1
vote
2answers
49 views

How do I remove Cement Board that has been screwed in and is bonded to wood subfloor with thinset?

I am in the process of purchasing a townhome and I am looking to tear up the existing 12" ceramic tile that covers the entire main level... an area close to 600 sq. ft. to make way for laminate ...
2
votes
3answers
149 views

What is a proper high-quality sub-floor preparation for porcelain tile floor installation

I am preparing to do a kitchen remodel where I am replacing an existing tile floor with a new porcelain tile floor. The old floor that is being replaced has several areas where it is not level and ...
4
votes
3answers
792 views

How should I install a plywood subfloor that will be covered by granite tiles?

I am replacing my entryway floor and I have removed the old mud bed. I'm left with planks perpendicular to the joists. However the room is defined at a 45 degrees angle from the joists, so the planks ...
3
votes
2answers
374 views

Is it feasible to cover low-pile carpet with a 1/4" subfloor and vinyl tile in a kitchen?

Scenario: I'm the owner of a multi-unit 2 story apartment. The people living up and down are cousins to each other and are in the process of switching apartments -- long story, don't ask. The upstairs ...
4
votes
2answers
380 views

Should I remove nailed-down plywood before laying tile?

In my bathroom there is vinyl on top of plywood, which is nailed to the sub floor. Should I pry up the plywood before putting down cement backer board for tile, or can I go over the plywood?
2
votes
2answers
681 views

Should I apply waterproofer on the subfloor beneath a shower pan?

I'm going to be using the Kerdi shower pan and membrane to seal a steam shower. I understand the process of installing the membrane, deck and preparing the wall and ceiling substrate. This question ...