1
vote
2answers
125 views

Paint a rusty hinge without sanding?

If I use primer on a rusty hinge, can I paint it and get away without sanding it first? Photo:
0
votes
0answers
17 views

What size Airless sprayer tip should we use with Shellac Primer

We will be spraying BIN shellac primer onto nicotine-stained cabinets. What is the proper size tip to use with this product when applying with a Titan 440 airless sprayer?
0
votes
2answers
66 views

Is the Zinsser BIN Shellac primer sandable?

We are preparing to prime kitchen cabinets that had past nicotine stains, and want to completely block any future bleed-through of those stains. We hesitate using the Shellac because we aren't sure ...
0
votes
2answers
44 views

Should I use oil primer underneath oil paint?

Is it necessary to use oil primer underneath oil paint (for trim) or can I use latex primer? Do all primers work interchangeably with oil and latex paints?
0
votes
1answer
23 views

Do I need to sand oil-based lacquer before painting?

Getting ready to paint fireplace surround, which currently has oil-based lacquer that turned yellow. Do I need to sand it before applying latex paint, or can I use a brand name cleaning product to ...
0
votes
1answer
65 views

How do I paint a metal sheet fence with a spray gun?

I am looking at painting a metal sheet fence with a spray gun. How do I calculate the amount of paint needed? What are the preparations that I need before painting, should I use a primer, do I need ...
3
votes
3answers
115 views

Dealing with nicotine stains in a Victorian property

I am just in the process of buying an old property, previously lived in by heavy smokers. What is the best way to clean and prime walls to prevent nicotine stain recurrence in a solid brick Victorian ...
1
vote
3answers
129 views

How do I choose paint for exterior steel on carport?

Planning on painting the steel purlins of a carport, that is peeling. I assume the primer and old paint are "oil based" alkyd. I think we will have it sandblasted. What primer should I use on the ...
3
votes
1answer
512 views

Should I sand baseboard before painting it?

I am replacing some baseboards in my house. It is the most basic type: flat board 5-1/2" wide by 3/4" thick. I would prefer to buy primed board, but my local shops do not sell it for some reason (they ...
2
votes
1answer
59 views

What type of primer is required for pine?

I bought a gallon of Zinsser, low-odor, stain-and-odor-blocking, oil-based, primer. We bought it primarily for the subfloor we found after tearing out the carpet and seeing some various pet stains. ...
3
votes
3answers
4k views

Do I have to prime over spackle?

I'm painting my kitchen. Some areas of the walls had to be repaired with spackle. Do I need to do a prime coat before I paint? I'm painting the same color. Although I'm changing the finish from ...
3
votes
1answer
337 views

How can I prevent color variants when painting over wall putty? [duplicate]

I have used putty on the wall to fix the holes, and fill some gaps. the putty color is white while the rest of the wall is an older light green, I am painting a very dark yellow, However when painting ...
2
votes
1answer
223 views

Can I use a spray sealer and primer over a patched drywall followed by painting over it?

I have patched one of my wall from a few holes(5) where each is about a finger big. Since it is not a big surface area, can I use a spray stain sealer and primer, and then apply paint over the entire ...
6
votes
1answer
2k views

Do I need to prime/seal new drywall behind cabinets?

If I were doing it, I would usually prime and paint before installing the cabinets. My painter for this project says he'd prefer that I install everything before he paints. Do I need to use a sealing ...
7
votes
1answer
344 views

Do primer + paint products work well?

Are primer + paint products as effective as using separate primer and paint
2
votes
1answer
444 views

What is best way to thoroughly clean airless sprayer after using shellac primer

We will be using a shellac-based primer on our interior walls, using an airless sprayer. I know it needs to be cleaned thoroughly with denatured alcohol. I read somewhere that I should run an ...
6
votes
1answer
582 views

Drywall Painting: Do I need to keep priming here?

I am painting a room where the previous paint job was not very good. You can see brush marks from a great distance, it got all over the trim, and the paint looked watered down (thanks builders). It ...
11
votes
1answer
10k views

How should I clean and repaint a painted wooden deck?

My deck appears to have been painted with just a single layer of paint, which is now peeling off. I like the look of the paint (when it's in better condition, of course), and am uninterested in ...
3
votes
1answer
188 views

How can I stop primer from eating my roller handles?

Whenever I use primer, it seems like I get about one room's worth of coverage before the roller handle seizes up, so that I'm pushing the roller along the wall instead of rolling it. I'm ...