The tag has no wiki summary.

learn more… | top users | synonyms

9
votes
2answers
3k views

How can I remove stuck anti-vandal rings in tap head?

Most of the taps in my new house are fitted with so-called "anti-vandal" screws in the tap heads, as shown in the image. These screw into the tap head to tighten them onto the stem. I can't remove ...
6
votes
1answer
3k views

Can I oil a squeaking tap?

I have a tap with one handle for hot and cold water (not sure how to call it, it looks like the picture) It worked good for about 2.5 years. But now, its handle became hard to turn and it makes ...
6
votes
3answers
833 views

How can I determine what is in my water?

My question is, how can I determine exactly what these "floaties" are that I see in my drinking water? I know that I sound crazy and more than a little obsessive-compulsive....my wife tells me this ...
5
votes
2answers
1k views

Are either of these tools suitable for tightening the pipe union nut underneath a bath?

I'm having trouble tightening the pipe union nuts on some new bath taps I've fitted at my mum's house. I got everything out OK, and (because the previous plumber had put the hot tap on the right ...
4
votes
2answers
2k views

How can I replace a non-standard (20cm) bathroom faucet?

The bathroom sink has a separate cold and hot tap, their centres are 20cm apart. I want to replace them with a mixer tap. However, the mixer taps I see have 18cm distance. What are the options for ...
3
votes
5answers
558 views

How can I fill a large container in a shallow sink?

I'm moving into a dormitory building and the bathroom sinks are very shallow. I want to be able to pour water into my Brita water filter but it doesn't fit beneath the tap. I was thinking of getting ...
3
votes
1answer
3k views

How to stop a whistling hot water tap which also has a mind of its own?

The hot water tap in my kitchen whistles quite loudly when it is in a certain pressure range -- at very low and high pressures it is fine, but within the sweet spot it whistles away. It also seems to ...
2
votes
2answers
539 views

Will having reversed hot and cold damage my faucet?

On our old kitchen tap handles, the cold is on the left side and hot on the right. The new taps are the exact opposite, cold being on the right and hot on the left side. Is it okay to just connect ...
2
votes
1answer
446 views

How can I repair this broken bathroom tap?

So we had a bathroom tap that looks pretty much like this: the red lines I drew are where the tap has a kind of screw joint that separates the head from the side hot/cold taps. The problem is the ...
2
votes
1answer
403 views

How can I determine what type of washer/gasket to use for an antique shower?

I have an old home (built in 1760). One of the beloved features is the clawfoot tub in one of the bathrooms. The shower assembly leaks from the shower head and my attempt to replace the gasket/washers ...
2
votes
1answer
535 views

What could cause a tap to flow well, then spurt?

I fitted a new tap to a sink, single cold water tap. When I first turned it on the water ran fine. If I open the tap further, the water flow becomes jerky with constant gaps in the flow. Is this the ...
2
votes
0answers
502 views

Why does my bath faucet drip for a few minutes after it's shut off?

I have a traditional two handled (one hot and one cold and they are separate) bath faucet. I recently had it reseated and the washers replaced, however, what I noticed was that immediately after shut ...
1
vote
1answer
81 views

can I put a single mixer tap in a basin that has 3 holes?

Can I put a single mixer tap in a basin that has 3 holes? I've just bought a basin that has 3 holes. Can I put a single mixer in the centre one and plug the other 2 holes? I notice that the centre ...
1
vote
1answer
48 views

How can I stop a dishwasher water supply from causing the tap water to smell?

OK, here is the situation: I recently bought a dishwasher that has a shorter water hose than required. So I bought this inlet hose and connected the two hoses using this inlet connector. For water ...
1
vote
0answers
116 views

How can I dismantle this shower tap?

The shower tap in the picture is, I think, a Hudson Reed shower control, similar to this one Can anyone tell me how I can dismantle this as it is leaking and presumably needs a new washer? Also, I ...
0
votes
1answer
55 views

Tighting taps under kitchen sink doesn't cut off water supply

I have a set of taps similar to these under the kitchen sink that lead to a single mixer tap. My issue is when I try to turn off the water supply via these (trying both directions) it still flows ...
0
votes
2answers
541 views

How do I shut off the water to my apartment?

I live in a unit in Sydney Australia, I am trying to figure out how to turn off my water so that I can replace the washers on the taps in the basin. Is this possible so that I don't disturb my ...
0
votes
0answers
93 views

Why does my outdoor tap have a diameter of 1-1/4“ inches, not the standard 1”?

The outdoor tap for the front yard of our house has an outer diameter of 1-1/4" inches, so it is useless for attaching a garden hose. A standard tap is more like 1" in diameter. My question is: Why? ...
0
votes
1answer
45 views

How to attach this tap cover?

The cover of my bathroom's tap always goes away. I find the system quite silly because you have to remove it to access the screw inside if necessary yet it's glued on it! Anyway what solution/product ...
0
votes
0answers
2k views

Adjusting a Mixer Tap Hot/Cold Mix

I have a Twyford mixer tap on my bathroom washbasin (Exact model here). As it stands the Hot/Cold mix I can get out of it is either very hot or very cold, with a tiny area in the middle giving a ...