The tag has no usage guidance.

learn more… | top users | synonyms

6
votes
1answer
47k views

How do I determine if a wall is load bearing?

I'm considering removing a wall in my master bathroom but I can't tell if it is a load bearing wall or not. I've done a fair amount of research. I don't have the house blueprints, and it's difficult ...
6
votes
1answer
4k views

Can I safely make a door frame taller?

UPDATE: April 22 What I ended up doing was removing the trim non-destructively. Above the door frame, it was clearly not load bearing, so I continued and was not so non-destructive. The end-result ...
5
votes
1answer
1k views

What should I do to level an uneven floor with a potential load bearing wall above?

I'm trying to level the first floor in my 90 year old house. The floor joists are held up by a wooden beam composed of 5 2x8s, which is held up by two steel columns. In the middle of the wooden ...
0
votes
2answers
942 views

What size lumber do I need for a mezzanine floor to support a 20,000 lbs load?

I am thinking of putting a mezzanine in my garage to support 20,000 lbs of load, not including the weight of the floor. On the floor the area is 20' deep X 32' wide; I was looking at 4" X 12" ...
1
vote
2answers
3k views

Can my floor support Kitchen Island?

I am installing a 5' x 3' kitchen island consisting of two base cabinets. Once I've installed the two base cabinets, SilestoneUSA will install a quartz counter top. My plan is to screw two ...
6
votes
2answers
3k views

How much temporary bracing do you need when cutting a new exterior door opening in an existing house?

I'd like to add a door to the back side of my garage, but since this is a load bearing wall I'll have to brace it temporarily while I frame the opening. The garage has one room above it, which spans ...
5
votes
2answers
2k views

I removed this non-load bearing wall in the corner of my basement, now 2 doors upstairs rub on their frames. Why is this?

In the image below, notice where the small 1x1 bits are, running perpendicular to the ceiling joists. These was used by the previous homeowner to lower the ceiling in one room, so if you can imagine, ...
3
votes
1answer
13k views

Can I build a pergola on an existing deck, without digging more footers?

A couple of years ago I built a deck onto my house. It is 32' x 14' I used a cantilever design at 12' with 2x8" floor joists, with 2x6" decking boards. The Cantilever beam was set on 6x6" posts that ...
9
votes
1answer
423 views

Can I modify a load bearing triple stud?

I am installing a small safe in a wall and when I cut the opening in the drywall I noticed that the studs were in an unusual distribution. The stud on the right was normal but then there were multiple ...
2
votes
1answer
387 views

Installing a swing set between two brick walls?

My neighbors and I are considering putting up a swing set in the alleyway between our houses. The space is about 10' wide, and the house walls on both sides are brick (about 4" thick). Which of the ...
3
votes
2answers
1k views

How should I install a hoist given that the walls and ceiling are made of concrete?

I have this hoist, of the engine-lifting variety, which is designed to be installed below a pipe or beam. I do not have any load bearing pipes or beams. What I have are a poured concrete ceiling (9" ...
29
votes
4answers
8k views

Are there ways to determine if a wall is load bearing?

Other than looking up blue prints, which many homeowners may not have, are there ways to determine if a wall is load bearing? Methods I can think of might include: Going up in the attic to check if ...