0
votes
2answers
47 views

Does it matter what kind of pipe is used for a sink drain?

The drainpipe in our sink broke (corroded right through in several places). Not having the time to find my pipe wrench (much less actually replace the pipe) we called a plumber. The plumber replaced ...
1
vote
1answer
40 views

Proper way to join PVC pipes to brass ball valve

I'm using the following fitting to join PVC pipes to the brass valve, my concern is that the recommended 3-8 wraps of teflon tape and finger tight plus 1-2 turns didn't cut it. I end up using about 20 ...
1
vote
2answers
115 views

How can I avoid excessive junk on inside junction, when cementing PVC sprinkler pipe?

I'm cementing some schedule 40 PVC pipe using the best instructions I could find ( http://www.tchristy.net/pdf/ChristysTechManual_v5_English.pdf ). The outside of each joint looks fine, but inside ...
1
vote
3answers
518 views

How can I close a rectangular PVC pipe without using glue?

I will use a rectangular pipe (65mmx100mm) for growing herbs on the wall outside my house. I want to close both ends of a rectangular PVC pipe without using glue so I can pull at anytime both ends for ...
3
votes
1answer
2k views

How do I easily separate unglued PVC pipe from joints?

I've been retrofitting an existing PVC irrigation system around my house. Part of that work requires that I work in shallow holes adding T joints and elbows in places where there were none before. In ...
2
votes
2answers
236 views

Should I use a hose clamp on my furnace drainage pipe?

I have a drainage pipe coming from my furnace that a hose regularly connects to and drains to somewhere down into the floor. The hose unfortunately isn't in a great location and if people aren't being ...
5
votes
1answer
356 views

Should I use glue or o-ring joints on a buried PVC waste pipe?

What are the advantages and disadvantages of both systems of joints for "non-pressure" pipes that are buried? O-ring joints are more expensive, but easier to do on buried pipes. Glue on the other ...
3
votes
1answer
356 views

What should I keep in mind when extending downspouts?

I am considering extending/connecting the downspouts of my house to some pvc piping which I will run underground. What are things that I need to keep in mind? Specifically, I have the pvc piping but ...
2
votes
0answers
295 views

How can I find wide diameter clear tubes at a cheap price? [closed]

I am trying to build a series of tubes for my pet rat to run around the apartment in. But I need for the tubes to be at least 3'' in diameter, preferably 4'' and I need them to be clear so I can find ...
3
votes
1answer
360 views

How to add a drain pipe to a concrete block wall covered in insulation?

I want to run a 1.5" drain pipe along the wall about 2 feet from the floor to a microbrewery setup in the corner of my basement. I have sheets of fiberglass insulation against the walls though, and I ...
3
votes
2answers
2k views

How to patch this PVC elbow connection?

I bought a home about 3 months back, and recently discovered a slow leak under a wall in my utility room. I ended up removing that part of the wall to get to it, and the leak is coming from the feed ...
4
votes
1answer
7k views

Can I move my bathroom sink's drain pipe about 6 inches to the right?

I found the vanity I wanted for my bathroom, but it doesn't fit due to the position of the drain pipe. It needs to move about 6 inces to the right. I assume there is some sort of adapter or ...