1
vote
1answer
111 views

What tool is used for this tight plumbing situation?

Our tub drain is severely plugged. Cannot get a snake down into it. Our crawlspace is only about 18" tall (WHY?!?), and due to both the confined space and the angle we cannot leverage the wrench in ...
3
votes
1answer
235 views

How can I repair a fiberglass ladder?

I have a 10 ft fiberglass step ladder that was damaged when someone used it on unstable ground. This ended up ripping one of the rivets on the middle locking brace out of the fiberglass. Anyone have ...
0
votes
1answer
5k views

What type of glue sticks to tiles?

I have some hooks that has a glued surfaced attached to it. They look like this, Image Courtesy: www.dhgate.com I bought a lot of them. Like 50-60. I used them almost everywhere. Mostly in ...
1
vote
1answer
438 views

What is the life expectancy of a ratchet strap?

During my house move I used ratchet straps to secure a book-shelf on a roof of my car. That was well secured and worked out perfect. But the second time I have tried using the same straps, they did ...
3
votes
2answers
5k views

Troubleshooting a circular saw that quit working

I have a circular saw that quit working for no obvious reason. I cut a board and sat the saw down to get another board. When I tried to cut the next board, the saw wouldn't work. Pull the trigger ...
3
votes
2answers
5k views

How can I clean sticky and dirty hand tool's rubber?

I have a hand tool - Needle-nose plier that had a rubber that is used as the handle. Currently, I managed to clean up all the rust on the metal and would like to clean up the rubber handle as it is ...
20
votes
7answers
4k views

How can I repair rusty tools?

Should I use sandpaper to clean the rust from the tools (e.g. Needle-nose pliers), or can I soak them in vinegar or lemon juice? Would I be better off just buying new tools (which can be an ...
11
votes
2answers
6k views

How do I replace an axe handle?

I have an axe with a damaged handle that needs replacing, but I don't know how to do it. What tools and techniques should I use to get the job done?