2
votes
2answers
68 views

How can I eliminate unneeded receptacles?

The house I just bought has three different outlets in the walk in closet!! I want to remove a couple of the plugs and just put a solid plate on them. The outlet has 2 black wires and 2 white ones. It ...
2
votes
2answers
75 views

How can I connect my 30 amp electric dryer to a 50 amp plug?

I bought a used electric dryer and the connection that came with it says it's 30amp. I also have an old school plug in my wall that doesn't go with the connection provided. My current plug has 3 ...
0
votes
3answers
109 views

2 prong to 3 prong outlet help

I don't know too much about replacing outlets, only what I've read online or through YouTube videos. The house was built in the early 50s. Some outlets have been replaced (brand new kitchen) but some ...
0
votes
2answers
55 views

What does it mean when one wire goes into load, and one goes into line

I am replacing my kitchen outlets with GFCI. The inspector told me I just needed to install one at the first outlet in the circuit. I looked at the outlets on either side of my kitchen; at one end ...
1
vote
2answers
53 views

Is it okay to use both the backwire holes and the side terminals on an electrical outlet?

I'm tying into an existing outlet box to provide power for a new electrical outlet. The existing outlet already has 2 lines connected to it - one from "upstream" (to the fuse box) and one downstream ...
2
votes
3answers
89 views

Wiring electrical outlets from a single outlet

I'm building an entertainment center unit, and on the unit I want to embed wall outlets into it so I can plug things like my receiver, NAS, consoles etc in a clean method. I thought the entertainment ...
1
vote
5answers
115 views

TV Arcs with Cablebox through both Coax and HDMI

Here is our setup Outlet in older house that was replaced with a GFI last year. (no issues until recent) The GFI doesn't have a ground wire running up from the basement. Just the white and black ...
3
votes
2answers
78 views

What is the preferred method for removing & replacing electrical wiring in the garage?

I just purchased a house built in the mid-1990s in Kansas, U.S. The garage is generally finished: It has sheetrock walls and ceiling. It also has outlets spaced every 6 feet or so about 4 feet above ...
0
votes
1answer
58 views

How do I properly install GFCI outlets with existing 12/3 wire in parallel and on a switch?

I am trying to help my inlaws with a problem in their living room. Two of their outlets stopped working and I don't really know why. The outlets were wired to a switch in the hallway, which ...
1
vote
2answers
71 views

Adding USB Dual Port Charger Receptacle Blows Mains

I purchased a Hubbell "USB Dual Port Charger with 15A Duplex Receptacle" from Lowes to replace the duplex receptacle on my kitchen island. I first opened the circuit labelled for the island. The ...
12
votes
3answers
1k views

Is there ever a reason for reversing hot and neutral on a receptacle?

I moved into a new home and several receptacles have the hot and neutral reversed. I confirmed this with a basic receptacle tester. I opened one up and found the white wire on the brass terminal, ...
1
vote
2answers
154 views

Is it possible (and safe) to adapt a 4-prong dryer outlet to a NEMA 6-20?

I'm considering an appliance that is 240v 16A 3500watt with a NEMA 6-20P plug. Is it possible and safe to create an adapter for this so that it can be plugged into a standard 4-prong 14-30R dryer ...
3
votes
2answers
281 views

How do I change which half of a receptacle is controlled by a wall switch?

I have a switched outlet in a bedroom. The top receptacle is controlled by a wall switch while the bottom is always hot. Can I make it so the top is always hot and the bottom is switched by just ...
1
vote
2answers
81 views

Why use AFCI receptacles rather than AFCI breakers?

Is there any reason to use an AFCI receptacle rather than replacing the breaker with an AFCI type? It seems that providing protection on the whole circuit makes much more sense than to just one ...
2
votes
1answer
65 views

How many circuits do I need? and can I bundle wires in the wall?

I'm looking into running new electrical circuits to my attic and second floor. The attic is two bedrooms + a small bathroom, the second floor is four bedrooms + another bathroom. I'd like some advice ...
2
votes
2answers
194 views

Why are only half of my receptacles working after an electrical arc in one of them?

I live in an apartment above an older building that I help care for. I was unplugging my phone charger (I may have pulled it out too fast) and there was a huge arc and flame color and it smoked. This ...
2
votes
1answer
113 views

How safe is this power configuration?

I have a regular 2 socket, 15 amp outlet in my garage. I need to run my miter saw and shopvac at the same time, the saw draws 15A and the shopvac 8.5A. I've currently been running them off one ...
0
votes
1answer
139 views

Should I replace a receptacle with a small burn mark?

I have a window A/C in my room. I turned it on last night and power from that socket, the restroom lights, second bedroom and hallway lights are not working now. The plugs in the restroom do work. The ...
1
vote
1answer
193 views

How can I wire a GFCI combo switch so that the switch controls the receptacle?

I want to install a Cooper Combination Switch/Receptacle GFCI device. Everything I've seen shows the switch controlling a light or garbage disposal and the outlet always hot. I want the switch to ...
5
votes
3answers
548 views

GFCI outlet hot when nothing's plugged into it

Using a thermal camera (coolest thing in the world, by the way), I discovered that a GFCI outlet in my bathroom is hotter then the surrounding wall when nothing's plugged into it: It's not boiling ...
1
vote
3answers
87 views

One GFCI outlet to protect them all

My house was built in 1981, we have a small U shaped kitchen with 5 outlets, along with a switch for the garbage disposal. I do not see any GFCI outlets or any indication any of them are. With a 4 ...
1
vote
2answers
92 views

Why do I have no power in two rooms after plugging something in?

I plugged something into an outlet, and heard a sort of a sizzle noise. Now I have no power in two rooms, but the breaker did not trip? Any ideas into what happened?
0
votes
1answer
314 views

How to attach outlet box in soffit?

I'm now planning to install out outlet flush, or as flush/above as possible, to the soffit. I've read other threads, and believe I'm good on how to protect it, etc. I buy a rate outside box correct? ...
1
vote
2answers
251 views

GFIC requirements for a Kitchen multi-outlet strip

I was thinking of replacing my current kitchen counter receptacles with a Hard Wired Multi-Outlet strip that would run below my cabinets. My question is How would I provide GFCI protection? Can a ...
2
votes
6answers
942 views

Do power outlet splitters decrease power for each deviced connected to them?

If I have a one to three outlet splitter, would this mean that each outlet only gets one-third power, or do all three get full power?
2
votes
1answer
164 views

Replacing outdoor outlet

How can I replace an outdoor outlet cover that has a stripped center screw? Do I need to replace the outlet as well? Do I need to replace the box that the outlet is housed in if it is coming out ...
1
vote
1answer
340 views

How do I add an outlet to the end of a circuit that terminates with a recessed light fixture?

I have a closet with a light switch and a recessed light. I want to add an outlet to the ceiling of the closet. I have really good attic access to the recessed light, so actually placing the ...
0
votes
2answers
191 views

How should I mount a rework box if it has to go through an MDF/wood panel and drywall?

I need to install a combination power and low voltage box in the ceiling of my finished basement for my home theater projector. I can't bolt the projector mount directly to the studs because of ...
2
votes
4answers
2k views

What is the purpose of the “grounding” tab/wire on a 3-prong to 2-prong adapter?

We've probably all seen these guys... They come in handy when you need to plug something with three prongs, into something with two prongs. What I've never understood was, what the heck is the ...
1
vote
3answers
259 views

What are the pins in this socket?

What's the correct orientation for a plug in this outlet? What are line, which are neutral, which is ground? It's from India.
2
votes
2answers
5k views

How can one whole group of outlets stop working, but the wires to one plug on one outlet are still hot?

I have a bank — circuit? — of outlets in the kitchen that have stopped working. One of these outlets is a GFCI but it is not tripped. The breakers for all the kitchen outlets have not tripped but I ...
5
votes
3answers
181 views

Provisioning for a hypothetical electric car

I'm doing a remodel on my house which involves building a new garage. I have no plans to get a new car soon but presumably will in 1-5 years. How should I wire for an undetermined electric vehicle ...
1
vote
1answer
144 views

Can I install a new outlet here?

I saw a blank faceplate at our new place, decided to open it up, and found two black cables going straight through the box (see picture). This would be a great spot for a new outlet, so I wanted to ...
3
votes
1answer
174 views

How can I provide GFCI protection to my kitchen receptacles?

I Live in Round Lake, Il., in a 1940's built home. In my kitchen I have four counter top receptacles surrounding my sink area. Two of the receptacles are close to the sink, and I want to replace them ...
2
votes
1answer
231 views

What size GFCI and receptacles on 20A circuit?

I am adding a string (5-6) of receptacles to an existing 20A circuit in my basement that currently has just one 15A duplex receptacle on it (with 12/2 Romex). I am planning to replace the existing ...
1
vote
3answers
251 views

How can I trace an electrical cable?

I'm installing a wall mount over an existing electrical socket - so I want to remove the socket I've read that just capping off the Hot and Neutral wires is not the best approach and that ...
1
vote
1answer
141 views

Shorted a wire and now no outlets work

I turned off the wrong circuit breaker by mistake and when I cut a wire thinking it was dead there was a large spark. I went to the circuit breaker box and the circuit breaker did not look as though ...
6
votes
2answers
5k views

Can I replace this receptacle that has four wires connected to it?

I'm in the process of replacing all of the electrical outlets in our kitchen to match the color of a new backsplash. Three of them were straightforward. The fourth and fifth, however, were wired ...
5
votes
2answers
4k views

Why does my receptacle tester say open ground on my new outlet?

I replaced an outlet and the tester says open ground. I checked all the wires and they are secure including the ground wire. What could be wrong?
3
votes
3answers
808 views

Can a dryer receptacle be wired without a neutral?

In my apartment, I have a 4 wire 240V receptacle for a dryer where the neutral is not connected, only the 2 hots and ground. Is this configuration permitted for a dryer circuit? An electrician and ...
1
vote
0answers
357 views

Wiring Leviton Timer to Bath Fan and Switch to Light

I am a DIYer with a basic knowledge of electrical wiring. I am having trouble wiring a bath fan to a timer and light to a switch. I can get get power to one or the other, not both. Here is the ...
4
votes
1answer
311 views

How do I wire this 30A 250V straight blade pass and seymour receptacle?

This is the receptacle I'm trying to wire. The ground says green next to it, but the other two wire inputs don't say anything. I need to know which is positive and negative. there is no + or - the ...
5
votes
3answers
7k views

How can I rewire my bathroom fan, light, and receptacle?

My bathroom has one switch that powers the fan and light. In that electrical box, there is also a hard wired electrical outlet that sits in the bathroom. Since I don't have room for a 2 gang box in ...
2
votes
1answer
63 views

How do I replace my electrical receptacle?

There is 1 hot and 4 neutrals tied into one receptacle two neutrals on each screw with one hot on the other side. I want to put GFCI in its place on that circuit. I added a GFCI receptacle downstream. ...
5
votes
2answers
1k views

How do you secure electrical outlets in a concrete block wall?

I have an old home that has several outlets in the exterior wall. These outlets are not secured to the block, they just dangle in the opening and are only secure (or appear to be firmly in place) due ...
11
votes
4answers
8k views

I have a 3-pronged receptacle but no ground wire connected to it. Is this ok?

I removed the plates from outlets to paint walls and noticed that some of my electric boxes have ground wires connected to outlets while others do not have a green wire at all. Is this ok? I know ...
6
votes
1answer
614 views

How do I connect the wires to this USB receptacle?

I am replacing a wall outlet with a Cooper Wiring USB outlet (TR7745). The new outlet has 3 wires coming out of it--a black, a white, and a green. Each one needs to be attached with a wire nut to ...
5
votes
5answers
6k views

What types of electrical outlets are found in a typical home in the USA?

I do not live in the USA. If I were to buy a home in the USA, what are the key facts I should know about USA household electrical supply at outlets in homes? E.g. when buying a clothes dryer or other ...
5
votes
3answers
347 views

How can I seal this hanging electrical outlet in my horse barn?

I really am not a fixer type of gal but this seems like it should be simple enough. Please respond appropriately for someone who has limited knowledge. I have a hanging outlet in my horse barn. ...
1
vote
1answer
4k views

Electrical outlet has two black hot wires but one neutral white wire?

I attempted to replace an electrical outlet that was not working. My voltage tester indicated nothing was working. A receptacle analyzer indicated nothing was working as well. but when opening it ...