1
vote
3answers
96 views

How do I level a sloping floor that has been tiled?

We have a large room that we want to use as a bedroom and it has been tiled, over a concrete slab. On further inspection we now realise that there is a slope of approximately 5cm from one end of the ...
2
votes
1answer
64 views

What kind of thinset should I use on porcelain?

I found some porcelain tiles that look like the wood planks, they are 6x24 and I am having trouble figuring out what kind of thinset and trowel I should use.
1
vote
1answer
71 views

Do I have to replace backerboard before tiling a floor?

We recently pulled up the vinyl in our bathroom to discover that there is backerboard underneath. It is in good shape but has a thin layer of glue on parts. The surface is completely smooth. Can I ...
1
vote
2answers
120 views

How do I tile over a leveled floor with a feathered edge?

I have a laundry room in a home I just bought which had some unseen water damage. They originally had the sticky vinyl tiles on there which I pulled up. The concrete underneath was pitted and uneven. ...
0
votes
1answer
522 views

Laminate to tile transition [duplicate]

I am laying my floor but I have a transition that I need help with, I am going from laminate to tile but the tile is much bigger. I have attached a drawing of the 2 different materials and I am ...
0
votes
0answers
23 views

Commercial flooring tile finish/glaze

I just did the floor of my little indoor storage with commercial flooring tiles from the Home Depot (Armstrong brand). But I feel the finished look does not look as smooth as what appear to be the ...
0
votes
1answer
150 views

How do I clean paint and glue from bluestone?

I have Bluestone interior floors in new construction. Ready to finish but slight paint overspray and several glue spots. Is there a problem using a diluted muriatic acid to clean?
1
vote
0answers
70 views

What is the sandy substance underneath my old ceramic tiles and what preparation should I do before installing a new one?

We are removing old ceramic tile from a cement floor. There is a sandy substance underneath. Do I have to remove the cement or can I just sweep this substance off and continue installing ceramic ...
3
votes
2answers
641 views

Can I put tile in my basement over Ditra and existing mastic?

My basement has been prone to getting water for many years before I bought the house. We're having the basement walls repaired (excavated outside) & sealed. So this problem should go away. The ...
4
votes
3answers
1k views

How should I install a plywood subfloor that will be covered by granite tiles?

I am replacing my entryway floor and I have removed the old mud bed. I'm left with planks perpendicular to the joists. However the room is defined at a 45 degrees angle from the joists, so the planks ...
3
votes
1answer
95 views

How do you seal travertine floors?

I moved into a house with travertine floors. They appear to have been sealed and polished. I recently learned that travertine is highly porous. I recently noticed this tile where the seal appears to ...
3
votes
1answer
1k views

Should I use underlay when tiling a bathroom?

Recently I had a water leak in the bathroom. I noticed water spilling out from the tiles grouting and I removed them to prevent any more water penetration. I noticed that the following layers have ...
2
votes
1answer
125 views

Which tile cutter to use for commercial flooring tiles?

I am putting (vinyl?) commercial flooring tiles in one of my hallways. The product I've seen one guy (pro) use at a supermarket once was this: Now, that baby is $200+. I was wondering whether the ...
4
votes
1answer
1k views

How do I install carpet tiles in a below grade room?

A few years ago, I saw an advertisement for carpet tiles that had a jagged edge so there would be less movement in the interlock between tiles, and prevented the need for glue. (would like to find ...
4
votes
1answer
270 views

Will this floor tile break?

So, I've got some 12"x12"x1/4" tile laid over a concrete floor. I'm cleaning up between the tiles getting ready to grout and I notice I can see some concrete between and underneath (the small amount i ...
6
votes
3answers
12k views

Can I use leveling compound between plywood and cement backer board?

I'd like to install slate tiles over a pre-existing plywood floor. The plywood floor is 3/4" and sits on joists. There's a dip about 3/8" deep by 2 feet wide by 5 feet long. My plan was to fill it ...
5
votes
3answers
737 views

What preparation is required for tiling over poorly laid floor boards?

4" hardwood floor boards mounted on a poorly-designed frame made out of whatever wood the constructor had lying around it seems. There's a lot of bounce, some boards even drooping 1/2" when walking on ...
12
votes
1answer
991 views

Where should the floor transition from tile to carpet go?

I have 2 rooms planned, one will be tiled and the other will be carpeted with a door opening between them. Where should the tile stop and the carpet begin? In the figure below I have 3 different ...
1
vote
1answer
395 views

Do I need to do more prep work on this cement floor before putting in new tile?

In my basement i have a poured concrete floor, and we're re-doing the bathroom down there. It used to have Vinyl flooring, and we ripped it all up. The top vinyl part came up easily, but it left a bit ...
3
votes
1answer
6k views

How do I fill a wide gap between tile and other flooring / sill plate?

I recently installed 16" porcelain tile in a new laundry room addition. As luck would have it, the room ended up being the same width as 4 tiles, so I had to do very little cutting to complete the ...
5
votes
2answers
14k views

How do I make where my carpet meets tile look nice?

We've recently replaced our kitchen tiles. I pretty happy with the results but have no idea what to do with the edge. How do I clean this edge up so that it looks more appealing?
2
votes
2answers
2k views

Do I need to put mortar between wood and backerboard on a mixed wood/tile floor?

We have a hardwood insert on our kitchen floor and we will be surrounding it with slate tile. Also the room next to the kitchen is all hardwood floor. Our heights are correct for the tile (with the ...