0
votes
1answer
51 views

Is plywood or dimensional lumber better for repairing notched joist?

During a recent remodel, I came across a 3 inch deep by 5 inch wide bottom notch in a 3x10 (the beams are that old!). I must say, i'm just a diy'er and even I was beside myself that someone would do ...
3
votes
3answers
885 views

Are plywood dovetails a good solution to building something that needs to be dismantled?

Are hand cut, plywood dove tails feasible? Assuming you can get "good" plywood, i.e. not the brittle splinter-fest I've seen around, is dovetailing feasible? I'd like to avoid using glue for the ...
1
vote
1answer
165 views

What thickness, size, and quality plywood is required for an aviary floor?

12'L x 5'D x8'H size aviary needs what thickness plywood to hold human weight. Aviary floor is slightly elevated from the ground. Also, please specify how many floor joists it needs to hold the weight ...
5
votes
2answers
1k views

How can I plane the edges of plywood?

I'm working on an 8ft x 12ft climbing wall. I have 3/4 inch ACX plywood attached to a frame. Since the frame isn't perfectly square, the plywood overlaps on the edges (up to about 1cm) so I need to ...
5
votes
2answers
2k views

Should I choose MDF or plywood for my false stair treads?

I'm looking to install false stair treads and risers on my basement stairs. Generally, we're talking about a kit like this: Which is installed with adhesive and finishing nails like this: The ...
9
votes
2answers
8k views

Can you rout plywood?

I have some applewood 13 ply 3/4" plywood that I'm using for a desk top. I was wondering if I took a router to the edges if it would turnout ok.
4
votes
4answers
2k views

Is there a way to remove the warp in plywood?

I just bought some 1/2" plywood from HD for a project, and the best piece I could find was still pretty warped. Is there a way to fix this? Currently, it's sitting flat on my garage floor with a sheet ...