1
vote
1answer
40 views

How to level bathroom plywood subfloor before tiling?

In a bathroom remodeling project, I noticed the newly installed plywood sub-floor is flat but not level, which may cause issues when installing the shower and the sink cabinet (water evacuation and ...
1
vote
3answers
157 views

How do I level a sloping floor that has been tiled?

We have a large room that we want to use as a bedroom and it has been tiled, over a concrete slab. On further inspection we now realise that there is a slope of approximately 5cm from one end of the ...
1
vote
2answers
161 views

How do I tile over a leveled floor with a feathered edge?

I have a laundry room in a home I just bought which had some unseen water damage. They originally had the sticky vinyl tiles on there which I pulled up. The concrete underneath was pitted and uneven. ...
5
votes
2answers
6k views

Should I use self-leveling concrete or mortar to level a patched area of concrete prior to tiling it?

I had to repair cast iron pipe in the basement. This left me with a 2ft x 3ft hole in my tiled basement floor. We cut along the grout lines, so I just need to replace the tile and concrete. Well, ...
1
vote
1answer
251 views

How can I smooth a seam between cement board?

I have a joint between two sheets of cement board that forms a small ridge elevated maybe 1/8" relative to the centers of either board. I was wondering if extra thinset on both sides can be used to ...
6
votes
3answers
13k views

Can I use leveling compound between plywood and cement backer board?

I'd like to install slate tiles over a pre-existing plywood floor. The plywood floor is 3/4" and sits on joists. There's a dip about 3/8" deep by 2 feet wide by 5 feet long. My plan was to fill it ...