The tag has no usage guidance.

learn more… | top users | synonyms

4
votes
2answers
469 views

Are off-brand framing nails compatible with my Craftsman nailer?

I have a Craftsman Clipped Head Angle Framing Nailer (28 degrees) Model No. 351.181790. They don't appear to stock the specific nails for this gun anymore. Which according to the manual are: 18351 ...
2
votes
2answers
121 views

What part is faulty when a pneumatic nail gun does not leak any air, is not jammed, but does not fire?

I have a Porter Cable DA250C (15ga angle finishing nailer). Worked fine yesterday until it just stopped. The gun does nothing at all when the trigger is depressed. It is not jammed. The piston is ...
1
vote
1answer
2k views

Can I mount a router to the Ridgid R4510 table saw?

I'd like to purchase a Ridgid R4510 table saw, but I want to make sure I can mount a router under it. Should I be concerned with whether this specific table saw is going to allow it or do pretty much ...
0
votes
1answer
224 views

Ryobi 18v. Lithium says fully charged but no energy

Recently I was using a Ryobi cordless drill to work on some drainage equipment. Unfortunately it caused a spill and a little water got on me and the drill. I did not think it was a lot of water (and I ...
1
vote
0answers
47 views

DeWalt Hammer Drill D25023 SDS Plus Rotary Hammer

The Drill does not rotate but the hammer works. Is this something a DIY'er can take apart & fix? The drill is almost new so there is very little, if any, wear on the intermal parts. The front end ...
1
vote
0answers
72 views

How can I remove the armature on my Porter Cable trim saw?

I have a Porter Cable model 314 trim saw. When using it the other day, it stalled in the cut. Ever since then, it sometimes will not turn on, but you can move the blade just a tad and will turn on. ...
1
vote
0answers
130 views

How much do I lose on Dremel power from a flex shaft

I would like to mount my Dremel 4000 so I can use it as a stationary tool, e.g. a self-made CNC. There are several pages on the web and many videos on youtube showing the Dremel fixed in a box-like ...
0
votes
0answers
22 views

Correct oil type for domestic power-washer pump

I have a low-cost domestic power-washer / power-hose with swash-plate style 3-piston pump. The pump oil level has dropped (probably due to split o-ring) and I need to top up. The oil is not specified ...
0
votes
0answers
16 views

fencing and siding coil nailers: magazine capacity and choosing compatible nails

I need a coil nailer that can take 15-degree ring-shank 1-1/2" stainless steel cedar shingle nails. I have never used a coil nailer and have some very basic questions about choosing compatible nail ...
0
votes
0answers
522 views

How could a power drill trigger switch be damaged when used continuously in variable speed range?

I just acquired a DeWalt DCD790 cordless brushless drill/driver, and going through the manual, on page 10 under Speed Trigger Switch, I find the following: NOTE: Continuous use in variable speed ...