1
vote
2answers
91 views

When installing backer board for wall tiles, do the screws need to be absolutely flush or even pushed into the backer?

I'm asking because some screws will not go in fully flush. But I'm thinking the layer of thinset then tile will surely cover any screws that aren't flush, so tiles won't 'pop' out.
0
votes
1answer
195 views

CertainTeed DiamondBack- Waterproofing needed for tile?

I picked up some DiamondBack CBU to tile a shower enclosure, as it seems like it would be a lot easier to work with than Hardibacker (I can't cut the stuff without making a huge dusty mess, so if you ...
1
vote
1answer
79 views

Do I have to replace backerboard before tiling a floor?

We recently pulled up the vinyl in our bathroom to discover that there is backerboard underneath. It is in good shape but has a thin layer of glue on parts. The surface is completely smooth. Can I ...
8
votes
2answers
12k views

Should the backer board be in front of or behind the tub flange?

I'm installing a new bath tub and shower. I've removed the old tile down to the studs. Should the backer board be in front of or behind the tub flange? I put it on the rear tub wall from floor to ...
5
votes
1answer
4k views

When tiling a shower surround, how do you transition from backer board to greenrock?

I am remodeling a bathroom and have done demo down to bare studs. I am going to tile the bath tub (with shower) up to about 6 ft, and one wall will have tile up the wall 4 ft high. I am planning on ...