I just bought a house built in 1978 and I'm planning on putting tile in the bathrooms (currently linoleum). The fixtures are removed and the flooring under the linoleum is particle board. I think ...
I'd like to install laminate floor on top of Delta FL in my basement. The basement slab is not level, it slopes (from all directions) towards a floor drain (that, via a pipe, leads to a sump pump) ...
I am preparing to do a kitchen remodel where I am replacing an existing tile floor with a new porcelain tile floor. The old floor that is being replaced has several areas where it is not level and ...
Mike Holmes is a big fan of OSB/plywood over 1" XPS for basement floors, though his book leaves something to be desired in terms of details. His book says: ...on top of the foam, you want to have ...
In a bathroom remodeling project, I noticed the newly installed plywood sub-floor is flat but not level, which may cause issues when installing the shower and the sink cabinet (water evacuation and ...
Recently moved into an older house (1950s built) and noticed that the coat closet has a musty smell. The coat closet is next to the front door and has one wall that is an exterior wall. It has ...
As part of finishing my basement I'll need to rebuild these stairs to account for the higher floor level. The back of this stair case is currently open to the lower basement, but that will be getting ...
We recently purchased a new washer and dryer set. It's a High Efficiency front loader washer with the high speed spin cycles. It's causing us grief. It vibrates like crazy. To the point where it's ...