers
55 views

GE gas dryer noise - is this from motor?

Hi I'm trying to fix my 13 year old dryer. It's started to have squeaking noise but I was able to fix that by replacing the front and rear bearing. Now it's starting to have this noise and I think ...
2
votes
1answer
122 views

When I turn the light on/off on one circuit, it makes the light “blink” off/on on another circuit

I apologize for the long post, but I wanted to provide as much info as possible. Recently I started a DIY home electrical project to replace a lot of light fixtures, the light switches, and the ...
0
votes
1answer
158 views

Identifying an unknown and intermittent source of electric power usage

I have noticed a problem with my power usage today. I'm watching the meter often and making a record of each reading for the last three days. So far, nothing to note as far as unusual usage until ...
5
votes
11answers
56k views

How can I find an open neutral?

My lights and outlets went out in the half bath of my home and also the two recessed lights in my hall just outside the half bath. I believe there are two feeds, one to the hall lights and one to ...
1
vote
0answers
48 views

HVAC - hot air flowing on both zones when only 1 zone should be on

I have 2-zone forced air heating, with separate thermostats for each zone. Normally, if the thermostat in zone 1 triggers the system to go on, the heat will only blow through the vents in zone 1. ...
5
votes
3answers
8k views

Why is my lighting circuit tripping the breaker?

I have several MR16 2 pin style light bulbs in my kitchen - The other day the trip switch for the light bulbs tripped when turning these bulbs on - I went and flipped the trip switch and tried again ...
0
votes
0answers
37 views

question about a gas furnace having to light repeatedly

I am new to this forum, but I will do my best to answer any questions I can (I am a general contractor with a background in engineering and residential construction and machine design) so, here is my ...
1
vote
1answer
44 views

GFCI in garage keeps tripping when I turn on kitchen lights

The GFCI outlet in my garage keeps tripping whenever we turn on the kitchen lights. When it trips, two cable TV boxes in the living room and one bedroom also lose signal. I press the button ...
2
votes
2answers
62 views

Unable to close Garage door with remote

I’ve made a video of the issue. I have a craftsman garage door mechanism and can open the garage door with the remote but unable to close my garage door via the remote. I can do both the tasks via the ...
1
vote
1answer
71 views

How to troubleshoot “refrigerator power goes off occasionally but comes back on when I cycle power switch off and back on”?

Refrigerator power occasionally goes off (lightbulbs are off, and apparently everything else though I haven't tested with a multimeter or anything) but comes back on when I cycle power switch off and ...
0
votes
0answers
63 views

Flashing LED down lights

Here's one for the master electricians. I just installed two new LED down lights and noticed this morning that when I turned them on they started flashing on-off at about a 1sec cycle. When I ...
0
votes
2answers
49 views

garage door button on the wall does not work but remote control does open and close garage door

My remote control opens & closes the garage door but the button on the wall does not work.
3
votes
1answer
62 views

If a Drill's Clutch doesn't properly align the gears, can it cause the Chuck to loosen?

So I was using my hammer drill to drill into some masonry when I ended up hitting the clutch to a lower setting. When this happened, the trigger remained pulled for a moment, but the bit nor the chuck ...
1
vote
2answers
79 views

What would cause multiple fridges motors to stop running, but leave the lights on?

When my old fridge cooling unit stopped working but the light remained on we assumed that since it was an old fridge that it was broken, so we replaced it. Today my new fridge has had the same ...
1
vote
1answer
27 views

generator quits running

I have a Coleman 6250 generator that has set idle for over 3 years. It has compression. I can start it with a little carb cleaner and keep it running with that, but as soon as I stop squirting it ...
2
votes
1answer
451 views

What should we do with floor tiles that were applied with Type 1 Mapei mastic?

We tiled a 25 sq. ft bathroom with 12X12 porcelain tiles. Instead of a bag of normal powered mortar (which covered more area than we needed), we picked up the tub of Type 1 Mapei and were told it was ...
1
vote
1answer
83 views

Lutron Maestro CL Extreme Delay

I've had nothing but success with using Maestro dimmers on both LED and incandescent lighting for years, but recently picked up a new dimmer (MACL-153M-WH) and a pair of G7 Elko LEDs (30W total) and ...
0
votes
2answers
132 views

trouble shoot air conditioning thermostat

my compressor outside is not kicking in. Here's the sequence of events: I came home and the thermostat - a Honeywell LCD - was no more numbers and the battery indicator was flashing. replaced the ...
0
votes
2answers
299 views

What could be causing this strange intermittent sound?

I've seen that there are already some questions about odd sounds but I thought if anywhere is likely to provide a specific answer or a suggestion, here would be a good place to look. I have a ...
1
vote
1answer
58 views

Refrigerator freezes contents, even when set to warmest setting

Our refrigerator, an Amana/Whirlpool ABB1921DEW5, works very well -- rather too well, even, as the contents of the refrigerator are freezing, even with the refrigerator thermostat on its warmest ...
3
votes
4answers
5k views

Troubleshooting a garage door/opener that “catches” and re-opens when wet

My garage door and opener work reasonably well most of the time -- hot weather or cold. Sometimes when it rains, though, the door "catches" a little bit, at about 2 feet from the ground, and it is ...
3
votes
2answers
165 views

Troubleshooting dropped phase in 240 volt line

A 60 amp breaker in our circuit breaker box serves a sub-panel in our barn. That panel serves 5 120 volt lighting and convenience circuits. The sub-panel has two bus bars, each attached to one phase ...
0
votes
1answer
67 views

Could our new plumbing be to blame for our new downstairs toilet and upstairs spare bath being clogged?

We need help troubleshooting our plumbing problem before we spend any more money on this house. We just spent quite a bit of money finishing our basement, where we added two bedrooms and a new full ...
1
vote
1answer
2k views

Troubleshoot AC issue, no inside blower

I need help troubleshooting Rheem RAHE-036JAS, Armstrong G1N80AU125D20C-1, Honeywell ST9160B 1068 Board, Honeywell SV9520H 8034 Gas Valve. About a week ago, AC and Heat were working fine. After ...
0
votes
1answer
52 views

Circuit troubleshooting. Need input on discovery

Using an extension cord (like new, great condition), I checked a disconnected circuit attached to the same service. First, I checked the disconnected circuit: Hot -> Ground ~0V Hot -> Neutral ~0V ...
0
votes
0answers
102 views

What can cause a Ceiling Fan to rotate slow at certain speeds

Home Ceiling Fan Specs: Make: Crompton Greaves (Dont remember the model) Years in operation: More than 7 years No of Speeds available: 5 speeds Issue #1: The Ceiling fan rotates slower at positions 1 ...
1
vote
1answer
173 views

Why is it taking so long for my A/C to start?

When I turn my AC thermostat to cool, I can hear it click but the outside unit does not start and no air blows inside. Several hours later everything turns on and it works fine. If it turns off, ...
1
vote
3answers
228 views

Timer on dryer stopped working

The timer on our Maytag dryer seems to have died/stopped working and I would like to replace it myself: What I mean by "died/stopped working" is that the timer no longer decrements and mechanically ...
1
vote
0answers
22 views

lost voltage to outdoor light fixture

have an out door motion decter light suddenly w/o voltage to fixture. I traced romex from mdl to an in ceiling down light in laundry room. down light works fine, switches on and off. am I shooting the ...
1
vote
2answers
2k views

Why did my hot water stop?

I have a Rinnai RL94 tankless water heater. Today something went wrong and now I have no more hot water. The machine is not showing any kind of error code like it has in the past when things went ...
1
vote
1answer
849 views

Why does my breaker trip when I turn a light on?

In my bedroom I have a light wired to a plug and three receptacles. There is nothing plugged into the receptacles but every time I turn the switch to the light on, the breaker trips. The wiring ...
1
vote
0answers
82 views

Why does my Whirlpool washing machine stop after the wash cycle?

My scenario: Whirlpool washing machine, mechanical timer/dial. It will fill with water, agitate during the wash cycle and at the END of the wash cycle it (the timer) clicks and stops completely. ...
0
votes
1answer
328 views

Heating system won't blow warm air

Turn my heat on via the thermostat. My oil fed burner kicks on and is lit up (heat is being made). The system is sucking in air to feed the system. Only problem is hot air never makes it out the ...
2
votes
1answer
1k views

Why did my oven light stop working after cleaning the oven?

I replaced the bulb in the oven with a new bulb and it won't light. Both the old bulb & new bulb work in a table lamp. The light stopped working after cleaning the oven. Any suggestions? Is ...
2
votes
3answers
2k views

How can I remove a stuck overhead light fixture?

I recently decided that it's time to install some less hideous lighting in my apartment. Since it's an apartment, my options are limited because I must be able to restore whatever is there now if I ...
-1
votes
1answer
25 views

Viewing cumulative electricity usage [closed]

The TED 5000C monitors real-time electricity usage. This, however, isn't so useful if plugged into, say, a fridge, where, presumably, the bulk of the electricity usage is going to come from when the ...
1
vote
1answer
716 views

How to troubleshoot/diagnose an oven that won't heat past a certain point?

Our ovens (double-stacked Nutone Hotpoint circa 1960s) are old: About 2 months ago, we noticed that the bottom one - which had been running great for years - wouldn't get any hotter than just ...
0
votes
2answers
1k views

Why do my fluorescent lights turn on slowly or not at all in the summer?

We live in Florida, and the fluorescent lights in the kitchen turn on very slowly (if at all) in the summer. Other clues are: They work fine in the early morning Later in the day (hot day) they ...
0
votes
0answers
122 views

sliding window with electric roller shutter doesn't fully close

I have this window which doesn't fully close. It stucks at some point while closing. I can hear its electric motor still working but something prevents it from fully closing. So half of the holes are ...
0
votes
0answers
68 views

GFCI circuit partially works

While making coffee using downstream outlet, it just stopped. My GFCI outlet works and it isn't disconnecting. The test button also works but downstream outlets don't. What would cause that? ...
0
votes
1answer
4k views

What could be causing my lawn mower to surge?

My lawn mower was giving me the worst time tonight. The only way I could keep it running was to pull the choke back and the engine would start again. Finally, after 30 minutes of messing with it, the ...