1
vote
1answer
45 views

Is it possible to get a magnetic mount to attach to my aluminum tablesaw base?

I want to use a magnetic base and precision deflection meter with my tablesaw, which has aluminum instead of cast iron table, which means it is not a magnet-friendly material. I'm wondering if anyone ...
9
votes
3answers
409 views

Why do some table saws have a direct and a reverse ruler on the fence?

For example, in the ruler, the bottom row goes from 0 to 31 cm from left to right and the upper row goes from 32 upwards from right to left? EDIT: Here is the manual for the tablesaw pictured ...
0
votes
1answer
1k views

Can I mount a router to the Ridgid R4510 table saw?

I'd like to purchase a Ridgid R4510 table saw, but I want to make sure I can mount a router under it. Should I be concerned with whether this specific table saw is going to allow it or do pretty much ...
7
votes
2answers
5k views

Can I use an 8“ dado blade set in a 10” table saw?

I have a 10" table saw... this is probably a stupid question, but can I use an 8" dado blade set in this saw? Is one only supposed to use 10" blades in a 10-inch saw? I read on some contractor's ...