0
votes
1answer
82 views

How do I add support blocking for a floating sink (when the wall framing is metal studs)?

I'm installing a floating sink and think I need to install blocking between the studs. I would normally open the drywall at the correct height and use a 2x6 between the studs. But this is going into a ...
1
vote
1answer
38 views

How can I sand the underside of an enamel sink?

we need clearance to install stem valves because the faucet hole was drilled too close to the sink. We need about 1/2" extra clearance. The counter top guys drilled too close to the sink and did not ...
2
votes
2answers
575 views

Should I secure a free-standing vanity sink to prevent drain pipe damage?

I recently installed a free-standing vanity sink in my laundry room, similar to the one pictured below. Due to the configuration of the drain and supply pipes in the room, the sink could not be ...
4
votes
5answers
6k views

How do I install this wall mount bathroom sink?

I'm replacing a sink that was on a vanity cabinet and hoping to do as little busting through the perfectly good tile as possible. I heard a rumor that I need to make very sure that the sink is ...
2
votes
1answer
875 views

Removing knockouts in composite granite sink

The sink has one existing hole, and 3 knockouts which are cut about half way through the material. What are the best tools, and techniques for removing fixture knockouts on a composite granite ...