The tag has no wiki summary.

learn more… | top users | synonyms

0
votes
1answer
22 views

Rubbered Washer Nuts Direction?

When a nut has a built in rubber washer, does the rubber side have to go on the inside as it is almost impossible to get it started?
2
votes
1answer
62 views

How can I get the “new bed” smell out of my daughter's bedroom?

I bought one of those princess carriage beds for my daughter. You know, the kind that take seventeen hours and five allen wrenches to put together. Anyway, I get it together and honestly, it's ...
1
vote
4answers
299 views

How do I even out a pair of bookcases on an uneven floor?

So, I have a couple Ikea Billy bookcases, normal. I got them with doors, so with the forward weighting, I'm a bit extra paranoid about tipping. I put them together; all fine. Then I try to place ...
1
vote
2answers
189 views

Is beeswax ok to use to keep a screw tight?

I have purchased a table and chair set, and the screws holding it together consistently come loose (from pulling and dragging I assume). I have heard that beeswax will help hold things together, and ...
2
votes
1answer
9k views

How do I remove these screws from an IKEA Micke table?

I have assembled a Table Micke for the 1st time ... but I have some screws I want to remove. or didn't fit well (shld have tighten all screws more), 110126, 103430, 110630 the look like below ...
6
votes
1answer
787 views

How do I fix stripped bolt holes in wood?

I have a wood futon that is assembled with threaded bolts screwing into holes in the wood that are threaded. Over time the threading in the wood has worn and the bolts just slide in and out. I've ...
0
votes
1answer
732 views

How do I put together an Avid Outdoor Gazebo / Sun Shade [closed]

I've lost the instructions to my Avid Outdoor Gazebo / Sun Shade, Model #1083. Avid has gone out of business, and the instructions are not available anywhere on the internet (though there are many ...
3
votes
2answers
194 views

What size ratchets do I need to assemble some new equipment?

I recently purchased a power rack and various other bits and pieces for the home gym. In the instruction manual the nuts and bolts on the hardware list state the following sizes: 1/2" × 3 - 1/2" 1/2" ...
1
vote
1answer
670 views

How do I reinforce a drawer bottom?

I recently bought a self-assembly wardrobe. After assembling it, the drawer bottoms were not held in place by enough wood (I think the groove for the drawer base was too close to the bottom of the ...