Structure above the floor joists and below any finished flooring.

learn more… | top users | synonyms

0
votes
1answer
41 views

How to flatten an uneven plank subfloor when the existing planks can't be removed?

The upper-floor master bedroom in my c. 1700 house has a plank floor laid across the joists which is quite old, if not original. The planks were apparently once 1/2", but in some areas of the room ...
2
votes
2answers
547 views

How should I install flooring over fresh concrete?

I have fresh concrete poured in my basement. Planing to use Metrofloor Engage Select vinyl plank for most of the floor. Contemplating ceramic tile for the bathroom if vinyl is not good enough for ...
3
votes
2answers
274 views

What type of subfloor should be used for Engineered hardwood flooring installed on grade concrete slab?

I would like to install engineered hardwood flooring over a concrete slab which is on grade. It is the first floor of the house, there is no basement and the house was built in the 1990's. I have seen ...
1
vote
1answer
123 views

Can I install T&G Bamboo floor over a sagging subfloor?

The subfloor dips about an inch on one axis across the middle of the room. Structurally, I think this is due to old and rectified foundation issues. Since the dip is just 1-dimensional, can I install ...
5
votes
2answers
16k views

How should I prepare a plywood subfloor for vinyl sheet flooring?

I'm planning on replacing the carpet in my dining room with a vinyl sheet flooring. I know I need to get the carpet, padding and any staples/debris cleaned up before laying the vinyl, but do I need ...
2
votes
2answers
1k views

Installing subfloor and hardwood on top of concrete (2nd story)

I bought a condo in a triplex where I have all of the 2nd floor. Most rooms are on hardwood, while the rest is on laminate with a serious height difference of an inch and a half (hardwood being ...
4
votes
4answers
167 views

How to support the subfloor around a toilet between I joists

I'm replacing some rotted subfloor around a toilet, and I want to add blocking around the flange for extra support, and to give me a place to support the new pieces of subfloor (I'm not planning on ...
0
votes
1answer
24 views

Increasing subfloor thickness under new shower pan

I ripped my old shower down to the studs and joists. The studs were rotten, the subfloor was rotten, and the top of the joists (in some places) were weak and rotten. I plan on replacing some studs ...
2
votes
1answer
61 views

How should I fill in pits in a concrete floor so I can install laminate?

I have these holes in the concrete floor, and I want to install laminate floor. What can I do to fill in these holes to get a nice level surface.
0
votes
1answer
67 views

What type of subfloor should be used for on grade for nail down engineered hardwood?

I am ripping up tiles on the ground floor of my home and would like to install 1/2 inch engineered hardwood. It is over a concrete slab on grade. What is the best and most economical way to do this ...
0
votes
0answers
22 views

replacing subfloor

How does one replace the sub floor? I will redo the bathroom and need to get to the pipes under the sub floor. This is the first layer of flooring... so it is installed before the walls went up. ...
0
votes
1answer
31 views

Secure subfloor underwall between joists

I jumped to quickly into cutting out subfloor in my bathroom and I am now trying to figure out how resolve the issue and get the new plywood in place and secured properly. I cut the sub floor to as ...
2
votes
2answers
2k views

What kind of screws are used for plywood subflooring?

I have removed the old bathroom lino and cleaned the parts that adhered to the floor. I want to screw down the existing plywood subfloor because the nails are old (45yrs) and sparse. What kind of ...
1
vote
4answers
132 views

How to remove tar left over from old floor carpet?

Redoing bathroom floors and under the tiles there was really old carpet. I was able to remove the upper layer of it, but there is a tar-like substance stuck on the wooden floor that is very difficult ...
2
votes
0answers
33 views

Are there any things to consider when putting thick rubber underlayment down?

I am finishing my attic and have just completed laying the OSB subfloor. I plan to use this space as a yoga studio for my wife / guest room for family / playroom for my child. It is directly over my ...
2
votes
2answers
127 views

How can I level and finish a slanted deck that was enclosed?

Hello everyone I am new to this so I apologize if I seem a little slow mentally. I have a 104 yr old home that at one point had a deck that was completely enclosed. my issue is that the floor was ...
2
votes
0answers
34 views

Stripping parquet floor glue to install underfloor heating

We have a huge lounge in our new house (in the UK) and it is covered with parquet flooring which we dislike. The little wooden blocks are starting to work loose here and there, so I don't see it as ...
3
votes
1answer
54 views

Is a leveled wood frame for a basement floor a good idea?

Just bought an old house. One half of the basement has a nice headroom. The floor is painted concrete, and is pretty uneven and ultimately slopes towards a floor drain. I'd like a nice floor. Can I ...
1
vote
2answers
2k views

Should I replace bathroom OSB subfloor with plywood?

Before we begin, English is not my first language so my terms could be a bit wrong. Considering I'm planning to install 1/4" concrete backer-board over the sub-floor before tiling it again, is OSB ...
6
votes
1answer
4k views

Is it safe to use screws in subfloor-to-joist connection to eliminate floor squeak

Getting ready to have some hardwood (12mm laminate, technically) installed in our dining room, and in preparation for this, I bought some 1.25" stainless steel screws that I'll be putting down through ...
3
votes
2answers
163 views

Does it make sense to put quality (=pricy) underlayment over 3/4“ subfloor+1/2” extra plywood layer?

I have standard subfloor + 1/2" plywood on top, to correct for joists going different directions, so that all hardwood boards can be laid one direction for a clean look and avoid sagging where they ...
3
votes
2answers
950 views

Is it feasible to cover low-pile carpet with a 1/4" subfloor and vinyl tile in a kitchen?

Scenario: I'm the owner of a multi-unit 2 story apartment. The people living up and down are cousins to each other and are in the process of switching apartments -- long story, don't ask. The upstairs ...
0
votes
0answers
30 views

DMX underlayment or DRIcore?

I've seen some great reviews of the underlayment like the DMX one step, but I see a lot of people still using the padded OSB product like DRIcore. Is there any benefit to using the DRIcore type of ...
1
vote
2answers
78 views

HELP! Upgrading my kitchen to ceramic tile floor

So, I've decided to take on this big project. I have a 1/2" plywood subfloor with 3/4" MDF on top. Should I rip out my entire subfloor add a 3/4" t&g plywood then lay 1/2" plywood on top or am I ...
0
votes
1answer
46 views

Additional Subfloor Layer - Glue or Red Rosin Paper

Currently my main level subfloor is joist, 1/2" plywood, then 3/4" partical board. I am in the process of replacing the partical board with 3/4" with Oriented Strand Board Tongue and Groove. After ...
2
votes
3answers
73 views

Is this the correct approach for installing 3/4" Hardwood floor?

So I've been thinking of adding a hardwood floor in my dining room and hallway. This is what I know as of right now. I have Hemlock 2x10 Floor Joists spaced apart 16" OC that span 13 feet and the ...
1
vote
2answers
56 views

Misaligned floor joist hangers

What is the best way to resolve an issue with misaligned floor joist hangers? Our flooring in the kitchen is starting to dip and sag and it is directly related to the fact that the floor joists are ...
4
votes
1answer
14k views

How to properly install tongue and groove plywood subfloor?

I'm doing a remodel and can't seem to find the proper method for installing the tongue and groove plywood subfloor over joists. I mean, I think I pretty much understand how to do it but there are a ...
3
votes
1answer
85 views

How high can a 'sub floor' be raised withh plywood sheets?

Re-tiling the entryway to my home and had to remove the old mud floor that the old tile had been laid on top of. This lowered my floor by approximately 2" so now assume I need to raise by that much ...
1
vote
3answers
14k views

Proper way to install double-layer of subfloor?

I am installing natural tile, so I've had to reinforce the joists a bit and I'm currently working on installing a new subfloor. The subfloor is 3/4" plywood with 1/2" plywood on top of it. The ...
2
votes
1answer
58 views

Support for Tile floor

I have 2x8 (7.25x1.5) what appear to be doug fur or southern pine floor joists on 16" centers in a finished basement. I want to tile a master bath on the main floor. Joists span exactly 11' 4" from ...
0
votes
1answer
119 views

Finishing Attic Floor (Joists Blocking / Insulation)

I moved into a house built in the 1920's several months ago that has a finished attic where the former owner's two teenage boys were living. I want to go from the old ratty carpeting to nice floor ...
2
votes
0answers
44 views

Securing plywood “underlayment” to timber “sub-floor”

I am laying 12mm plywood on existing timber flooring (before laying Hardiebacker board & ceramic tiles) apart from screwing the ply to the sub-floor, should I also use grab adhesive, thinset tile ...
13
votes
3answers
1k views

How can I speed up the removal of stubborn tile?

I am trying to remove tile from the bathroom floor. It was installed in the 70s, and the pieces are tiny, 1 in x 1 in. I've been hammering away but they're not coming up very easily. Is there a ...
1
vote
2answers
106 views

Bathroom remodel

I am in the process of redoing my upstairs bathroom. I would like to tile the bathroom floor. I have a tile-redi shower pan for the shower floor. Q1: Do I need to put a moisture barrier over the wood ...
2
votes
4answers
16k views

What is a proper high-quality sub-floor preparation for porcelain tile floor installation

I am preparing to do a kitchen remodel where I am replacing an existing tile floor with a new porcelain tile floor. The old floor that is being replaced has several areas where it is not level and ...
2
votes
0answers
57 views

Floor Makes Metal Clang When Walked On - One Room

We have a 3 bedroom, 2 bathroom house. The whole house has hard-wood flooring. One bedroom on the corner of the house has a floor that sounds hollow... When walked on it makes a loud clanging sound... ...
0
votes
0answers
80 views

How level does a wooden sub-floor need to be to put down engineered hardwood flooring?

We did a house expansion that pushed the walls out approximately 6' on 3 sides of a room. We built the foundation wall for the new floors to be 100% level but the old floors were not level in all ...
1
vote
3answers
354 views

Can I remove parquet flooring adhesive by using a heat gun?

I have to remove a parquet floor with possible bitumen adhesive and am unsure how thick the adhesive was applied. I need to remove the flooring to prep for laying ceramic tiling. Could a heat gun ...
2
votes
1answer
148 views

Should I install a floating floor or a staple down for engineered hardwood?

I would like to to put down a DRIcore subfloor over my on grade concrete slab floor and then install engineered hardwood flooring on top of it. Should I staple the flooring to the DRIcore and if so ...
0
votes
0answers
46 views

vapor barrier between sub floor?

A friend and myself are building a cabin in southern california. It doesn't snow often where it is located. The cabin itself is setup on a post foundation and we are almost finished with the ...
8
votes
3answers
1k views

Drywall screws for subfloor

Are drywall screws suitable for attaching a 3/4" tongue-and-groove plywood subfloor? In this case, joists are 16" O.C. and no glue will be used.
0
votes
0answers
45 views

What type of soundproofing does floormuffler offer over a concrete floor?

My mom has a 2nd floor condo and has bought laminate flooring and I'm voluntold to install it. I'm curious if anyone has experience with cork and floormuffler (and similar products) on cement floors, ...
1
vote
0answers
48 views

Floor advice - gaps, leveling, sound improvements and materials

I am a new homeowner and thus new avid DIY enthusiast :) We recently had a new radiator installed and relocated, and had to remove all the existing materials. This is what I discovered (see image) ...
4
votes
1answer
391 views

Can particleboard subfloor be used as a nail base for 3/4" solid wood strip flooring?

Question: Has anybody out there laid solid oak strip floor over a 3/4" particle board subfloor and lived to tell about it? Basis for question: I did a search on SE and all answers point to pulling ...
1
vote
1answer
65 views

When to use concrete plasticizer

When should one use a concrete plasticizer? Should it be used for internal floor slab?
0
votes
0answers
112 views

Can I shave off half an inch of a crowned up 3 by 6" floor joist?

My subfloor is sloping up because of an very crowned up floor joist in the middle of the house. The house is build on footings, and floorconstruction is accessible from underneath. The footings are ...
4
votes
1answer
399 views

What can I do about a house with internal concrete floor with no DPM?

My partner and I have just bought our first home.A 1950's bungalow which is need of refurbishment. So far it has thrown us a ton of surprises! The worst so far being the floor in one of the bedrooms. ...
1
vote
3answers
199 views

How should I finish a basement with a pitched floor?

I am building a room in the basement where the slab has a pitch. I have already installed had a foam and magnesium board subfloor and my intention is to have a carpet installed on top of that. The ...
1
vote
1answer
41 views

Are there any special considerations for installing laminate on a 2nd floor?

I have installed a lot of laminate in 1st floor rooms, with concrete subfloors. No issues there. Now I'm installing in a second floor bedroom in a townhouse. Before I rip up carpet Im checking to see ...