Vertical member in wall framing.

learn more… | top users | synonyms

2
votes
2answers
85 views

Mounting Full Motion Mount on a Single Stud

I've seen this question regarding a sheet metal stud, but my plan and situation are a bit different. I am curious if ananyone thinks this sounds secure: I have a full motion flat screen wall mount ...
1
vote
1answer
35 views

Can I use OSB or plywood instead of 1x6 boards to hang metal panels?

I'm going to be putting up two louvered panels that will hold plastic hanging bins (think akro-bin type). I won't be able to mount the panels on studs, so I'm trying to decide if I should mount ...
1
vote
1answer
141 views

Can I hang cabinets and shelves on metal studs?

I recently moved into a high rise apartment and need to hang some cabinets. The cabinets themselves weight about 20lbs and I'm thinking the stuff stored inside them will be around 40lbs. I know I ...
0
votes
1answer
91 views

What's the strongest anchor for something heavy in double drywall?

I have a party-wall in my apartment-née-condo that seems to have two sheets of drywall installed against eachother. All attempts to find some sort of stud or resilient channel / furring strip have ...
2
votes
0answers
2k views

Why can't I drill into studs more than 1 & 1/2 inches?

I am trying to mount a TV onto an "exterior" wall. I used the quotes because I guess technically it may not be exterior (I live in a townhouse with dividing walls between the houses). Anyway, I've ...
1
vote
0answers
25 views

Ceiling fan install - orientation of mounting bracket to slope of ceiling

I'm replacing a light fixture with a fan/light using a down rod mount on an angled ceiling. The frame studs run parallel with the slope of the ceiling. Manufacturer notes to install mounting bracket ...
1
vote
0answers
50 views

How should I build stud walls to make shelves in a room that has a sloping ceiling and floor?

We have a home that is 104 years old. There is a room that was added in the 1940's and built over a sloped roof from the rooms below. It is fully enclosed and we would like to add some shelving in the ...
1
vote
0answers
69 views

how to attach threaded rod to wall stud on hinge

How can I attach threaded rod to a wall stud so that it is on a hinge. The hinge axle will be horizontal so the rod can rotate up and down but not side to side. The one piece solution I have found ...
0
votes
0answers
61 views

Sappy, oily smell on drill bit from wall studs

Just moved into a new apartment and drilled some pilot holes to mount my TV. The apartment is 25 years old located in south florida. When I removed the drill bit from the wall it smelled like pine ...
0
votes
0answers
41 views

What is the difference between a C stud with a dent on the back and one without?

What is the difference between a C stud with a dent on the back flange and one with a flat back?
0
votes
0answers
162 views

How much termite damage to load-bearing studs and sill plates warrants reinforcement or replacement?

I opened up an exterior wall and found a lot of termite damage. They did a number on two load-bearing studs and the sill plate they're resting on. To get a sense of the damage, I cleared out as much ...