0
votes
2answers
18 views

Should we use regular plywood or Lauan over fir strip sub-floor before laying vinyl?

We are preparing a rental kitchen floor for sheet vinyl or VCT tiles. We currently have exposed 3" wide fir strips as the sub-floor. We were told we needed to lay 3/8" plywood over the fir for ...
0
votes
1answer
30 views

Bathroom subfloor replacement

I live in a house built in 1981 that has 16 inch spaced floor joists. In wanting to retile the bathroom I have discovered the plywood all around the toilet flange is junk, it expands about 12 inches ...
0
votes
1answer
24 views

Would cork flooring underlayment help with vibration dampening in a sub floor?

Related question: HE Front End Washer vibrations on wood floors: any tried-and-true solutions? In hopes of being able to keep our new front-end HE washer (which we like) I've decided to bite the ...
1
vote
2answers
183 views

how do I level the floor in a sunk in living room

My home has a step down living room. It has carpet on it, but i want to make the floor level with the rest of the house it is about 2.5 inches step down. People keep tripping. I then either want to ...
0
votes
0answers
34 views

Raise cupboard floor (under stairs)

We have a 1930s terraced house in London (UK) with a small cupboard under the stairs, its floor space is about 80cm x 190cm. The floor of this area is around 80cm lower than that of the hall that runs ...
0
votes
0answers
28 views

How should I install a tongue and groove subfloor over ceramic tiles?

I am really new and not sure what I am doing to be honest. I am laying down a t&G subfloor over ceramic tiles to protect them(I am leasing a store front, owners would like to keep the tiles ...
0
votes
2answers
753 views

When Laying Tongue and Groove plywood over 1x6 subfloor, do I lay it with the grain perpendicular to the floor joists or to the 1x6 boards underneath?

I am redoing a bedroom and I am in the process of installing a new sub floor. I currently have 1x6 running perpendicular to the floor joists. Some do have a bit of give to them. I am laying over that ...
4
votes
2answers
504 views

Should I remove nailed-down plywood before laying tile?

In my bathroom there is vinyl on top of plywood, which is nailed to the sub floor. Should I pry up the plywood before putting down cement backer board for tile, or can I go over the plywood?
2
votes
2answers
117 views

How to fix pitched floors in a brick building

I'm looking at a property the was built in the lat 1800s. It's a 3 level brick building with two other building of similar stature on each side. I too a quick look at the second floor, and it pitches ...
2
votes
1answer
1k views

Is it a good idea to repair a squeaky floor from above?

I have a second floor that squeaks, a lot. Attempts at using scored screws haven't helped much, and the carpet is due for replacement, so there is little concern about pulling it up. A contractor ...
6
votes
3answers
933 views

What should go between a wood plank sub floor and a hardwood strip floor

I am about to install a hardwood floor into a room in my 1905 farmhouse. The subfloor is 8-12" wide 1" thick planks. The floor I am installing is 2-1/4" prefinished solid hickory tongue and groove. ...
6
votes
3answers
5k views

How do I level a basement floor but not the slab underneath?

I'd like to install laminate floor on top of Delta FL in my basement. The basement slab is not level, it slopes (from all directions) towards a floor drain (that, via a pipe, leads to a sump pump) ...