I'm going to have some mild steel tubes with holes drilled on it hot-dipped galvanized. I need to know how much tolerance or how big the holes should be when I drill them so that they would be at ...
I plan on building a power rack for my home gym and was wondering what kind of metal/coating I should use when building it since it will be stored outdoors. Most commercial power racks are built using ...
I've once seen it on TV: in industrial wire production they use a set of castors that bends the wire back and forth, up and down – always a bit less, until its straight. Is there something similar for ...
I recently replaced an over-the-range microwave with a hood. Since the hood is about half the height of the microwave, this left a ~15" gap between the preexisting tile backsplash and the start of ...