Electrical device used to open and close an electric circuit.

learn more… | top users | synonyms

2
votes
1answer
65 views

Can I install a dimmer switch on a 2 way circuit?

I have a 6 lights controlled by 2 normal switches (2 Way Circuit). I want to replace one of the normal switches with a dimmer switch. Is this possible?
0
votes
0answers
19 views

Install one dimmer switch which is part of two regular switches

We're purchasing (5) dimmable LED's for the kitchen and I'm now researching the dimmable switches. The lights are controlled by two switches. Either one can turn off or turn on the lights (So one ...
1
vote
1answer
37 views

Is this a valid layout for a stairwell light?

My pair of lights and pair of switches was working in my basement stairwell. I'm redoing the wiring because I added more switches but I can't get the stairwell lights working again. The only thing I ...
0
votes
1answer
76 views

12v Led Wiring Problem

I have 2 strips of approximately 200 LEDs in each strip. From the power source I run the negative to the negative on each strip and the positive to a switch. From the switch I run to the positive on ...
1
vote
1answer
34 views

Multiple wall switch wiring issue

I am replacing wall switches and unfortunately did not label the wiring before removing. I also changed 2 outlets that were switched on the bottom and always live on top to always live. Wires 2W ...
2
votes
2answers
48 views

How do I install an insteon light switch where wire colors don't match?

Electrical noob here. I know enough to turn off the breaker. I've read a couple of other answers and want to get a second opinion. I have three wires coming out of the existing switch socket, 2 ...
0
votes
1answer
90 views

Can I change a switch within a circuit from powering multiple lights to a single light?

I have a family room ceiling fan connected to a single pole light switch. However, that switch also controls a bathroom light, staircase light and a bedroom receptacle. There is only 1 cable coming ...
0
votes
1answer
29 views

tapping power from a 3 way switch to an adjacent 2 way switch

I have a ceiling fixture that is controlled through 2 3-way switches (power comes from the fixture not to one of the switches). in the same room, there is a set of wall light fixtures that are tied ...
5
votes
2answers
5k views

Can a low voltage light switch be located in a closet as opposed to outside the closet?

Okay you guys I have next question. And like all good questions this one begins with a story. I was reading the post about a nick in a wire and read a couple of you mention that light switch in a ...
2
votes
1answer
59 views

How do I make two wall switches work in coordination, wirelessly?

I remodeled my kitchen and added under cabinet lighting. The under the cabinet lights are controlled by a wall switch on one side of the kitchen. The overhead recessed can lights have a switch on ...
1
vote
1answer
37 views

Turning light on turns power to fire alarm off

I have a ceiling fan connected to a two way switch. When I turn the ceiling fan/light on, the power to the hard wired smoke detector is cut off, whereas turning the fan/light off returns power to the ...
4
votes
1answer
143 views

Why would a replacement 3-way light switch cause the other switch to no longer work?

I just attempted to replace an existing three way switch (two switches controlling the same light), with one of these I hooked up the cables in the same way as on the old switch. The new switch ...
2
votes
1answer
58 views

What is this electrical junction box? (re: adding 3-way switch)

I'm trying to replace an existing switch (at the top of the basement stairs) with a 3-way switch by adding an additional switch at the bottom of the basement stairs. The existing switch box has 4 ...
0
votes
1answer
24 views

How do I add an electrical switch to a series of lights from an additional doorway? [duplicate]

My basement shop has been fully wired to operate by one power switch. I would like to add another switch to power up the shop by entering from another door.
2
votes
1answer
41 views

Why would the documentation say to wire a pole of the 3-way occupancy switch to ground?

I'm currently wiring up an occupancy sensor to a 3-way switch, I'm leaving one of the mechanical switches in place, and here is the wiring instructions. according to the instructions I need to wire ...
0
votes
1answer
60 views

Repurpose light switch to control surge protector?

I have a lone light switch lying around and thought it would be cool to use this switch to turn on/off a surge protector instead of the smaller switch on the surge protector. Can this be done? The ...
1
vote
1answer
73 views

How do change the wall switch for my ceiling fan from a variable fan/light combination to a single on/off switch?

I used to have a ceiling fan/light combination that was controlled by a wall switch the controlled both the fan speed and dimmed the light. I bought a new fan/light that is controlled by a remote ...
0
votes
1answer
219 views

Wiring a switch to (2) pendant lights, a ceiling fan (all new)

My existing is I have no ceiling lights or fan. I mounted two pendants and a ceiling fan that has a light. The only switch is one that controls the upper outlets so lamps can be used (which I ...
3
votes
1answer
150 views

How can I combine two switches on two circuits on 1 timer switch?

I just purchased my first house (new construction) and I got tired of remembering to switch the outdoor lights on/off every day. So, I got a Honeywell solar econoswitch, which is essentially a timer ...
8
votes
1answer
37k views

Is it normal to have a light switch setup using only the hot wire?

I was changing the light switches around the house when I came upon this setup. The two switches to the right are all wired using the hot wire (black) from the two electrical wires on the back panel. ...
0
votes
1answer
53 views

Removing light switch but keeping the power

I have a three switch outlet on my living room wall. the leftmost switch was to a can light above the mantel, the middle to the fan portion of the fan and the right to the light portion of the fan. ...
0
votes
1answer
134 views

Occupancy (motion) switch wiring question

I have a single-pole light switch that I want to replace with a motion-detecting occupancy light. It is a Leviton Motion Sensor, # IPS02. When I removed the old switch, I noticed that the switch only ...
2
votes
1answer
69 views

Why does my garbage disposal have a 3 way switch?

In my house I have what seems to be a plain two wire + ground flip switch for the garbage disposal. I need to replace the switch because we added backsplash tiling and want to better match the color. ...
0
votes
0answers
17 views

New ceiling fan installed, lights are blinking when I turn the fan off

I just made settlment on my house on Friday and I just had a Hunter ceiling fan installed with a new controller plate as well. All of the wiring was intact to install the fan, the original owners took ...
4
votes
1answer
32 views

Would this be the correct way to add a timer switch to an existing fan with thermostat?

We have an existing 120V AC exhaust fan wired to simple inline attic fan style thermostat. We would like to add a timer switch so the fan could be manually turned on as needed. Would this be the ...
1
vote
0answers
36 views

Roadblock installing 4-way switch

I've been trying to install a four way switch setup for a ceiling fan using a Leviton z-wave control switch and two matching remotes. I've attached a copy of the wiring as it is currently set up. I'm ...
0
votes
2answers
154 views

How should I fix an electric shower pull cord that doesn't work anymore?

The red light on my pull cord electric shower no longer comes on, hence it doesn't work. However, there was a brief period yesterday where it worked suggesting it's an electric fault and can be fixed? ...
2
votes
2answers
568 views

Random light switch behavior

I have a light switch on my bedroom closet that exhibits erratic behavior: about half the time when the switch is flipped from off to on, the light remains off. Flipping the switch back off and on ...
3
votes
1answer
81 views

How can I replace a single pole light switch with Z-Wave light switch?

I'm trying to replace a single-pole switch with a z-wave switch. I'm new to electrical stuff, I understand a little of the terminology just from reading the black & decker wiring book. I turned ...
2
votes
1answer
40 views

How do I find out the correct pre-charge air pressure for my captive air water tank?

I have a Sears captive air water tank (model No. 390.29171) that stores water pumped from the well. When we took possession of the house, there was no water in the tank or lines, the water pressure ...
3
votes
3answers
228 views

Trying to understand why a light would be wired this way?

Just moved in to an older home with fiancé and WAS planning to change out a light fixture with a new ceiling fan. However after turning off light switch and breaker and proceeding to remove light ...
0
votes
2answers
57 views

Trying to Replace 3-Way Light Switch

I'm aware that the WeMo light switch does not work as a 3-way switch, but I had purchased it before opening up the existing light switch plate and understanding the wiring I would work with. Anyway, ...
1
vote
4answers
4k views

When I turn on my light switch, there is a delay before the light comes on

We have a ceiling fan light. One swith controls the fan, the other the light. When I turn on the light switch, there is a noticable delay (like a full second) before the light comes on. Is it a ...
0
votes
0answers
28 views

Belkin WeMo switch short circuit: Is it the neutral wire?

I successfully connected a WeMo switch to the front porch, replacing a single pole switch. The neutral wire in the box had been capped, and I connected it to the neutral on the switch. All is working ...
0
votes
7answers
7k views

Is there a motion sensor light switch that does not need ground?

My house was built in early 1950's and all electrical switches do not have a ground. This was found out with an electrician when I asked them to install Lutron Maestro, but it would not power on since ...
2
votes
2answers
104 views

Why does my new switch keep tripping the breaker?

I am attempting to enable a light switch in a bedroom that had the wiring but had no ceiling light fixture and no switch (just a blank plate). However, I am running into an issue and I want to seek ...
2
votes
1answer
208 views

how can i set up dusk to dawn outdoor lighting ?

My digital in-wall electric timer will only work with a single pole configuration. My wiring currently has 2 switches/poles. The simplest option is screwing in an electric eye automatic light control ...
2
votes
1answer
104 views

How can I add a 3-way switch to my light? (confused about existing wiring)

I'm trying to install a 3-way switch for a specific light but I'm not sure how to do the wiring. The existing switch box has quite wires inside: 3x 12-2 1x 12-3 The hots (black) are all tied ...
2
votes
1answer
155 views

I ran into two hot lines when replacing a three way switch

I've read up on three way switches, and have replaced a few over the years. I recently installed a bathroom fan, and so had to replace two three way switches. Very simple setup - two switches, one ...
2
votes
2answers
44 views

How do I fix a light switch timer?

I have some auto-light switches in my home. The one in the image below has nothing in the LCD display and is non-operational. How do I fix that? Manual operation does not work either. Below the ...
5
votes
4answers
2k views

Concerns about replacing a worn out light switch

Our home is about 3 years old. New construction. New parts. The main lights in the kitchen are a 4-way circuit (3 switches, + lights). Since we primarily come into the room from one side, one ...
1
vote
1answer
71 views

Remote Triggered Switch for a Water Heater socket

I have a Water Heater ( 3 kW; 220 V; single phase) situated in one bathroom that has plumbing to service two bathrooms. Currently it is connected to a local wall outlet (15 Amp) in Bathroom-1 with ...
3
votes
3answers
85 views

Is this a “switched neutral” situation?

Replacing switches with new ones and wanting to add a zwave dual-relay while I'm at it. It's a 3 gang box and all are on the same circuit. I have an electronics background, but no electrical ...
1
vote
2answers
103 views

Why is my switch controlled receptacle always on?

I replaced the outlets and switches in a room. One outlet now has constant power, the switch no longer turns the power on and off (to control a lamp for example) as it originally did. For ...
1
vote
1answer
1k views

How can I eliminate one 3-way switch to leave just one switch on the lighting circuit it's on?

I have two sets of lights in my kitchen. At one end of the kitchen, I have a 2 Gang light switch which operates both sets of lights, and at the other end I have a single light switch which operates ...
0
votes
1answer
22k views

Why would a light switch be wired with the neutral wire?

I'm having trouble installing a WEMO wall switch. The light I want to use it on is a single on/off switch, not a 3 way switch. When I remove the face plate, the neutral wire is wired to the light ...
0
votes
1answer
59 views

Old Wiring to New Light Fixture With Switch

I bought a new light fixture to replace an old outdated light-bar the bathroom of my apartment. The building was constructed in 1926 so everything is super old. When I took the old fixture down, I ...
1
vote
1answer
18 views

Occupancy sensor immediately off after on

I attempted to install a Lutron 2 AMP occupancy sensor this weekend, replacing a simple single-pole switch. Installation seemed to be straightforward enough. However, when the time came to test it, ...
1
vote
0answers
34 views

How do I wire multiple light fixtures on their own switch on a Modular wall?

I have a wall that will be used to display vanities. This wall needs to be able to move around and hold 3 light fixtures. Those three fixtures each need their own switch. My thought was to install ...
1
vote
1answer
136 views

Why is my kitchen ceiling light not turning on with the light switch?

My kitchen light is not turning on with light switch, I checked it with a two wire light gadget and when I stick them in a electrical plug socket I get a bright light on the gadget, when I touch the ...