2
votes
2answers
117 views

What's the point of a thin (1/4" width) piece of wood set diagonally between two studs?

What's the point of a thin (1/4" width, ~2-3" wide) piece of wood set diagonally between two studs? I just took out a piece of drywall for some other work I'm doing, and between two studs, there's ...
0
votes
1answer
112 views

What is this pipe - should I be worried?

We found it behind a wall, it is a bit more than 10 inches wide it has about an 3/4 inch of concrete between metal. It was jaggedly broke off on the bottom in the basement ceiling. It is also ...
2
votes
2answers
414 views

Are there span tables published for repairing a cut roof joist?

A roofing company mistakenly cut a 2 foot section out of a roof joist, on my home. I'm seeking a reference to what would constitute a proper repair, preferably a prescriptive code or a load table. ...
1
vote
1answer
775 views

Can I use a threaded rod for a rafter tie?

Long story short: I am working on a 1960's house with no rafter ties. The rafters themselves are now attached with screws and strong-ties (previously just double nailed!) but I don't have faith in the ...
5
votes
2answers
6k views

What size ceiling joists and rafters should I use for a 14' span?

I'm going to build a single story addition to my home with a width of 14ft. I plan on using ceiling joists every 16" but I'm not sure which size to get. The roof will be asphalt shingles and the attic ...
4
votes
1answer
3k views

How far can I move ceiling joists up?

The second floor of our house has a fairly low ceiling, perhaps 6'8" or 6'10". The width of the structure is only about 16' with standard construction and the ceiling joists running parallel to to the ...