The tag has no usage guidance, but it has a tag wiki.

learn more… | top users | synonyms

11
votes
3answers
100k views

Why do my LED lights stay on, even when the switch is off?

I have two LED lamps in my corridor, and when I switch them off, they keep emitting light (not very strong, but it's annoying at night). What can it be? How can I fix it?
18
votes
1answer
67k views

What do I need to install LED strip lighting?

I've been looking to install LED strips, either RGB or white for lighting and ambiance. It wouldn't be the main lighting of the room, so no necessity for high power LEDs. The perimeter of the room is ...
1
vote
3answers
21k views

How can I prevent these LEDs from blinking when turned off?

In a block of units we installed 240v EARTHED downlights. I believe the neutral maybe 2-3volts above earth causing the lights to flash when turned off. The fittings are provided with earth connection ...
2
votes
2answers
357 views

How can I make a bluish “white” LED less blue?

I recently bought this white LED reading lamp. I like it a lot, but the "white" light produced is significantly blue; I'll guess its color temperature is about 5000K. I've noticed that, when this is ...
1
vote
1answer
8k views

Can dimmable (triac) LED bulbs be used on a motion sensor switch without neutral wire?

I bought a bunch of these motion sensor switches. I also want to use these dimmable LED bulbs. The motion sensors do not have a neutral wire connector. My outlets only have a live wire and it would ...
4
votes
1answer
1k views

Replacing Halogen with LED bulbs

I've just purchased some 12V LED MR-16 bulbs, intending to use them to replace the existing 12V Halogen MR-16 bulbs in my bathroom. I have found, much to my chagrin, that the LED bulbs seem to have ...
5
votes
2answers
6k views

Can a low voltage light switch be located in a closet as opposed to outside the closet?

Okay you guys I have next question. And like all good questions this one begins with a story. I was reading the post about a nick in a wire and read a couple of you mention that light switch in a ...
4
votes
7answers
9k views

Will switching to LED lightbulbs make a significant difference in my electric bill?

I asked Reliance Controls about a THP103 meter that I was having trouble with. Turns out that it's not a true RMS meter and thus is unable to give you accurate readings on a CFL or LED installation. ...
1
vote
2answers
9k views

Can I connect all of my LED strips to a single power supply?

Im working on a project with LED light strips, and want to connect them all to a sd controller. The lights are ws2812b 60 LED/meter, and have 20 meters of it. It calls for 14.4w per meter @ 3 amps per ...
3
votes
3answers
1k views

Replacing G4 halogen bulbs with LEDs

We've got 12V halogen G4 fixtures mounted under our kitchen cabinets and would like to use LED's instead. I found some G4 LED bulbs on Amazon, and they fit in the fixtures just fine, but if I try to ...
2
votes
1answer
333 views

Is there such a thing as an actual 60W draw LED or CFL bulb?

CFL and LED lightbulbs are sold as being "40/60/100 watt equivalent". They're designed and sold as replacements for a certain wattage of incandescent lamp. I have some fixtures where I want a very ...
1
vote
2answers
65 views

How to attach 10 AWG wire to LED strip lights?

I'm running LED light strips from a location that is over 50 feet from the LED transformer. In order to account for voltage drop 10 AWG CL2 wire has been used. Questions Since the 10 AWG wire is ...
0
votes
1answer
620 views

Upgrading to LED Bulbs

So I've been doing a lot of research recently regarding LED lighting, and attempting to do an overhaul of our entire house. But I've run into a few issues, and I really don't want to go back and forth ...