For questions specifically regarding sanitation fixtures designed for removal of human waste, generally referred to as toilets but also including urinals and bidets. Topics include designs, installation, repair, plumbing supply and drainage, and sanitary concerns including cleaning.

learn more… | top users | synonyms

3
votes
1answer
221 views

Temporary toilet installation

I need to install a toilet in a my house while it is being built. The floor isn't ready yet and won't be for at least a couple of months and right know it is a rough concrete slab. Since the soil ...
0
votes
0answers
47 views

How do I remove the vacuum behind my toilet's flapper valves?

Over the last 12 months, the toilets in my condo have becomes progressively harder and harder to flush. Once the flapper valve finally releases, they flush just fine, but it's getting them to release ...
0
votes
1answer
2k views

How can I fix a wall-mounted toilet that keeps running?

Our wall-mounted toilet keeps running. It is easy to "stop" by removing the plate with the push-buttons and pressing down the cylinder (valve?) inside, but I'd like to find an actual solution :) It's ...
0
votes
0answers
22 views

How to rewaterproof shower recess

I have a laundry/toilet/shower built just over 2 years ago. Recently, I engaged a tradesman to relocate the toilet bowl into the shower Recess. Unfortunately, he did not pull out the tiles and ...
2
votes
0answers
214 views

How can I adjust the depth to which a pneumatic toilet flush button must be pressed?

We have a toilet with the cistern built into a cabinet, with a button on the front to flush it. However, it only seems to flush if you press the button right in (quite deep) and you have to do it ...
3
votes
1answer
6k views

Why does this toilet fill valve leak around the top?

I have a pretty new dual-flush toilet whose fill valve suddenly started leaking for no reason. A picture of the toilet is below: Basically, the toilet flushes normally once the button is pressed. ...
0
votes
0answers
212 views

Why won't my toilet flush?

A sewage pump in my basement is 7 feet from the shower drain and 2 feet from the water closet. The only vent is from the sump pump which runs 20 feet horizontally to an outer wall then goes ...
4
votes
1answer
4k views

Why does my toilet make a high pitched whine when it refills?

When my toilet is refilling with water,it makes a very high pitched whine. Any suggestions on how to resolve?
1
vote
1answer
280 views

Why won't my toilet hold the refill water?

I know there are several posts on toilet fill valves and supply lines, but I'm afraid that my issue may be much worse. My toilet was draining slowly so I got a professional grade auger and ran it ...
0
votes
2answers
972 views

What is causing the vibrations through my water pipes after flushing the toilet?

I am getting vibration through my pipes after flushing, it is also very slow & I am finding cement pellets at the bottom of the pan
3
votes
4answers
237 views

What is the easiest way to tear out a bathroom subfloor?

We recently did some remodeling, and in the process, managed to hook up the toilet in the bathroom to the hot-water line. The trouble is, we discovered this fact after we had already put down the ...
1
vote
1answer
107 views

Can a cracked toilet be permanently repaired?

So I broke the entire corner (top to bottom) off of the tank on my toilet. The toilet was inherited by me in house, which was a foreclosure. It is a one-piece that is valued at $1450. I was ...
3
votes
1answer
117 views

Is there a simple way to retrofit an existing toilet with a top-mounted sink?

I'm looking for a toilet with an integrated sink. I've seen them on rare occasions: flushing the toilet activates the sink, which re-fills the toilet and tank using the water that drains through the ...
1
vote
1answer
127 views

Why isn't my Fluidmaster installation working correctly?

I have tried two brand new fluidmaster toilet valves. It is very inconsistent. Sometimes it doesn't allow the tank to fill, sometimes the floater does not engage causing perpetual flowing of water, ...
0
votes
0answers
67 views

Wax rings flange is to large for the floor drain?

When trying to install a new wax ring with the plastic flange, the plastic flange did not fit in the floor drain hole, is that normal? Should I use 1 or 2 wax rings with out the flange?
2
votes
1answer
114 views

Is there anything wrong with leaving toilet tank below waterline?

In troubleshooting a problem with recurring flushing (turned out to be a worn out flapper) I lowered the tank water level to about an inch below what the manufacturer marked as the waterline. Flushing ...
4
votes
4answers
579 views

Why are all the toilets in my house running intermittently?

All of my toilets in the house have started to run intermittently. Is there something wrong with the plumbing or could it be that the flapper has gone bad on all the toilets at the same time?
3
votes
1answer
206 views

What is the “warm water method” of clearing a clogged toilet?

In this question the OP mentioned that, when having problems with blocked toilet, as his first attempt he tried warm water method. I would like to ask: What is warm water method? For which ...
3
votes
1answer
874 views

How do I make a new toilet tank on an old bowl flush properly?

Problem / symptoms: I've bought a new water tank (nothing fancy inside, just what I'd describe as "the usual, run-off-the-mill mechanism"*), but it doesn't flush properly, as it doesn't release enough ...
0
votes
1answer
247 views

Does my toilet have a manufacturing defect?

I purchased a Kohler toilet about 6 months ago for my bath remodel. I finally got the bath finished after a sequence of delays. The toilet is about 1/8" off level in the rear (see photo) and rocks ...
2
votes
3answers
3k views

How to open the lid of this toilet water tank?

Water is contantly leaking so I want to open the lid of the tank and fix the leak. However, I can't open up the lid! Any ideas? Picture 1: The water tank from above. The two buttons lifted out from ...
5
votes
2answers
1k views

What do I do with a sewer pipe (toilet rough-in) full of cement?

I have a problem that is mind boggling. I bought a house and am now just getting ready to put a toilet in the basement, which has a cement slab. I just took the cover off the rough-in expecting the ...
3
votes
4answers
11k views

What can I do about a toilet flange that is 1/4" below the finished floor?

I used two wax seals to set my toilet since the flange is 1/4" below the new tile. At first it seemed to be water tight but after a few flushes I noticed water seeping and pulled it out. As can be ...
4
votes
1answer
328 views

What is this pipe called, and how does it work? (Round II)

OK, thanks for people's help on my last question, now I've confused myself again. I came across this picture, similar to the last question, but I don't think it's a cleanout. It looks like a vent to ...
5
votes
2answers
983 views

What is this pipe called, and how does it work?

I recently saw a plumbing setup where a 2" pipe was run from a bend in the 4" toilet return. The 2" pipe bent upwards to meet the floor next to the toilet, where it was capped off with a removable ...
2
votes
1answer
147 views

How can I remove this flapper alternative?

I had good luck in the past using this product to replace a leaky flapper valve. However, this new toilet does not have a flapper hinge on the base of the flush valve. Instead, there is a ...
2
votes
2answers
5k views

What is causing toilet supply water leaks above the coupling nut?

In my toilet, when the shut off water valve is open: Water leaks above the coupling nut: If I close the supply water valve and the tank is full, there is no leakage. What could be causing the ...
5
votes
4answers
3k views

How do I get these toilet shut off valve out?

As title says I am trying to figure out how to remove the old shut off valve from the pipe. I've been watching lot of videos, reading up on articles and all seem to deal with compression fit type but ...
4
votes
3answers
672 views

Is it a problem that my toilet flange is 3/8" below the surrounding tile?

My tile setter had to elevate the tiles around the toilet hole in order to make up for some unevennesses. As a result, the toilet flange is approx. 3/8" below the surrounding tile. Can that be ...
2
votes
1answer
1k views

Do I need to add a vent when moving a toilet drain across the bathroom?

In working on finishing our basement, I've come to the bathroom. It was originally plumbed with the plan of having the fixtures share a common wall (vanity, toilet, then tub). so there is already a ...
1
vote
1answer
93 views

Will the water be able to drain out of a blocked toilet?

Our toilet is backed up and water is filled to the brim but there is nothing else in the bowl. I turned off the water supply for the toilet with the little knob connected to the wall, but will the ...
1
vote
1answer
131 views

How do I measure for a toilet rough-in?

Is my thinking correct - If I measure from the wall to the bolt cap of my current toilet, which is 12", that means I have a 12" rough-in.
1
vote
0answers
160 views

How can I repair my leaky toilet?

Apparently my original toilet valves were cheap because they both had problems and I replaced both with fluidmaster valves some years ago. Two problems were apparent immediately which I solved: ...
2
votes
1answer
799 views

What can I do about a toilet drain pipe that is too high above the floor?

My toilet drain pipe protrudes about 1/3" above the floor, and makes the toilet wobbly. What can I do to fix this?
0
votes
1answer
735 views

Why won't my toilet flush right? Did our plumbers not put something back right?

We've had issues in the past about having the sewage line get backed up. We just had the plumber here almost a week ago to replace the water line. Now our toilet won't flush right. It flushes all ...
2
votes
2answers
2k views

How can I prevent the hose in the toilet tank from popping out of the tubing?

Unfortunately, I do not know the appropriate terminology but, there is a small hose that fits into a tube within a cylindrical container in the toilet tank. When this occurs, I can see initially hear ...
3
votes
1answer
540 views

Is it possible that no water running to one toilet could be from frozen pipes?

We've been in a cold snap for about a week with daily highs below -20C. The water is not running to one toilet that is near an exterior wall. To ensure it wasn't something in the tank, I detached ...
2
votes
1answer
504 views

How can I remove this toilet shutoff valve?

This valve has a slow leak, and I am trying to replace it. Problem is I can't get the thing off. I am trying to twist the compression nut (the bronze one closest to the white pipe) clockwise while ...
15
votes
5answers
16k views

Why does the shower get cold when I flush, and how can I prevent it?

When the shower is running and someone flushes a toilet, why does the shower get cold (or sometimes hot) in some houses, but not others? More importantly, would fixing that require replacing the ...
1
vote
1answer
378 views

What could cause bubbling in the downstairs toilet of an urban condo?

About 2 weeks ago, I noticed that the toilet would bubble and, eventually, the water would back up into the shower in the basement of my duplex down condo. What started out as about 12-15 minutes of ...
3
votes
3answers
26k views

How do I determine which wax ring to use under my toilet?

Other questions almost answer this question. What is the purpose of the flange on the wax ring? I can purchase a ring with or without the flange. How do I know whether to get the standard ring or ...
0
votes
3answers
40k views

Why does my toilet randomly start running?

Sometimes my toilet starts running for a few seconds at a time, like it's just finishing filling up the tank. Usually this happens when the bathtub is being drained, or when I turn on the facets in ...
1
vote
1answer
647 views

What are the different parts of a toilet seat called?

I know a toilet seat has two parts but what are they called? Can someone find me a diagram, or just tell me what the two parts are called? I think the top part is the lid...and the bottom part with ...
4
votes
3answers
2k views

Are these toilet bolts installed properly?

I had my bathroom renovated and had a new toilet installed. I noticed the white caps on the toilet screws were not secure---- looked like the contractor tried to secure them with some sort of ...
1
vote
2answers
2k views

How do I fix a slow toilet flush?

If I press the toilet handle or pour a bucket of water down the toilet, the water flows down slowly. What can I do to find out the cause of the issue along with steps to fix it. I've tried cleaning ...
6
votes
2answers
3k views

What to look for in a new/replacement toilet?

I have a slow/weak flushing toilet and it's not the tank or flapper, etc. Shirlock says in an answer to a related question, that it's "time to spring and spend 200 bucks for a new Class 5 toilet. ...
0
votes
1answer
1k views

Why does my toilet still leak after replacing the wax ring?

I just replaced the wax ring under my toilet. Now when you flush, it leaks worse than it did before! I am so confused! Is there something else that needs to be replaced?
4
votes
1answer
279 views

Can I connect a drain for my new washing machine to an existing toilet drain?

I would like to add a wash machine to the basement. Near the area of the basement where I'll be adding it is a 4 in drain coming from an upstairs toilet. Can I tap the new drain into the toilet ...
1
vote
3answers
11k views

My toilet is filling very slowly with a Fluidmaster valve, how do I fix it?

My toilet is filling very slowly. Sometimes it sounds like it is filling up a drip at a time. What's wrong with it and how do I fix it?
3
votes
2answers
2k views

How to fix broken toilet flange from over tightened bolt?

I broke my PVC toilet flange when I over-tightened the bolt used to secure the toilet to the flange. How do I fix this without replacing the entire the PVC fitting? This PVC flange is glued to the ...