4
votes
1answer
178 views

Proper size of header to support new door in load bearing wall?

We're going to install a new linen closet off the hallway next to our recently(ish) remodeled bathroom. The wall in question is load bearing. I know how to properly build out the King and Jack ...
0
votes
2answers
105 views

Wall load bearing or not?

We want to remove a wall in our kitchen, We ripped out the drywall on one side. Is there a way to tell if it's load bearing or not? The house was built in 2005, we have been told newer houses do not ...
2
votes
1answer
155 views

Is this a load-bearing wall between my house's entrance and dining room?

I have recently bought a home in which there is a wall at right at the entrance of the foyer. Is there any way to tell if it is a load-bearing wall? I just want to get rid of it.
3
votes
1answer
319 views

Can you tell from this frame if it is a nonbearing wall?

Just removed the drywall and need help to confirm if it's a non-bearing wall. It's a 1900 duplex house and there is a similar wall on the first floor but it is not aligned, about 10" distance. ...
4
votes
1answer
343 views

How many jack poles should I use when opening a doorway through a load bearing wall?

I'm opening a 6-foot wide opening in a 19-foot section of load bearing wall between two rooms on the main level of two-level-with-basement home. I'll be installing a built-up 4x10 header (using (2) ...
5
votes
1answer
595 views

What should I do to level an uneven floor with a potential load bearing wall above?

I'm trying to level the first floor in my 90 year old house. The floor joists are held up by a wooden beam composed of 5 2x8s, which is held up by two steel columns. In the middle of the wooden ...
5
votes
2answers
945 views

I removed this non-load bearing wall in the corner of my basement, now 2 doors upstairs rub on their frames. Why is this?

In the image below, notice where the small 1x1 bits are, running perpendicular to the ceiling joists. These was used by the previous homeowner to lower the ceiling in one room, so if you can imagine, ...
2
votes
1answer
301 views

Installing a swing set between two brick walls?

My neighbors and I are considering putting up a swing set in the alleyway between our houses. The space is about 10' wide, and the house walls on both sides are brick (about 4" thick). Which of the ...
21
votes
4answers
3k views

Are there ways to determine if a wall is load bearing?

Other than looking up blue prints, which many homeowners may not have, are there ways to determine if a wall is load bearing? Methods I can think of might include: Going up in the attic to check if ...