6
votes
6answers
1k views

How to SLIGHTLY widen bored hole in 2x6

I'm making a stand-alone pullup bar and I bored 1 1/4" holes in 2x6's for my 1" galvanized pipe (1 1'4" outside) to slide through. Only the pipe is definitely 1 5/16" (thank you, guy at Lowes) and I ...
5
votes
2answers
823 views

How can I plane the edges of plywood?

I'm working on an 8ft x 12ft climbing wall. I have 3/4 inch ACX plywood attached to a frame. Since the frame isn't perfectly square, the plywood overlaps on the edges (up to about 1cm) so I need to ...
1
vote
3answers
121 views

How to sand wood without flattening it

I'd like to sand some wood planks on a rustic table to remove paint stains, but keep the rough wood structure (1-2 mm height difference). How can I do that?
4
votes
1answer
168 views

What's the significance of orbit diameter in a random orbit sander?

I've been looking at random orbit sanders and noticed that they have different orbit diameters, and some models even offer settings for it. Does the orbit diameter affect material removal, or ...