Vertical member in wall framing.

learn more… | top users | synonyms

0
votes
1answer
32 views

Mounting TV on metal studs?

The wall contains metal studs 24 inch apart. On a previous TV, I installed an articulating TV mount (80lbs total with mount) on two metal studs with 4 snap toggles (that's 2 snap toggles per metal ...
2
votes
0answers
3k views

Why can't I drill into studs more than 1 & 1/2 inches?

I am trying to mount a TV onto an "exterior" wall. I used the quotes because I guess technically it may not be exterior (I live in a townhouse with dividing walls between the houses). Anyway, I've ...
1
vote
0answers
78 views

Giant magnetic something behind drywall/fireplace

I'm trying to mount a flatscreen TV above our fireplace that was converted by a previous owner (from wood?) to direct vent. During the process of finding the studs, I noticed that magnets stick the ...
1
vote
0answers
158 views

Ceiling fan install - orientation of mounting bracket to slope of ceiling

I'm replacing a light fixture with a fan/light using a down rod mount on an angled ceiling. The frame studs run parallel with the slope of the ceiling. Manufacturer notes to install mounting bracket ...
1
vote
0answers
110 views

How should I build stud walls to make shelves in a room that has a sloping ceiling and floor?

We have a home that is 104 years old. There is a room that was added in the 1940's and built over a sloped roof from the rooms below. It is fully enclosed and we would like to add some shelving in the ...
1
vote
0answers
338 views

how to attach threaded rod to wall stud on hinge

How can I attach threaded rod to a wall stud so that it is on a hinge. The hinge axle will be horizontal so the rod can rotate up and down but not side to side. The one piece solution I have found ...
0
votes
0answers
88 views

What is the difference between a C stud with a dent on the back and one without?

What is the difference between a C stud with a dent on the back flange and one with a flat back?