5
votes
1answer
896 views

Is it safe to use screws in subfloor-to-joist connection to eliminate floor squeak

Getting ready to have some hardwood (12mm laminate, technically) installed in our dining room, and in preparation for this, I bought some 1.25" stainless steel screws that I'll be putting down through ...
2
votes
1answer
1k views

Is it a good idea to repair a squeaky floor from above?

I have a second floor that squeaks, a lot. Attempts at using scored screws haven't helped much, and the carpet is due for replacement, so there is little concern about pulling it up. A contractor ...
3
votes
1answer
3k views

How can I remove just one tongue-and-groove subfloor board?

I am not talking about laminate planks, but actual subfloor sections. My entire room consists of tongue-and-groove boards. I was under the impression that the point of this was so you didn't have to ...
1
vote
1answer
224 views

How can I locate the 2x8 boards beneath subfloor, backer board, mortar, and ceramic tile?

My floor is getting a little creaky in my bathroom. Unfortunately, it has ceramic tile over it (along with mortar and backer board). What I need to do is drill a clearance hole through the grout and ...