This is an open-ended question. I will describe the situation and outline my approach to solving the problem. I am hoping to get feedback that will help me decide if this is the right approach, ...
My attic has tongue and groove planking down as the floor, and I need to do some work up there. I'd like to only remove a couple planks in the middle of the field, rather than pulling up half the ...
I order this 3/32 slotting bit from Amazon. Shank size 1/4, depth of cut up to 9/16. I only need 3/8 depth (slightly over is ok), but I could not find the right bearing. There are router bearing ...