Fixing something after it gets damaged or broken.

learn more… | top users | synonyms (1)

2
votes
0answers
356 views

Help! enclosed porch/sunroom foundation

We just purchased a home and now that the snow level is not 4 feet high ( we live in central NY ) we see that the concrete patio/foundation has horizontal cracks, and crumbling along the side, corner ...
2
votes
0answers
209 views

Need to unstick stuck shower divider valve

The shower divider value (which chooses between letting water flow into the tub or up into the shower) is stuck. I can't spin it with the installed plastic handle. Here's some pictures: With the ...
2
votes
0answers
180 views

How can I protect my hardwood floors without sanding and refinishing?

At some point, I do plan to sand down my hardwood floors and refinish them in my 100 year old home. However, It's a 100 year old home. There is no subfloor, the hardwood is installed right on the ...
2
votes
0answers
224 views

Can I add cement glue and sand into my concrete mix to repair my cenent garden statue?

I have a leopard concrete garden statue that was given to me by my neighbor that has a broken foot and log. I want to repair it and paint it. It also has been weather eroded so I need to recover it as ...
2
votes
0answers
415 views

Why won't the lower agitator on my washing machine spin?

I have a Whirlpool top load washing machine. I recently replaced the dogs on the agitator which was very easy. The top agitator works like it is supposed to, but the bottom doesn't move. It's like it'...
1
vote
0answers
40 views

How to measure head casing?

I have, what seems like a trivial question. How on earth do you measure the size of a head casing? I measured as it shows in this picture, going from the bottom side of the 45's. I measured my ...
1
vote
0answers
46 views

How to repair broken off wood from a chair?

I have an old chair that part of broke of some time ago and was lost. I've finally got round to fixing it as it's a bit of an eyesore. I started by using some woodfiller which I had lying around, but ...
1
vote
0answers
25 views

ground water in old coal store

Hi my old coal store in cellar leaks ground water when it rains. Rest of my cellar is a converted kitchen and bathroom. House is over 100 years old. I have damp proofed with liquid rubber, tanking tar ...
1
vote
0answers
22 views

Easiest way to replace mortar around door?

I have a stone house and some of the mortar around one of my door frames has completely eroded away, there are big gaps and I can now see the screws that once screwed into the mortar too hold the door ...
1
vote
0answers
40 views

New troy built mower b&s engine surges

My son called me told me that my brand new out of the box mower's engine surges. Yes I'm going to take it back to the store,when I get back in town, and have them fix it but in the mean time I am ...
1
vote
0answers
30 views

Electric blackout blinds

I've looked at the questions that have already been posed and they go some of the way to the situation I have. I will attempt to remove the cassette that houses an electric motor and the sidebars as ...
1
vote
0answers
35 views

Where can I find drawings of a mobile home's construction?

I bought my very first trailer/mobile home last August. I've never lived in one, never spent significant time in one, know less than nothing about them. That said, I have a doublewide 90 Commodore. ...
1
vote
0answers
79 views

Tiling over rough uneven plaster wall

After pulling down some paneling in our bathroom I discovered why they had it there in the first place. At one time there was plastic tile over the walls and they damaged the surface while removing ...
1
vote
0answers
24 views

Clay drain pipe repair

I was digging up a foundation and broke some parts of the top sewer pipe. The pipe is encased in concrete so not easy to replace. How can we repair the hole without replacing the pipe?
1
vote
0answers
58 views

How to repair a table surface?

The table is a bean shaped hollow structure made of two 4mm hardboard panels and has a convex siding. The top surface and the sidings are coated seamlessly. It's 40mm thick and about 1.5 square ...
1
vote
0answers
82 views

How to fix a stripped hole?

I have a hole that a head of as bolt goes into, but the hole is stripped and cannot get a good grip on the bolt head. The hole is attached to an agitator which spins. Any help? Remember, only the head ...
1
vote
0answers
20 views

Fountain maintenance / Repair

I have an outdoor in-ground concrete fountain. How can you tell if water is evaporating fast or if I have a leak? I do not see any visible cracks in the concrete basin. However, water seems to ...
1
vote
0answers
140 views

What causes these chips in a cement brick wall, and how can I fix them?

I have found my exposed basement cement wall which is about 15 x 10 in size to have quite a few areas where there is a cracked chip ranging from approx 0.5" in diameter to 2" in diameter and a few ...
1
vote
0answers
45 views

Tripping Inline GFI Outlet

We are working on an "inline" GFI Circut (has 4 or 5 outlets on the GFI Circut). When we use a tester to test for 110 (Red prob to hot side of socket and Black prob to ground at box) it pops the GFI ...
1
vote
0answers
70 views

water heater won't stay lit

Looking for suggestions on repairing my water heater. The pilot light won't stay lit. I've cleaned the air intake and checked the venting in the attic but it didn't correct the problem. It will ...
1
vote
0answers
528 views

Repairing dimmer switch

I have an IKEA lamp with dimmer switch which took a knock and immediately started outputting full brightness. I've read a little about how dimmer switches work and that this is likely caused by the ...
1
vote
0answers
73 views

MayTag Legacy Series Top of Dryer Won't Open

I can not open the top of my Maytag Legacy Series Dryer. There is a screw on each side of the top of the dryer pinning it down to the base? What do I do now to get to the rest of the dryer since the ...
1
vote
0answers
66 views

Waterproofing sub & top floor for balcony

I have a 27 X 10 feet open balcony. I replaced the Plywood floor it had with 3/4 Plywood which I used as sub floor and covered it with different lengths (from 12 in to 32 in) of 2 by 4 studs. I ...
1
vote
0answers
136 views

Glue Kohler flush valve together?

I have a Kohler toilet with a canister flush valve (part 1084017-6-A). The top of the "guide" piece in the flush valve assembly (where the hose attaches) broke off, so the toilet functions but very ...
1
vote
0answers
186 views

How to repair straight cut floor joist?

What's the best way to repair a cut floor joist? It looks like when removing floor boards for remodel, someone has cut about half way through the top of joist with saw straight cut. No notching. I'm ...
1
vote
0answers
156 views

Dimmer, on/off switch and outlet not working after replacing

I replaced an old dimmer switch on an new 7 recessed lights (Outdoor Soffit Lighting Kit 2-Pack) with 6 R20/50W bulbs. The dimmer I bought is Skylark Contour 150-Watt Single Pole/3-Way CFL-LED Dimmer. ...
1
vote
0answers
624 views

How can I fix these cracks in my concrete/plaster wall apartment in Paris?

I'm used to working on sheetrock in the U.S. but I now live in France. In my old apartment in Paris, the walls seem to be plaster but could be concrete. It is soft enough to make divots if I dig in my ...
1
vote
0answers
86 views

Ceiling fan fixture's lights flicker then the whole unit fails completely

I have two remote controlled ceiling fan fixtures in my living room. The individual units are the same, three speed fans with three lights on each. One day, one of them began flickering after I ...
1
vote
0answers
213 views

Is this vertical gap in the concrete block foundation something to worry about?

I'm looking at a home that has a vertical gap or crack running the height of the exposed concrete block foundation. The crack is near the center of the home, about a foot to the right of the concrete ...
1
vote
0answers
583 views

Repairing cracked fiberglass pool steps

I have a roughly 6" crack on one of my top fiberglass pool steps that slowly allows the water level to drain below the optimal level for the skimmer. I've found some years old suggested techniques ...
1
vote
0answers
63 views

Would painting the underside of plywood serve as a vapor barrier to protect the plywood from absorbing moisture?

I will strip the 3/4"tk x 3" wd t/g kitchen flooring and replace it with 3/4" t/g plywood. I will install solid vinyl planks (akin to laminate flooring) on top of the plywood. The question: Would ...
1
vote
0answers
278 views

How do I replace foam seal on clothes dryer?

I was doing some unrelated work on my Frigidaire clothes dryer and noticed that the foam seal that is attached to the front panel and sits against the blower housing was bent on the bottom and burned ...
1
vote
0answers
76 views

Wooden siding repair

I have some timber siding (planks of wood) that over lap. I've been told its shiplap but according to the place I got my wood the wood is shiplap but the style of overlaying it is something else. ...
1
vote
0answers
58 views

Should I remove dryer support roller residue and how?

I have a front-loading electric Whirlpool dryer (LER4634PQ0) that's got a sagging drum, making it noisy and causing it to soil clothes. I first noticed it via brown marks on my clothes caused by a ...
1
vote
0answers
156 views

How should I waterproof a replacement shower floor?

I have to replace the tile floor in my shower because of mold. What should I use to waterproof the floor and turn up the wall?
1
vote
0answers
160 views

Repairing exterior cement wall

I have an exterior wall on one side of a brick building that appears to be stucco or cement. Some of it is starting to come off in sheets. Basically, there is one layer, maybe the thickness of orange ...
1
vote
0answers
670 views

Installing a Sewer Cleanout

Recently I've been experiencing some backup with my toilet and tub due to some roots in our line. I've had Roto Rooter come out a couple times to do their thing and cut out some of the roots to ...
1
vote
0answers
2k views

Would this buildup cause “dHE” error on an LG Tromm dryer?

Got the machine off craigslist. During the drying cycle it stops and shows the error. The user manual tells that with dHE error I should inspect the water supply, if the water supply is within spec, ...
1
vote
0answers
147 views

Why don't the locks on the bottom of my uPVC windows lock into place?

I have a problem with the window handles on two of my uPVC windows: the handles turn up and down but the little locks at the bottom of the windows do not move or click into place properly, therefore ...
1
vote
0answers
109 views

Why am I not getting hot water from my tankless hot water heater?

I just bought my house last year. The previous owner had just replaced the boiler before I closed. I had oil delivered the day that I moved in. I had problems with the hot water right away as it ...
1
vote
0answers
62 views

What type of support would I use for a hutch that is leaning inward?

I have a hutch that is comprised of two pieces that come together. The bottom is a flat surface with a cabinet and two doors in addition to some storage space. Above it, is a more storage space ...
1
vote
0answers
782 views

How do I repair cracks in the concrete pillars supporting my patio roof?

I have two round concrete pillars that support my patio roof. I have noticed that they have cracks even though they are new. I suspect the filling of mortar and bricks inside those pillars was not ...
1
vote
0answers
2k views

What dangers are associated with changing the pilot light assembly on a gas water heater?

My A O Smith ProMax gas water heater started going out at various intervals. I would re-light it and it might stay lit for a few minutes, few hours, or even a day or so. I figured it was the ...
1
vote
0answers
398 views

Is there something wrong with this 3-way lamp switch?

We have a floor lamp with a three-way combined switch and socket. I noticed arcing sounds when rotating the switch, so I disconnected it. Later I found that the "low" and "high" settings worked fine, ...
1
vote
0answers
624 views

How can I repair scratches on a coated stainless steel surface?

I have a coated stainless steel refrigerator that unfortunately was scratched. Every tip I've found for removing scratches says the coated ones cannot be fixed once scratched. Any suggestions?
1
vote
0answers
344 views

How can I tell if I've got Cool Deck installed?

I have coping around my pool that I thought was Cool Deck. When I started researching "How to repair cool deck", I noticed I do not have the uneven (up and down) pattern) my coping is smooth and ...
1
vote
0answers
131 views

How can I repair damage to an engineered floor caused by cleaning products?

A product 'Mop & Glo' was used on my engineered floor. An employee of the company from whom I purchased my floor recommended that I use Armstrong Hardwood Floor cleaner to attempt to remove the ...
0
votes
0answers
54 views

What can I do to repair my metal gazebo frame?

My friend gave my his old gazebo frame as the canvas has worn out and replacing it was equivalent to the cost of getting a new one. It is 10x10 feet. I bought a medium duty green brown tarp to cover ...
0
votes
0answers
44 views

what type of sheet metal screws are harder than stainless steel?

I am trying to repair my dishwasher that has a stainless interior. I need to use stainless sheet metal screws so they wont corrode. I've got holes drilled and the screws go into the thin stainless ...
0
votes
0answers
40 views

Window air conditioner fan slows to a stop in about 2 minutes

I just bought a window A/C unit and turned it to "low fan" setting. Within I think a few seconds after it started, I could hear it slowing down, which it continued to do until it came to stop, which ...