1
vote
4answers
344 views

Installed Ceiling Fan, Now Light Switch Not Working Properly

Last night I switched a ceiling light fixture with a Ceiling Fan. Before it was just a light fixture and it was controlled from a switch on the wall; one of two switches on the same switch plate/panel ...
0
votes
3answers
477 views

2-wire switch loop controlling 2 outlets - replacing with 3-wire to fix?

I am in nearly this exact situation: Can I use a switch loop to power a ceiling fan? We are trying to install a fan, but instead of having a single duplex outlet on the same wall as the switch, we ...
0
votes
0answers
725 views

how to wire two three way switch to a ceiling fan & add one switch for the fan and one for the light

I have two three way switch when I'm closing one of them switch , the fan is automaticly close with the light & I hate that because it's a big place & I'm short so it's hard for me to grab the ...
1
vote
1answer
202 views

Can I use a switch loop to power a ceiling fan?

Need your help, please. I have a single pole switch that controls the wall’s receptacles. It has one 14/2 cable, white/black/ground, where the white is hot. I would like to install a ceiling fan. I ...
2
votes
2answers
102 views

What is the longevity of a three speed ceiling fan switch?

I have a three speed ceiling fan that came with my house. It's about 14 years old now. It's never given me problems but right now it won't turn off. The four position wall switch (Off-low-medium-high) ...
5
votes
1answer
2k views

What type of wire should I run when updating a ceiling fan?

I started to change out my ceiling fan and noticed the support brace is actually laying on the drywall and not firmly attached to a beam. I also noticed the new fan has a blue wire where the wiring in ...
1
vote
1answer
3k views

How do I know if a ceiling fan with light and the switch are wired correctly?

There was a old ceiling fan with light and remote in a bedroom of my house that didn't work. It also had a switch with 2 knobs that pushed in and turned labeled motor control and 300 w perm instld ...
2
votes
1answer
359 views

Ceiling Fan - Single Switch, but Dual Switch installation

I have a two switch plate & installed a ceiling fan using dual switch instruction (white/white, black/ungrounded, blue/ungrounded). Fan & light work fine from one switch, but I learned second ...
2
votes
1answer
877 views

Rewiring A Ceiling Fan - Add Wall Switch

I have ceiling fans in four rooms all with lights. The fans are hardwired to the breaker box, but the lights are on switches. I'd like to add another switch to control the fan, either on/off, or a ...
9
votes
5answers
12k views

Should I put a dimmer switch on a ceiling fan?

I have a ceiling fan on our bedroom's vaulted ceiling. Since we don't want 7' pull-cords, the speed is stuck at full-tilt, which is no good. The fan has separate switches on the wall for lights and ...
0
votes
1answer
2k views

Why does my ceiling fan turn itself on at night?

We have a ceiling fan with three lights that came with the house, and that is operated by an electronic switch driven by a 9V battery and with 5 buttons: Hi, Med, Lo, Off (for the fan) and Light (a ...
0
votes
1answer
1k views

Why isn't the switch working to turn off my ceiling lamp after I replaced a fan w/light?

I have properly connected the new ceiling lamp. Once I turn the breaker on again, the lamp turns on immediately. There is a double switch on the wall. One used to turn on a standing lamp on the corner ...