I have two LED lamps in my corridor, and when I switch them off, they keep emitting light (not very strong, but it's annoying at night). What can it be? How can I fix it?
I've been looking to install LED strips, either RGB or white for lighting and ambiance. It wouldn't be the main lighting of the room, so no necessity for high power LEDs. The perimeter of the room is ...
I've just purchased some 12V LED MR-16 bulbs, intending to use them to replace the existing 12V Halogen MR-16 bulbs in my bathroom. I have found, much to my chagrin, that the LED bulbs seem to have ...
Okay you guys I have next question. And like all good questions this one begins with a story. I was reading the post about a nick in a wire and read a couple of you mention that light switch in a ...
I asked Reliance Controls about a THP103 meter that I was having trouble with. Turns out that its not a true RMS meter and thus is unable to give you accurate readings on a CFL or LED installation. ...
I bought a bunch of these motion sensor switches. I also want to use these dimmable LED bulbs. The motion sensors do not have a neutral wire connector. My outlets only have a live wire and it would ...
In a block of units we installed 240v EARTHED downlights. I believe the neutral maybe 2-3volts above earth causing the lights to flash when turned off. The fittings are provided with earth connection ...
So I've been doing a lot of research recently regarding LED lighting, and attempting to do an overhaul of our entire house. But I've run into a few issues, and I really don't want to go back and forth ...