2
votes
3answers
216 views

What type of screws should I use?

I am going to build a set of shelves for my wall to hold my bead jars. The shelves are narrow 4" nominal and very close together 3" is the farthest apart they will be. I'm using quality pine ...
2
votes
1answer
142 views

How to build a wooden ladder for a loft bed?

I want to build a five foot ladder for my 6 ft loft bed that's being cut down to 4ft tall because it's too close to my ceiling. My bed is going to be in front of my window which is on my shortest ...
6
votes
2answers
254 views

How do I screw two posts together so that they look seamless and can easily be taken apart and put back together?

I would appreciate help so much! I am trying to make a 'collapsible' arbor if you will. I would ideally like to saw my large birch posts in half and make them screw back together in the center, but I ...
4
votes
2answers
389 views

How should I connect 2x4 (or wood horizontal railing pieces) to exterior painted wood?

I'm planning to add a 10-foot railing to a patio that has a 6x6 wood post on one end and the exterior of the house on the other end of what will be the railing. I'm planning wood horizontal rails ...
1
vote
1answer
3k views

How do I ensure my wood screws have a minimum of 120 lbs pull out or shear strength?

Some assembly instructions for a project I am doing requires that I use fasteners (screws) with a minimum of 120 lbs pull out or shear strength. What I plan to use is #8 2 1/2" coarse thread wood ...
4
votes
1answer
556 views

How Can I Fill Screw Holes In Beam So I Can Move Screws Slightly?

I had a contractor replace a 4x10 beam and two 4x4 posts that supports my deck. He also replaced and enlarged the concrete patio below the deck. I am in the process of replacing the deck floor so it ...
6
votes
2answers
1k views

What can I use to lubricate screws?

I am re assembling a swing set made of pretty hard wood. My electric drill won't drive the screws in all the way and I have to try to use plain screwdriver. I don't want to strip the heads though. Is ...
14
votes
5answers
4k views

Should I use nails or screws to refasten my subfloor to the joists?

My subfloor is squeaky, and there's a small window of opportunity I'll have to fasten it down before/during my carpet being replaced. I have available to me a nice corded drill, and an air-powered ...
4
votes
3answers
2k views

How can I repair screws in furniture with stripped holes?

I'm trying to repair a piece of furniture from which several screws have pulled out, stripping the wood. It's a lift top coffee table, such as this. (This is NOT the model in question, this just ...
4
votes
3answers
246 views

What guidelines exist for the number of screws needed to attach two pieces of wood?

Are there any guidelines or rules of thumb for how many screws I should use when screwing two pieces of wood together? For example if I have a 2cm x 10cm plank I want to screw onto a 10cm x 10cm ...
5
votes
3answers
2k views

Why should I use advanced nails instead of wood screws for strength?

Recently I found that there're some superior nails for constructing hurricane-resistant houses - with very clever design for preventing pulling the nails out and tearing the boards off when the ...