The tag has no wiki summary.

learn more… | top users | synonyms

1
vote
0answers
32 views

Can I cut out the sill plate to pass a duct through a load bearing wall?

I need to pass an HVAC duct through a load bearing wall into the basement below it. I can't seem to find a code reference in IRC for what I am allowed to do with respect to notching or cutting away ...
1
vote
1answer
71 views

Replacing sill (bottom plate) of wall

I need to replace the sill of an exterior wall (load bearing wall that faces the outside the home). I ripped the sheet rock off and noticed some very old termite which was apparently treated years ago ...
0
votes
2answers
36 views

How to attach a new sill to an existing concrete foundation

I have a foundation of block wall. To get it to the correct height I need to put 4" solid block top cap on it and my sill plate on top of the 4" solid top cap. I can fill in the voids in the block ...
1
vote
1answer
41 views

How to remove a granite window sill?

I need to remove a granite window sill in order to install plantation shutters. How can this be done? Can it be done without damaging the wall that the granite is affixed to (at the base of the ...
2
votes
1answer
74 views

Is there a recommended distance between fasteners on sole plates?

We've just started installing pressure treated 2x4s as sole plates in our 5 year old basement. We drove 3 nails into each 8' plate, one at each end (around 3 or 4 inches in) and one somewhere at the ...
2
votes
1answer
584 views

Replacing a sill, on a factory built Marvin window?

The following windowsill, and the ones like on the same building, have failed. Patching with Smith's Flexible Epoxy kept the sills alive for a few years, but now the entire sill feels like balsa wood ...
2
votes
1answer
467 views

Attaching sill plate to concrete, how do I attach framed wall to sill plate?

I am building a 12x12 shed on a concrete slab. I am going to bury j-bolts in the wet concrete so that I can attach the treated sill plate to it. The problem I'm running into is that the nut will be ...
4
votes
1answer
409 views

What can I do about this gap between the sill/exterior board and the subfloor?

I just discovered that my sill plate and joist setup is different than others I've seen (and I was a Realtor, so I've seen a lot of sills). As you can see from the picture, there's a gap between ...
5
votes
1answer
5k views

How do you finish a window installation?

After the window has been secured in the rough opening, how do you finish the inside part of the installation? For example adding a window sill and trimming out the inner portion of the rough opening, ...
4
votes
2answers
835 views

How can I correct the slope of a marble shower sill?

Our master shower is tiled in marble; it's almost perfect except... the sill has a slight slope running out of the shower instead of into it. As a result, every time we take a shower, a small amount ...