0
votes
2answers
191 views

Is sawdust really that bad for my vacuum cleaner?

My mother (who tends to be right about this stuff) says that using my non-shop-vac to cleanup sawdust will ruin the motor. I recently bought a new, fancy, expensive vacuum cleaner that was really ...
3
votes
1answer
131 views

Is it necessary to keep tools lubricated?

I've noticed that some of my tools, especially the more expensive ones (e.g., a wire cutter), come lubed. So, is it necessary to keep them lubricated? If so, what kind of oil should I use?
1
vote
1answer
449 views

What is the life expectancy of a ratchet strap?

During my house move I used ratchet straps to secure a book-shelf on a roof of my car. That was well secured and worked out perfect. But the second time I have tried using the same straps, they did ...
3
votes
2answers
7k views

How do I fix a Bostitch nail gun that is jammed?

I have a Bostitch nail gun (pneumatic) and it has been working fine all day until about 30 minutes ago. I went to nail in a piece of molding, and when I pulled the trigger I heard air feed into ...
3
votes
2answers
5k views

How can I clean sticky and dirty hand tool's rubber?

I have a hand tool - Needle-nose plier that had a rubber that is used as the handle. Currently, I managed to clean up all the rust on the metal and would like to clean up the rubber handle as it is ...
13
votes
6answers
3k views

How do you sharpen a knife?

Just got done sharpening a few knives, and thought it could be useful to post a question about it here. So lets say I have one of these guys. With a coarse stone, a medium stone, and a fine ...
21
votes
7answers
4k views

How can I repair rusty tools?

Should I use sandpaper to clean the rust from the tools (e.g. Needle-nose pliers), or can I soak them in vinegar or lemon juice? Would I be better off just buying new tools (which can be an ...
3
votes
1answer
255 views

Can I use a rusty soldering iron?

I am thinking of getting back into stained glass. One of the projects I want to work on is to fix a stained glass window that has a section with a crack in it. I was given a couple soldering irons ...
13
votes
2answers
5k views

When should I replace a circular saw blade?

Is there a rule of thumb for how often a circular saw blade should be replaced? Is visually inspecting the blade condition enough?
1
vote
3answers
144 views

What are good cleaners to use on pruning shears?

I'm new to the realm of shrubbery trimming, though have gotten some good results already. Now, however, I need to clean my pruning shears so they don't rust / get sticky. What are good cleansers to ...