0
votes
1answer
45 views

Are router bit imperfections normal?

I just got my first router and purchased some Freud bits for it. However, I noticed that a few of them have pitting at the base where the cutter joins the shank. Is this normal for router bits, or is ...
3
votes
1answer
209 views

What router bearing can I use to reduce groove depth?

I order this 3/32 slotting bit from Amazon. Shank size 1/4, depth of cut up to 9/16. I only need 3/8 depth (slightly over is ok), but I could not find the right bearing. There are router bearing ...